2001 SUBARU OUTBACK airbag

Seat, seatbelt and SRS airbags1-35
–
CONTINUED –
Safety Stand ard s or Canad a Motor Vehic le Safety Sta
nd ard s, is c omp at-
ib le with your vehic le and is ap p rop riate for the c hild’s ag e and size. All
c hild restraint systems are d esig ned to b e sec ured in vehic le seats b y
lap b elts or the lap b elt p ortion of a lap /should er b elt (exc ep t those c ov-
ered und er the sec tion in this manual, entitled “Instruc tion of c hild re-
straint systems b y use of lower and tether anc horag es”).
Child ren c ould b e end ang ered in an ac c id ent if thei r c hild restraints are
not p rop erly sec ured in the vehic le. When installin g the c hild restraint
system, c arefully follow the manufac turer ’s instruc tions.
Ac c ord ing to ac c id ent statistic s, c hild ren are safe r when p rop erly re-
strained in the rear seating p ositions than in the front seating p ositions.
All U.S. states and Canad ian p rovinc es req uire that infants and small
c hild ren b e restrained in an ap p roved c hild restrai nt system at all times
while the vehic le is moving .
Installing child restraint systems with seatbelt
NOTE When the child restraint system is no longer in use, remove it and
restore the ELR function of the retractor. That function is restored
by allowing the seatbelt to retract fully.
CAUTION
When you install a child restraint system, follow the manufactur-
er’ s instructions supplied with it. After installing the child re-
straint system, check to ensure that it is held securely in posi-
tion. If it is not held tight and secure, the danger of your childsuffering personal injury in the event of an accident may be in-creased.

Seat, seatbelt and SRS airbags1-37
–
CONTINUED –
HB1083BAHBS065BA
8. To remove the c hild restraint system, p ress the r elease b utton on
the seatb elt b uc kle and allow the b elt to retrac t c omp letely. The b elt
will return to the ELR mod e.
If you have any q uestion c onc erning this typ e of c h ild restraint sys-
tem, ask your SUBARU d ealer. Installation of child restraint systems by use of lower and teth- er anchorages
Some typ es of c hild restraint systems c an b e instal led on the rear
seat of your vehic le without use of the seatb elts. Suc h c hild restraint
systems are sec ured to the d ed ic ated anc horag es p ro vid ed on the
vehic le b od y.
HB1086BA
Your vehic le is eq uip p ed with four lower anc horag es (b ars) and three
up p er anc horag es (tether anc horag es) for ac c ommod at ing suc h c hild
restraint systems.

Seat, seatbelt and SRS airbags1-39
–
CONTINUED –
CAUTION
When you install a child restraint system, follow the manufactur-
er’ s instructions supplied with it. After installing the child re-
straint system, check to ensure that it is held securely in posi-
tion. If it is not held tight and secure, the danger of your childsuffering personal injury in the event of an accident may be in-creased.
1. Use the “Child ” marks to loc ate the two lower anc horag es (b ars)
for the p osition where you want to install the c hil d restraint system.
NOTE On a vehicle with a built-in child restraint, if you are required to use a child restraint system and the built-in child restraint at the
same time, it is recommended that you install the child restraint
system on the rear left side (behind the driver ’s seat). The built-in
child restraint is located toward the right side. For this reason,certain child restraint systems will be tilted if installed on theright side and they cannot be properly secured.
2. While following the instruc tions sup p lied b y the c hild restraint sys-
tem manufac turer, c onnec t the c onnec tors of the c hi ld restraint sys-
tem to the lower anc horag es.
When the c onnec tors are fastened , make sure that th e ad jac ent seat-
b elts are not c aug ht.
If your c hild restraint system is of a flexib le att ac hment typ e (whic h
uses tether strap s to c onnec t the c hild restraint s ystem p rop er to the
lower anc horag es), firmly tig hten the strap s after c onnec ting the c on-
nec tors.
3. Connec t the top tether hook to the tether anc hora g e and firmly
tig hten the tether.
For information on how to set the top tether, read the following “To p
tether anc horag es ”.
4. Before seating a c hild in the c hild restraint sys tem, try to move seat
b ac k and forth to verify that it is held sec urely i n p osition.
If you have any q uestion c onc erning this typ e of c h ild restraint sys-
tem, ask your SUBARU d ealer.

Seat, seatbelt and SRS airbags1-41
–
CONTINUED –

To hook the top tether
n Sedan CAUTION
When the child restraint system is to be secured using the top
tether, always pass the top tether under the headrest between theheadrest stay posts. If the top tether is routed over the headrest,it may not be properly tensioned, resulting in an unsteady childrestraint system.
HBS064BB
HBS063BA
1. Remove the head rest at the seating p osition where the c hild seat
has b een installed with the seatb elt or lower anc ho rag es; lift up the
head rest while p ressing the release b utton.
2. Fasten the top tether hook of the c hild safety to the ap p rop riate up -
p er anc horag e.

Seat, seatbelt and SRS airbags1-43
–
CONTINUED –
ton. Store the head rest in the c arg o area. Avoid p l
ac ing the head rest
in the p asseng er c omp artment to p revent it from b ei ng thrown around
in the p asseng er c omp artment in a sud d en stop or a sharp turn.
2. Fasten the top tether hook of the c hild restraint system to the ap -
p rop riate up p er anc horag e.
3. Tig hten the top tether sec urely.
Built-in child restraint (if equipped)
Refer to the d iag ram b elow to b ec ome familiar with the p arts of this b uilt-
in c hild restraint.
1 Lap -should er b elt
2 Chest c lip
3 Release b utton
4 Crotc h b elt
5 Warning lab el
6 Fastening strap 7
Child restraint c ushion
8 Belt b uc kle
9 Tong ue p lates
Q Maximum should er heig ht
ind ic ator lab el
W Removab le p ad HBS067BB

Seat, seatbelt and SRS airbags1-45
–
CONTINUED –

Snugly adjust the belts provided with this child restraint
around your child. The built-in child restraint should be used for only one child at
a time. Using it for two or more children at the same time couldresult in serious injury or death in an accident. Do not use the center lap and shoulder belt with the child re-
straint. A child using the center seatbelt could slide forward andout from under the seatbelt in a sudden stop or an accident, re-sulting in serious injury to the child.
HBS047BA
WARNING
Do not use another child restraint system over the opened
built-in child restraint. Because a child restraint system cannot be secured on the built-in restraint cushion, the restraint could
fall down during sudden braking, a sharp turn or in an accident,
causing serious injury to the child in it. Always keep the child restraint equipped rear seatback locked
securely in place when the child restraint is in use. Otherwise, inan accident, serious injury or death to a child could result if the
seatback falls down. The built-in child restraint, especially metallic parts, can be-
come hot in a vehicle that has been closed up in sunny weather;they could burn a small child. Check the child restraint beforeyou place a child in it.

Seat, seatbelt and SRS airbags1-47
–
CONTINUED –
HBS049BA
4. If the left and rig ht halves of the c hest c lip ar e fastened tog ether,
sep arate them b y sq ueezing the release tab s.
HBS051BB
HBS050BA
5. Pull d own the seatb ac k p art of the removab le p ad . Make sure the
c hild ’s should ers are at or b elow the maximum should er he ig ht ind i-
c ated on the lab el attac hed to the seatb ac k.
The c hild restraint p ad is attac hed b y hook and loo p fasteners
(Velc ro ).
WARNING
If the child ’s shoulders are above the maximum shoulder height
indicated on the label, do not use the built-in child restraint. If
used, the built-in restraint cannot restrain the child properly,which may result in serious injury to the child in an accident.

Seat, seatbelt and SRS airbags1-49
–
CONTINUED –
8. Pull out one sid e of the lap -should er b elt and p l
ac e it over the
c hild ’s should er. Insert the tong ue p late into the b uc kle until it c lic ks.
If b oth sid es of the b elt are p ulled out, the b elts will loc k. If the b elts
loc k, allow them to fully retrac t to unloc k the ret rac tor. Then p ull out
only one sid e of the b elt.
9. Pull out the other sid e of lap -should er b elt and p lac e it over the
c hild ’s should er in a sing le motion. Insert the tong ue p l ate into the
b uc kle until it c lic ks. Onc e the b elt retrac ts even slig htly, the ALR will
b e ac tivated and b oth b elts will loc k.
If the b elt stop s b efore the tong ue reac hes the b uc kle, allow b oth
b elts to fully retrac t to unloc k the retrac tor and then sep arately p ull out
the b elts and b uc kle them ag ain.
10. Allow b oth b elts to tig hten snug ly ag ainst the c hild’s should ers.
Bec ause of the ALR func tion, the b elts c annot b e p u lled out simulta-
neously from the retrac tor.
The c olor g reen must ap p ear in the ind ic ator wind ow on eac h tong ue
when b uc kled . If the c olor red ap p ears in the wind o w, the tong ue is
not b uc kled .
WARNING
After inserting the tongue plates, make sure the tongue plates and buckle are locked and that the lap-shoulder belts and crotch
belt are not twisted. If the restraint is used with the tongues and
buckle not locked and/or with the belts twisted, the risk or severi-ty of injury to the child could increase in an accident.
CAUTION
If the child restraint belts do not function normally, contact your
authorized SUBARU dealer immediately.