Page 55 of 107

Key position There are four positions of the ignition key in the lock: "S" Stop: ignition is off.
"A" Accessories: ignition is off but
accessories can operate. The battery charge warning lamp lights. "M" Run: ignition on. The following
warning lamps light:
- low engine oil pressure,
- coolant temperature,
- battery charge,
- pre-heater (DIESEL),
- handbrake, low brake ßuid,
- engine diagnostics*, - ABS* (lights for 3 seconds, the
warning lamp should always go out when the vehicle speed isover 8 m.p.h. [12 km/h]),
- Airbag*, the warning lamp lights for six seconds, then goes out.
"D" Starter: starts the engine.
The following warning lamps go out:
- low engine oil pressure,
- battery charge,
- engine diagnostics*. Starting Unlock the steering
Turn the steering wheel gently
while turning the key. Before starting it is advisable to: Press the clutch pedal while opera- ting the starter to aid starting of theengine. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L55
06-05-2002
Page 58 of 107

KEYS The keys will lock or unlock the doors and the boot or tailgate inde-pendently or simultaneously bycentral locking, as well as the fueltank Þller cap and the steering lock. They also enable the passenger airbag* to be disarmed.THE REMOTE CONTROL A single press on button
Alocks the
doors and boot or tailgate. A single press on button Bunlocks
the vehicle. Note: Do not repeatedly press the button of your remote control out of range
of your vehicle. You risk causing itnot to work and the remote controlwould have to be reprogrammed. Changing the remote control batteries
To gain access to the battery, unclip the key casing with a coin whereyou can see the ring (CR2016/3 V). If the remote control does not work after the battery has been changed,re-programme the remote control. Synchronising the remote control*
- Use the key to unlock the driverÕs
door of your vehicle.
- Within 30 seconds of unlocking your vehicle, press button A
twice.
- The vehicle is locked by the second press of the button.
The remote control is now working again. * According to speciÞcation
Y O U R 1 0 6 I N D E TA I L59
A
B
06-05-2002
Page 78 of 107
P R A C T I C A L I N F O R M AT I O N7474
4
1
3
5
6
87 2
1124 cm
3
injection engine
1 .Air Þlter
2 .Brake ßuid
3 .Battery
4 .Power steering
5 .Dip stic k
6 .Eng ine oil Þller
7 .Coolant
8 .Reservoir for front/rear sc reen and
head lamp wash-wip e*
06-05-2002
Page 79 of 107
P R A C T I C A L I N F O R M AT I O N75
4
1
3
5
6
87 2
9
75
1360 cm
3
injection engine
1 .Air Þlter
2 . Brake ßuid
3 .Battery
4 .Power steering
5 .Dip stic k
6 .Eng ine oil Þller
7 .Coolant
8 .Reservoir for front/rear sc reen and
head lamp wash-wip e*
9 .Automatic g earb ox
06-05-2002
Page 80 of 107
P R A C T I C A L I N F O R M AT I O N7676
4
1
3
6
87 2
5
16-valves 1587 cm
3
engine
1 .Air Þlter
2 .Brake ßuid
3 .Battery
4 .Power steering
5 .Dip stic k
6 .Eng ine oil Þller
7 .Coolant
8 .Reservoir for front/rear sc reen and
head lamp wash-wip e*
06-05-2002
Page 81 of 107
P R A C T I C A L I N F O R M AT I O N7777
4
1
3
5
6
87 2
1527 cm
3
diesel engine
1 .Air Þlter
2 .Brake ßuid
3 .Battery
4 .Power steering
5 .Dip stic k
6 .Eng ine oil Þller
7 .Coolant
8 .Reservoir for front/rear sc reen and
head lamp wash-wip e*
06-05-2002
Page 82 of 107

P R A C T I C A L I N F O R M AT I O N7878
CHECKING THE LEVELS 1. Air Þlter The air filter element must be changed at the recommendedintervals. If you drive in a dustyatmosphere, change it twice asoften. Follow the recommendations given in the maintenance schedule. 2. Brake ßuid The level must always be above the
DANGER mark on the reservoir. Inthe event of a signiÞcant drop in theßuid level, consult a PEUGEOT
dealer immediately. Use fluids
approved by the manufacturer,which conform to DOT 3 or DOT 4standards. 3. Battery
At the beginning of winter, have the battery checked by a PEUGEOT
dealer. In summer (30¡C and above) or if the battery is in heavy use, checkthe level of electrolyte; it must coverthe separator plates at all times. If
necessary, top up with distilled
water.4. Power steering* When the engine is cold, the level must always be above the MINmark, close to the MAX mark. 5. Dipstick Check the oil level on ßat ground, with the engine cold and preferably
before the Þrst journey of the day. Never exceed the maximum level.
Check the level regularly.
6. Topping up with oil
Your oil must be changed in accor- dance with the maintenance sche-dule. The oil must be topped up between oil changes. Regularly check and top-up the oil level. Maximum oil consumption is 0.5 litres per 600 miles (1000 km). 7. Coolant Engine cold: the coolant level must be between the min and max marksin the expansion chamber with the
cap removed. To close, turn the capto the second notch*.
Cooling circuit Always use the coolant which is approved by the manufacturer
(PROCOR TM108 / GLYSANTING33 or REVKOGEL 2000). If this isnot possible, top up with distilledwater and have the protection level
checked by a PEUGEOT dealer. When the engine is hot, the coolant temperature is regulated by the fan.As the fan can operate with theignition key removed, and as thecooling circuit is pressurised,
do
not carry out any work for atleast an hour after switching offthe engine .
Note: the coolant does not need tobe renewed.
8. Front/rear screen and headlamp wash reservoir*
For optimum cleaning quality and
for your safety, it is best to use clea-ning products approved by PEU-GEOT (capacity 4.5 litres withoutheadlamp wash, 5.5 litres withheadlamp wash). * According to speciÞcation
06-05-2002
Page 94 of 107
P R A C T I C A L I N F O R M AT I O N90
FuseRating* Functions*
1ÑNot used
2 30A Anti-lock braking system
3 25A Engine cooling
4 20A Anti-lock braking system
5 25A Fan unit
6 20A Additional driving lamps
7 ÑNot used
8 ÑNot used
9 10A Fuel pump
10 ÑNot used
11 10A Oxygen sensor
12 10A Left-hand main beam
13 10A Right-hand main beam
14 10A Left-hand dipped beam
15 10A Right-hand dipped beam
16 30A Pulsair pump
16 fuse box (engine compartment)
Maxi fuse (engine compartment)
MF1 20A Lighting switch
MF2 80A Ignition supply (starter +ve)
MF3 40A Ignition supply (ignition controlled +ve)
MF4 40A Battery +ve feed to 13-fuse box
* According to speciÞcation.06-05-2002