2001 Peugeot Partner VU warning light

These warning lights are tested with the key in the ignition on position : M
64III-1STEERING LOCK-IGNITION-STARTER
¥ S : Steering lock
To release the steering lock, turn the steering wheel slightly, without forcing it, at the
same time as turning the key.
¥ A : Accessories Allows operation of some electrical accessories (radio, electric windows, map rea-
ders, etc.). The battery charge light comes on. ¥ M : Ignition
The following warning lamps * should illuminate : ABS, preheating (Diesel), battery
charge, STOP, oil pressure, handbrake and brake fluid level, engine autodiagnosis,airbags, door closing. If any of these warning lamps do not illuminate, there is a malfunction. ¥ D : Starter Release the key as soon as the engine has started. Never operate the key with the
engine running (see ÒSTARTING THE ENGINEÓ).
* According to model or country

Steering lock SWith the key removed and the steering lock engaged, the steering is loc- ked; the lock will engage in a number of positions of the steering wheel.The key can only be removed in the Sposition.
A The steering lock is released (by turning the key to position A, turning the
steering wheel slightly, if necessary).
M Driving position.
D Starting position.
For starting and stopping the engine, see ÒSTARTING THE ENGINEÓ.
65III-1STEERING LOCK-IGNITION-STARTER
WARNING
Never remove the ignition key before the vehicle has come to a complete stop. Never attempt to move the
vehicle without the engine running. If the engine is not running, the vehicleÕs steering and braking systemswill not be power-assisted (there is a risk of the steering lock engaging and the safety features not opera-ting). After parking, remove the ignition key and turn the steering wheel until the steering column locking peg engages.

Check that the gear lever is in neutral.
PETROL ENGINEStarting with the engine cold. Do not press the accelerator pedal. Operate the starter until the engine starts (not more than ten seconds).In very low temperatures, press the clutch pedal when operating the starter to ease starting of the engine. Release
the clutch pedal slowly.
DIESEL ENGINEStarting with engine cold
Turn the ignition key to position M(ignition, preheater) and wait until the preheater warning light goes out. Then
operate the starter until the engine starts. In very low temperatures, press the clutch pedal when operating the starter to ease starting of the engine. Release
the clutch pedal slowly. Note : Do not press the accelerator pedal during starting.
Starting with engine hot
Operate the starter. If the engine fails to start at the first attempt, repeat using the preheater. In all cases, if the engine stops or fails to start at the first attempt, wait a few seconds before operating the starter again. Note : The preheater warning lamp does not come on when the engine is hot.
Recommendation : It is not necessary to warm up the engine before starting off. Wait for the warning lamp to go out and then drive
off slowly, accelerating gently until the engine warms up.
66III-2STARTING THE ENGINE
CAUTION
Do not run the engine in an enclosed or poorly ventilated space.

ABS system*
This system increases safety by preventing the wheels from locking in the event of harsh braking or in conditions of poor grip. It enables the driver to maintain control of the steering.
The operating capacity of all the essential electrical elements of the ABS system is controlled by an electronic moni-
toring system both before and during driving. The ABS light comes on when the ignition is switched on, and should
go out after approximately two seconds. If the light does not go out, this indicates that the ABS is disconnected due
to a fault. Likewise, if the light comes on while driving, this indicates that the ABS is not operating. In both cases,
the normal braking system remains effective, as on a vehicle without ABS. However, to avoid the occurrence of other
faults with unknown consequences, the ABS should be inspected as soon as possible by an approved dealer.
It is still necessary to drive carefully on slippery surfaces (loose stones, snow, ice, etc.)..
67III-3BRAKES
Handbrake
The handbrake is operated by pulling the lever upwards. The greater the slope you are on, the greater the force that should be applied in pulling the
lever.
To ease the action of the handbrake lever, it is recommended that you press the brake pedal at the same time. As a precaution, 1st gear should be engaged in all cases. On steep slopes, you should also turn the wheels towards the kerb.
To release the handbrake, pressthe button while pulling the lever up, then
lower the lever to the fully down position.The warning light comes on if the handbrake is on or not fully released, with the ignition on.
* According to model or country.

Ashtray
To empty, press the locking tongue and slide the ashtray unit towardsyou. Push it back into position. Lighter Push in and wait a few moments for the lighter to release automati-
cally.
WARNING :keep children away
from the cigar lighter as it can ope- rate even with the ignition swit-
ched off (see fuse F23 - F23B). Storage compartments andbottle holder (for 1.5 litre bottle + 1 cup or 33 cl bottle).
Sun visor
To avoid sun glare through the windscreen, fold the sun visordownwards. In case of side glare,through the door windows, releasethe sun visor from its inside faste-ning and pivot it to the side.
74IV-3COMFORT