2001 SUBARU LEGACY oil level

11-10
Changing the oil and oil filter
Chang e the oil and oil filter ac c ord ing to the main tenanc e sc hed ule in
the “Warranty and Maintenanc e Booklet ”.
The eng ine oil and oil filter must b e c hang ed more freq uently than
listed in the maintenanc e sc hed ule when d riving on d usty road s,
when short trip s are freq uently mad e, or when d rivi ng in extremely
c old whether.
1. Warm up the eng ine b y letting the eng ine id le for ab out 10 minutes
to ease d raining the eng ine oil.
2. Park the vehic le on a level surfac e and stop the eng ine.
3. Remove the oil filler c ap .
HBB005BB
4. Drain out the eng ine oil b y removing the d rain p l ug while the en-
g ine is still warm. The used oil should b e d rained into an ap p rop riate
c ontainer and d isp osed of p rop erly.
WARNING
Be careful not to burn yourself with hot engine oil.
5. Wip e the seating surfac e of the d rain p lug with a c lean c loth and
tig hten it sec urely with a new sealing washer after the oil has c om-
p letely d rained out.

11-1212. Reinstall the c over und er the oil filter.
13. Pour the sp ec ified amount of eng ine oil throug h
the filler nec k.
Oil c ap ac ity: 2.5 liter mod els: 4.2 US q t (4.0 liters, 3.5 Imp q t )
3.0 liter mod els: 6.0 US q t (5.7 liters, 5.0 Imp q t )
14. Start the eng ine and make sure that no oil leak s ap p ear around
the filter ’s rub b er seal.
15. Run the eng ine until it reac hes the normal op er ating temp erature.
Then stop the eng ine and wait a few minutes to allo w the oil d rain
b ac k. Chec k the oil level ag ain and if nec essary, a d d more eng ine oil.
Recommended grade and viscosity CAUTION
Use only engine oil with the recommended grade and viscosity.
Oil grade: API classification SJ or SH with the words “ENERGY
CONSERVING II ” (if you cannot obtain the oil with SJ
or SH grade, you may use SG grade oil.) or the new API certification mark (Starburst mark) dis-
played on the container.
New API Certification Mark (Starburst Mark)API Service label
1
2
3
1 Ind ic ates the oil q uality b y API d esig nations
2 Ind ic ates the SAE oil visc osity g rad e
3 Ind ic ates that the oil has fuel saving c ap ab ilities

Maintenance and service11-23
–
CONTINUED –
sc hed ule in the
“Warranty and Maintenanc e Booklet ”. Consult your
SUBARU d ealer for rep lac ement.
If a b elt is loose, c rac ked , or worn, c ontac t your SUBARU d ealer.
Manual transmission oil Checking the oil level
Chec k the oil level monthly.
1. Park the vehic le on a level surfac e and stop the eng ine.
OM-H0210
Upper level Lower level
HBB004DB
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil throug h the d ip stic k hole to b ring the level up
to the up p er level. Recommended grade and viscosity
Eac h oil manufac turer has its own b ase oils and ad d itives. Never use
d ifferent b rand s tog ether.
Oil grade: API classification GL-5

11-26Front differential gear oil (AT vehicles)
Checking the oil level
Chec k the d ifferential oil level monthly.
HBA010BB
Lower level Upper levelHBB004EB
1. Park the vehic le on a level surfac e and stop the
eng ine.
2. Pull out the d ip stic k, wip e it c lean, and insert it ag ain.
3. Pull out the d ip stic k ag ain and c hec k the oil lev el on it. If it is b elow
the lower level, ad d oil to b ring the level up to t he up p er level.
Recommended grade and viscosity
Eac h oil manufac turer has its own b ase oils and ad d itives. Never use
d ifferent b rand s tog ether.
Oil grade: API classification GL-5

Maintenance and service11-27
–
CONTINUED –
SAE viscosity No. and Applicable Temperature
OM-H0212
Rear differential gear oil
Checking the gear oil level CAUTION
If the vehicle requires frequent refilling, there may be an oil leak. If you suspect a problem, have the vehicle checked at your
SUBARU dealer.
Your vehic le may b e eq uip p ed with a rear d ifferenti al p rotec tor. The
d ifferential p rotec tor p rovid es p rotec tion to the r ear d ifferential assem-
b ly d uring off-road use. Removal of the rear d iffer ential p rotec tor is not
req uired when c hec king the oil level.

11-28
HB0078
HB0077
Filler hole
Drain hole Filler hole
Drain hole
Oil level
Remove the p lug from the filler hole and c hec k the oil level. The oil
level should b e kep t even with the b ottom of the fi ller hole. If the oil
level is b elow the b ottom ed g e of the hole, ad d oil throug h the filler
hole to raise the level. Recommended grade and viscosity
Eac h oil manufac turer has its own b ase oils and ad d itives. Never use
d ifferent b rand s tog ether.
Oil grade: API classification GL-5
SAE viscosity No. and Applicable Temperature
OM-H0205

Maintenance and service11-29
–
CONTINUED –
Power steering fluid
Checking the fluid level
WARNING
Be careful not to burn yourself because the fluid may be hot.
CAUTION
When power steering fluid is being added, use only clean fluid,
and be careful not to allow any dirt into the tank. And never use
different brands together. Avoid spilling fluid when adding it in the tank.
The p ower steering fluid exp and s g reatly as its tem p erature rises; the
fluid level d iffers ac c ord ing to fluid temp erature. Therefore, the reser-
voir tank has two d ifferent c hec king rang es for hot and c old fluid s.
Chec k the p ower steering fluid level monthly.
1. Park the vehic le on a level surfac e, and stop the eng ine.
2. Chec k the fluid level of the reservoir tank.
When the fluid is hot after the vehic le has b een ru n: Chec k that the oil
level is b etween “HOT MIN ” and “HOT MAX ” on the surfac e of the
reservoir tank.
When the fluid is c ool b efore the vehic le is run: C hec k that the oil level
is b etween “COLD MIN ” and “COLD MAX ” on the surfac e of the res-
ervoir tank.
3. If the fluid level is lower than the ap p lic ab le “MIN ” line, ad d the
rec ommend ed fluid as nec essary to b ring the level b etween the
“ MIN ” and “MAX ” line.