2001 SUBARU OUTBACK ignition

4-14NOTE
You can check the outside air temperature even when the Au-
tomatic Climate Control is off. (The ignition switch should be in the “ON” position.)
In the following cases, the display can indicate a higher tem-
perature than the actual outside air temperature: – In direct sunlight
– When the vehicle is parked for a long period of time with the
engine kept running.– During stop and go driving
n
— Defroster switch
To d efrost or d ehumid ify the wind shield and sid e wi nd ow, p ush the
d efroster switc h “
”. When the “” switc h is p ushed , re-
g ard less whether the air c ond itioner is op erating o r not, outsid e air is
d rawn into the p asseng er c omp artment, the air c ond i tioner c omp res-
sor turns on, air flow is d irec ted toward s the wind shield and sid e win-
d ows, and the ind ic ator lig ht “
” on the c ontrol p anel c omes on.
After eliminating the fog g ing from the wind shield , set the air c ond ition-
er b ac k in the AUTO mod e b y p ushing the “AUTO ” switc h or turn off
b y p ushing the “OFF ” switc h or “
” switc h.
n
— Fan speed control switch
HB5021BB
The fan sp eed c ontrol switc h has the 5 p ositions: A UTO p osition and
4 d ifferent fan sp eed p ositions.

Climate control4-17
–
CONTINUED –
n
Temperature control dial
HB5023BB
NOTE A setting of about 77 F (25 C) throughout the year is recom-
mended. The temperature setting remains even after the ignition switch
is turned to the “OFF”. However, if the battery cables are discon-
nected, the temperature will be set to 77 F (25 C) automatically.
Set d esired temp erature b y turning the temp erature c ontrol d ial; turn
the d ial c loc kwise to raise the temp erature setting and turn it c ounter-
c loc kwise to lower it.
The temp erature c an b e set in inc rements of 1 F within a rang e of 65
– 85 F for US mod els and in inc rements of 0.5 C within a rang e of 18
– 32 C for Canad ian mod els.
Even when q uic k c ooling or warming is nec essary, yo u d o not have to
c hang e the temp erature setting . The Automatic Clima te Control sys-
tem op erates at maximum p erformanc e until the air i n the p asseng er
c omp artment reac hes to the sp ec ified temp erature.

7-10If the eng ine d oes not start within ten sec ond s, wa
it a while and then turn
the ig nition switc h to the “START ” p osition ag ain while d ep ressing the ac -
c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one out after the
eng ine has started . The fuel injec tion system autom atic ally lowers the
id le sp eed as the eng ine warms up .
While the eng ine is warming up , make sure that the selec tor lever is at
the “P ” or “N ” p osition and that the p arking b rake is ap p lied .
Starting the engine during cold weather below –4F
(–20 C)
If the eng ine is d iffic ult to start using the norma l method (without d e-
p ressing the ac c elerator p ed al), turn the ig nition switc h to the “START ”
p osition while slig htly d ep ressing the ac c elerator p ed al.
Starting a flooded engine
If the eng ine d oes not start, it may b e flood ed (ex c essive fuel in the en-
g ine).
In c ase of a flood ed eng ine, turn the starter motor for five sec ond s with
the ac c elerator p ed al fully d ep ressed . Rep eat this two or three times until
the eng ine starts. Release the ig nition switc h and ac c elerator p ed al as
soon as the eng ine starts.
Stopping the engine
WARNING
Do not stop the engine when the vehicle is moving. This will
cause loss of power to the power steering and the brake booster, making steering and braking more difficult. It could also result in
accidental activation of the “LOCK” position on the ignition
switch, causing the steering wheel to lock.
The ig nition switc h should b e turned off only when the eng ine is id ling .

7-24started . This is c aused b y an automatic func tional
test of the ABS sys-
tem b eing c arried out and d oes not ind ic ate any ab n ormal c ond ition.
ABS warning light
HB4010GA
The ABS warning lig ht c omes on when the ig nition sw itc h is turned to
the “ON ” p osition and g oes out after ab out two sec ond s.
This is an ind ic ation that the ABS system is workin g p rop erly.
CAUTION
If the warning light behaves as follows, the ABS system may not
be working properly.When the warning light is on, the ABS function shuts down; how-
ever, the conventional brake system continues to operate normal-
ly. The warning light does not come on when the ignition switch
is turned to the “ON” position.
The warning light comes on when the ignition switch is turned
to the “ON” position, but it does not go out even when the vehicle
speed exceeds approximately 8 mph (12 km/h). The warning light comes on during driving.
If these occur, have the ABS system repaired at the first available
opportunity by your SUBARU dealer.

In case of emergency9-23
–
CONTINUED –

Using a flat-bed truck
HB8008AA
This is the b est way to transp ort your vehic le. Use the following p roc e-
d ures to ensure safe transp ortation.
1. Shift the selec tor lever into the “P ” p osition for automatic transmis-
sion vehic les or “1st ” for manual transmission vehic les.
2. Pull up the p arking b rake lever firmly.
3. Sec ure the vehic le onto the c arrier p rop erly with safety c hains.
Eac h safety c hain should b e eq ually tig htened and c are must b e tak-
en not to p ull the c hains so tig htly that the susp e nsion b ottoms out.
Towing with all wheels on the ground
WARNING
Never turn the ignition switch to the “LOCK” position while the
vehicle is being towed because the steering wheel and the direc- tion of the wheels will be locked. Remember that the brake booster and power steering do not
function when the engine is not running. Because the engine isturned off, it will take greater effort to operate the brake pedal andsteering wheel.

11-4
Always use the proper tools and make certain that they are
well maintained. Never get under the vehicle supported only by a jack. Always
use a safety stands to support the vehicle. Never keep the engine running in a poorly ventilated area,
such as a garage or other closed areas. Do not smoke or allow open flames around the fuel or battery.
This will cause a fire. Because the fuel system is under pressure, replacement of the
fuel filter should be performed only by your SUBARU dealer. Wear adequate eye protection to guard against getting oil or
fluids in your eyes. If something does get in your eyes, thorough-
ly wash it out with clean water. Do not tamper with the wiring of the SRS airbag system or
seatbelt pretensioner system, or attempt to take its connectorsapart, as that may activate the system or it can render it inopera-tive. The wiring and connectors of these systems are yellow for
easy identification. NEVER use a circuit tester for these wiring. If your SRS airbag or seatbelt pretensioner needs service, con-
sult your nearest SUBARU dealer. Before checking or servicing in the engine compart- ment
Always stop the engine and set the parking brake firmly to pre-
vent the vehicle from moving. Always let the engine cool down. Engine parts become very
hot when the engine is running and remain hot for some time af-ter the engine is stopped. Do not spill engine oil, engine coolant, brake fluid or any other
fluid on hot engine components. This may cause a fire. Always remove the key from the ignition switch. When the
ignition switch is in the “ON” position, the cooling fan may oper-
ate suddenly even when the engine is stopped.