2001 SUZUKI GRAND VITARA width

9-2 BODY SERVICE
Glass, Windows and Mirror
Quarter Window
REMOVAL AND INSTALLATION
Refer to “WINDSHIELD” in this section as removal and installa-
tion procedures are basically the same. However, note the follow-
ings.
•Before applying primer to glass edge, install molding accord-
ing to installing position shown in the figure.
•Observe the following precautions when applying adhesive
along glass edge.
–Adhesive should be applied evenly especially in height.
–Be careful not to damage primer.
–Press glass against body quickly after adhesive is applied.
Adhesive amount specification (quarter window)
Height “a” : 12 mm (0.47 in.)
Width “b” : 8 mm (0.31 in.)
Width “c” : 16 mm (0.63 in.) for glass front, rear and upper
section.
Width “c” : 14 mm (0.55 in.) for glass bottom section.
Position “d” : 177 mm (6.97 in.) for left side glass front
section.
Position “d” : 75 mm (2.95 in.) for right side glass front
section.
Position “d” : 29 mm (1.15 in.) for glass rear section.
Position “d” : 39 mm (1.54 in.) for glass upper section.
Position “d” : 22 mm (0.87 in.) for glass bottom section.
1. Spacer 4. Adhesive
2. Glass 5. Primer
3. Molding 6. Ceramic print
“c” “A”
“a”
“b”“d”
6
5
4

9-14 BODY SERVICE
“A” : Apply sealant
“B” : Sealant width (more than 5 mm (0.20 in.) between “a” and “b”)
“C” : Wipe off sealant in this section
“D” : Be free from protrude of sealant outside from this line
“E” : Smooth out sealant with a brush
“A”“C”
VIEW:DD
VIEW:FF
VIEW:BBVIEW:CC
VIEW:EE
GG – GG
AA – AA
“D”
“D”
“B”“A”
“B” “a”“b”
“E”
“A”
“b”
“C”
“E”
“A”
“A”
“C”
DDFF
CC BB
EE
AA
AA GG
GG
15-20 mm
(0.59-0.79 in.)
“B”
“A” “B”
“A”

BODY SERVICE 9-15
“A” : Apply sealant“C” : Wipe off sealant in this section
“B” : Smooth out sealant with a brush“D” : Sealant width (more than 5 mm (0.20 in.) between “a” and “b”)
“C”
“B”
“A”
“b”
“b”
“a”
“A”
“A”
“A”
“a”
“A”
“A”
“B” “A”
“C”
“D”
“D”
JJ
KKLL
“A”
“A”
“A”
PP PP
MM
NNNN
MM
HH
HH
“B”“B”
OO OO
PP – PP
OO – OO
NN – NNMM – MM
HH – HH
VIEW:KK
VIEW:LLVIEW:JJ

9-16 BODY SERVICE
“A” : Apply sealant
“B” : Smooth out sealant with a brush
“C” : Sealant width C more than 5 mm (0.20 in.)
KK
KK“A”
“A”“B”“B”
LL LL
“C”
LL – LL
KK – KK