2001 PEUGEOT 106 DAG warning

Front head restraints Height adjustment: slide the head restraint. The adjustment is correct when the upper edge of the head restraint isat the same height as the top of thehead. This adjustment avoidsexcessive movement of the headrearwards, in cases of rear impact. Adjustment of angle*: tilt the head restraint.
To remove the head restraint: posi- tion it at maximum height, press thetwo lugs then remove the headrestraint.
Warning:never drive with the head
restraints removed; they must be in place and correctly adjusted.
Adjustment of front seats Forwards/backwards adjustment: lift control
1, slide the seat, then let go to lock.
Adjustment of seat back:push control 2rearwards to obtain the required angle.
Access to rear seats: (3 doors)raise control 3or push control 2towards the front.
Tilt the back of the seat, then pull the seat forward.
The position of the seats is memorised*. To put them back as they were before, you need only return them to the original position.
The storage compartment for the handbook and Warranty book is located under the front right-hand seat*. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L50
13
2
06-05-2002

Rear seats
To tilt the seat:
Ð Pull the rear of the seat 1and tilt it against the front seats.
Ð Place the seat-belt in the hook 2(3-door) or on the top of the seat-back 4
(5-door).
Ð Unlock the seat-back by using the controls 3on the sides.
Ð Tilt the seat-back 4.
To remove the rear seat cushions , tilt the seat cushion to 45¡ and remove it.
To replace the seat cushion: position it on the front Þxing brackets and lower it to the normal position. When folding the rear seats, always start with the seat cushion, never the seat back (risk of damage).
Rear head restraints* These have one position (high) for when they are in use and anotherposition (low) for storing. They areremovable.
To lower, press the lug.
To remove, pull upwards as far as the stop and press the lug.
Warning:
never drive with the head
restraints removed; they must be in place and correctly adjusted. * According to speciÞcation.
Y O U R 1 0 6 I N D E TA I L51
2134
06-05-2002

Seat belts (5-door):
To adjust the height of the front seat belts*:
Pull control 1towards you and slide it.
To fasten the seat belts: Pull the strap, then insert the end into the buckle. Rear seat beltsThe rear seats are Þtted with two three-point inertia reel belts and alap belt. Pre-tensioning and force-limiting front seat belts* Safety in the event of a front impact has been improved by theintroduction of pre-tensioning andforce-limiting front seat belts.Depending on the seriousness ofthe impact, the pre-tensioningsystem instantly tightens the seatbelts Þrmly against the body of theoccupant. The pre-tensioning seat belts are armed when the ignition is on. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L54
1To be effective, a seat belt must be tensionedas close to the body aspossible.
Depending on the nature andseriousness of the impact thepre-tensioning system may betriggered before and indepen-dently of the airbags. In all cases, the airbag warning light comes on. Following an impact, have the system checked by a PEUGEOT
dealer. The system has been designed to be fully operational for tenyears. Have it replaced at the endof this period.
06-05-2002

Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:
- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, - ABS* (lights for 3 seconds, the
warning lamp should always go out when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lights for six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out:
- low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering
Turn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L55
06-05-2002

Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:
- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, - ABS* (lights for 3 seconds, the
warning lamp should always go out when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lights for six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out:
- low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering
Turn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L55
06-05-2002

Y O U R 1 0 6 I N D E TA I L56
Never race a cold engine.
Never run the engine in an enclosed space. If the engine cannot be stopped using the igni-
tion key, press the brake pedal,engage a gear and release theclutch in order to stall the engi-ne. Do not modify the steering
lock in any way.
Starting a petrol engine* Do not press the accelerator pedal. Operate the starter without relea- sing the key until the engine starts. * According to speciÞcation Starting a diesel engine Engine cold: Do not press the accelerator pedal.
Turn the key to position
ÒMÓ, the
pre-heat warning lamp lights.
Wait until the warning lamp goes out, then operate the starter in posi-tion ÒDÓ until the engine runs
smoothly. Engine hot: Do not press the accelerator pedal.
Operate the starter.If the engine stops or does not start
immediately, always wait a fewseconds before trying again using
the pre-heater.
NOTE: according to speciÞca-tion, the pre-heat warninglamp does not light if the engi-ne is sufÞciently hot.
06-05-2002

Switching off the side lights
switches off the rear fog lamp orreturns to the front fog lamps onlyposition if the vehicle is Þtted withthem. Horn Press the end of the stalk.
Dipped/main beam. Light off. Rear fog lamp lit.
Lights off. Front fog lamps.
Front and rear fog lamps.
Lights off.
Side light on.
In both clear and rainy
weather, in daylight andat night, the rear foglamp dazzles and is the-refore prohibited.
Do not forget to switch it off assoon as it is no longer needed.
LIGHTS STALK Front lights Selection is by turning ring A.
Changing between dipped/main beam: Pull the stalk fully towards you.When your vehicle is equipped with long range light* these operatesimultaneously with the main beam. To ßash the headlamps: Flick the stalk towards you and release it. N.B.:
If the lights are left on when
you switch off the engine and open
a front door, a buzzer will sound. Direction indicators (ßashers) Left, downwards.
Right, upwards.
Fog lamps Operation is by turning ring B. The
position is shown by the warning lamps on the fascia. It operates with the dipped/main beam headlamps. These operate with the side lights, dipped and main beam headlamps.
These operate with the side lights, dipped and main beam headlamps.
Rear Front and rear
Y O U R 1 0 6 I N D E TA I L62
A
B
A
B
06-05-2002

Interior mirror The interior mirror has two posi- tions:
- Day (normal)
- Night (anti-dazzle)
To change from one to the other:push or pull the lever on the bottom edge.Manually controlled mirrors
To adjust: move the adjustment lever in all four directions.
Electrically controlled mirrors*
To adjust:
- Select the mirror using the two way
switch 1.
- Adjust the mirror using control 2.
- Return the two-way switch 1to
its central position.
* According to speciÞcation
When the vehicle is parked, the mirrors can be folded back manually.
Warning: The mirror on the driverÕs side is aspherical to eliminate the Çblind spotÈ. Therefore, objects viewed in the mirror
are, in reality, closer than they appear. This must be taken into account in order to correctly judge the distance of vehicles approaching from behind.
Y O U R 1 0 6 I N D E TA I L65
1
2
06-05-2002