PEUGEOT SERVICING
22
SERVICING LEVELS Each vehicle possesses its servicing cycle, defined by the manufacturer in terms of the technical features.
This cycle consists in alternating beteen 2 levels A and C, intermediate visits and a few additional operations specific to your vehicle; they correspond to key stages in the life of your 206 CC. Service level B concerns servicing of less recent vehicles.At your first and each subsequent service, your dealer will advise you of the type and content of the next service due.
Intermediate top-up visit incorporated in the ServicingSchedule.
Automatic gearbox oil
level every 40,000 miles (60,000 km).
Replacement of brake fluidevery 2 years or 40,000 miles (60,000 km).
These fixed operations are carried out with synthetically based oil. Fuel Economy oil or
synthetic oil may also be used.
THE MAINTENANCE CYCLE FOR YOUR 206 CC
Service every 20,000 miles (30,000 km) or 2 years.
MILES (KM) 20,000 (30,000) 40,000 (60,000) 60,000 (90,000) 80,000 (120,000)
1st service at 6,000 miles
(10,000 km) or 6 months*. This is necessary in
order to benefit from the warranty.
100,000 (150,000) 120,000 (180,000) 140,000 (210,000) 160,000 (240,000) 180,000 (270,000)
+ replacement of timing belt
+ replacement of timing belt
* Whichever is first.
PEUGEOT SERVICING23
- Engine oil
Level
Operations Operation descriptions 1st
service
AC
Intermediate visit
- Oil filter - Fuel filter - Air filter element - Spark plugs
- Engine oil (check + top-up) - Manual gearbox oil (check + top-up) - Battery (check + top-up) if removable cap - Coolant level (check + top-up) - Front windscreen wash (check + top-up) - Brake fluid (check + top-up) - Power steering fluid (check + top-up according to specification)
- Operation of lights and indicators - Condition of glass, headlamp and light lenses and mirrors - Horn - Condition of wiper blades - Windscreen jets - Condition and tension of the ancillary drive belts - Handbrake - Condition of hydraulic circuits (hoses and covers) and check for leaks - Condition of rubber boots and gaiters - Brake pad wear o- Play in hubs, link rods, ball joints, flexible mountings - Shock absorbers: check for leaks - Rear drum brake lining wear - Condition and pressure of tyres (including spare tyre) - Emission control check according to current legislation - Pollen filter (according to specification) o- Visual check of the whole vehicle by a PEUGEOT dealer
- Courtesy vehicle
All driving conditions. oArduous conditions
DRAIN AND REFILL
REPLACE
LEVELS
CHECK
SERVICE
ROAD TEST
TYPE A AND C SERVICES AND THE INTERMEDIATE VISIT
YOUR 206 CC IN DETAIL71
Bonnet strut Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that the bonnetis locked.
Opening the bonnet Inside the vehicle:
pull the handle on
the left- hand side, under the fascia. Outside the vehicle: lift the catch and
raise the bonnet. Filling the fuel tank The tank must be filled with fuel with the engine switched off
.
Insert the key then turn it to the left. Remove the cap.
A label indicates which type of fuel to use. If you fill your tank, do not continue
after the third cut-off of the pump
nozzle. This could result in vehiclemalfunctions. The capacity of the tank is approxi- mately 10.3 gallons (47 litres).
