2001 SUBARU LEGACY fuel filter

11-4
Always use the proper tools and make certain that they are
well maintained. Never get under the vehicle supported only by a jack. Always
use a safety stands to support the vehicle. Never keep the engine running in a poorly ventilated area,
such as a garage or other closed areas. Do not smoke or allow open flames around the fuel or battery.
This will cause a fire. Because the fuel system is under pressure, replacement of the
fuel filter should be performed only by your SUBARU dealer. Wear adequate eye protection to guard against getting oil or
fluids in your eyes. If something does get in your eyes, thorough-
ly wash it out with clean water. Do not tamper with the wiring of the SRS airbag system or
seatbelt pretensioner system, or attempt to take its connectorsapart, as that may activate the system or it can render it inopera-tive. The wiring and connectors of these systems are yellow for
easy identification. NEVER use a circuit tester for these wiring. If your SRS airbag or seatbelt pretensioner needs service, con-
sult your nearest SUBARU dealer. Before checking or servicing in the engine compart- ment
Always stop the engine and set the parking brake firmly to pre-
vent the vehicle from moving. Always let the engine cool down. Engine parts become very
hot when the engine is running and remain hot for some time af-ter the engine is stopped. Do not spill engine oil, engine coolant, brake fluid or any other
fluid on hot engine components. This may cause a fire. Always remove the key from the ignition switch. When the
ignition switch is in the “ON” position, the cooling fan may oper-
ate suddenly even when the engine is stopped.

Maintenance and service11-7
–
CONTINUED –
Engine compartment overview
2.5 liter models
HBB036BB
1 Manual transmission oil level
g aug e (MT) (p ag e 11-23) or
Differential g ear oil level g aug e
(AT) (p ag e 11-26)
2 Air c leaner element
(p ag e 11-18)
3 Clutc h fluid reservoir
(p ag e 11-32)
4 Automatic transmission fluid
level g aug e (p ag e 11-24)
5 Brake fluid reservoir
(p ag e 11-30)
6 Fuel filter 7
Wind shield washer tank
(p ag e 11-42)
8 Fuse b ox (p ag e 11-46)
9 Battery (p ag e 11-45)
Q Eng ine oil filler c ap
(p ag e 11-9)
W Eng ine c oolant reservoir
(p ag e 11-15)
E Rad iator c ap (p ag e 11-15)
R Eng ine oil level g aug e
(p ag e 11-9)
T Power steering fluid reservoir
(p ag e 11-29)

11-8
3.0 liter models
HBB058BB
1 Air c leaner element
(p ag e 11-18)
2 Differential g ear oil level g aug e
(AT) (p ag e 11-26)
3 Automatic transmission fluid
level g aug e (p ag e 11-24)
4 Brake fluid reservoir
(p ag e 11-30)
5 Fuel filter
6 Wind shield washer tank
(p ag e 11-42) 7
Fuse b ox (p ag e 11-46)
8 Battery (p ag e 11-45)
9 Eng ine c oolant reservoir
(p ag e 11-15)
Q Eng ine oil filler c ap
(p ag e 11-9)
W Eng ine oil level g aug e
(p ag e 11-9)
E Rad iator c ap (p ag e 11-15)
R Power steering fluid reservoir
(p ag e 11-29)

11-1212. Reinstall the c over und er the oil filter.
13. Pour the sp ec ified amount of eng ine oil throug h
the filler nec k.
Oil c ap ac ity: 2.5 liter mod els: 4.2 US q t (4.0 liters, 3.5 Imp q t )
3.0 liter mod els: 6.0 US q t (5.7 liters, 5.0 Imp q t )
14. Start the eng ine and make sure that no oil leak s ap p ear around
the filter ’s rub b er seal.
15. Run the eng ine until it reac hes the normal op er ating temp erature.
Then stop the eng ine and wait a few minutes to allo w the oil d rain
b ac k. Chec k the oil level ag ain and if nec essary, a d d more eng ine oil.
Recommended grade and viscosity CAUTION
Use only engine oil with the recommended grade and viscosity.
Oil grade: API classification SJ or SH with the words “ENERGY
CONSERVING II ” (if you cannot obtain the oil with SJ
or SH grade, you may use SG grade oil.) or the new API certification mark (Starburst mark) dis-
played on the container.
New API Certification Mark (Starburst Mark)API Service label
1
2
3
1 Ind ic ates the oil q uality b y API d esig nations
2 Ind ic ates the SAE oil visc osity g rad e
3 Ind ic ates that the oil has fuel saving c ap ab ilities