2001 Mercury Villager garage door opener

2. Move the control in the direction
you wish to tilt the mirror.
3. Return to the center position to lock mirrors in place.
Heated outside mirrors (if equipped)
Both mirrors are heated
automatically to remove ice, mist
and fog when the rear window
defrost is activated.
Do not remove ice from the mirrors
with a scraper or attempt to readjust
the mirror glass if it is frozen in
place. These actions could cause
damage to the glass and mirrors.
HOMELINKTUNIVERSAL TRANSCEIVER (IF EQUIPPED)
The HomeLinktUniversal Transceiver, located on the driver's visor,
provides a convenient way to replace up to three hand-held transmitters
with a single built-in device. This feature will learn the radio frequency
codes of most current transmitters to operate garage doors, entry gates,
security systems, entry door locks, and home or office lighting.
When programming your HomeLinktUniversal Transceiver, to a
garage door or gate be sure that people and objects are out of
the way to prevent potential harm or damage.
Do not use the HomeLinktUniversal Transceiver with any garage door
opener that lacks safety stop and reverse features as required by U.S.
federal safety standards (this includes any garage door opener model
manufactured before April 1, 1982). A garage door which cannot detect
an object, signaling the door to stop and reverse, does not meet current
U.S. federal safety standards. For more information on this matter, call
toll-free: 1±800±355±3515 or on the Internet atHomeLink.jci.com.
MIRRORS
L R
Controls and features
94

Programming
Do not program the HomeLinktUniversal Transceiver with the
vehicle parked in the garage.
1. Prepare for programming the
HomeLinktUniversal Transceiver by
erasing the three factory default
codes by holding down the two
outside buttons until the red light
begins to flash after 20 seconds.
Release both buttons.
2. Hold the end of your hand-held
transmitter 5±14 cm (2±5 inches)
away from the HomeLinktUniversal
Transceiver surface (located on your visor) while keeping the red light in
view.
3. Using both hands simultaneously
press and hold the hand-held
transmitter button and the desired
HomeLinktbutton. Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with the procedure in the ªCanadian Programingº section.
4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly.
5. Follow steps 2 through 4 to program the remaining two buttons.
If you do not successfully program the HomeLinktUniversal Transceiver
after repeated attempts, refer toRolling code programingwhich
follows, or call toll-free customer assistance: 1±800±355±3515 or on the
Internet atHomeLink.jci.com.
Canadian Programming
During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLinktUniversal Transceiver.
Controls and features
95

To program your hand-held
transmitters:
²continue to hold the button on
the HomeLinktUniversal
Transceiver.
²press and re-press the hand-held
transmitter button every two
seconds until the red light changes from a slow to a fast flash.
Operating the HomeLinkTUniversal Transceiver
Once programmed, the HomeLinkt
Universal Transceiver can be used in
place of hand-held transmitters. To
operate, simply press and release
the appropriate HomeLinktbutton
(the red light will illuminate,
indicating the signal is being
transmitted).
Rolling code programming
Rolling code garage door openers (or other rolling code devices) which
are ªcode protectedº and manufactured after 1996, may be determined
by the following:
²Reference the device owner's manual for verification
²The hand-held transmitter appears to program the HomeLinkt
Universal Transceiver but does not activate the device.
²Press and hold the trained HomeLinktbutton. The device has the
rolling code feature if the indicator light flashes rapidly and then turns
solid after two seconds.
After completing the ªProgrammingº functions, follow these steps to
train a garage door opener with the rolling code feature:
1. Locate thetraining buttonon the garage door motor head unit.
Refer to the garage door opener manual or call 1±800±355±3515 or on
the Internet atHomeLink.jci.com.if there is difficulty locating the
training button.
2. Press the training button on the garage door motor head unit (which
will activate theªtrainingº light).
Controls and features
96

3. Press and release the
programmed HomeLinktbutton.
Press and release the HomeLinkt
button asecond timeto complete
the training process. (Some garage
door openers may require this
procedure to be done a third time
to complete the training).
The 2nd or 3rd press from step 3 will activate the door. The HomeLinkt
Universal Transceiver has now been trained to the receiver. The
remaining two buttons may now be programmed if this has not
previously been done.
Erasing HomeLinkTbuttons
Individual buttons cannot be erased,
however, to erase the three
programmed buttons:
1. Hold down the two outside
buttons until the red light begins to
flash after 20 seconds.
2. Release both buttons.
Reprogramming a single HomeLinkTbutton
To program a device to HomeLinktusing a HomeLinktbutton previously
trained, follow these steps:
1. Press and hold the desired HomeLinktbutton.Do NOTrelease until
step 4has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds),
position the hand-held transmitter 5±14 cm (2 to 5 inches) away from
the HomeLinktsurface.
3. Press and hold the hand-held transmitter button.
4. The HomeLinktindicator light will flash, first slowly and then rapidly.
When the indicator light begins to flash rapidly, release both buttons.
The previous device has now been erased and the new device can be
activated by pushing the HomeLinktbutton that has just been
programmed.
Controls and features
97

cause the engine to stumble or stall or cause the transmission to be
damaged or operate improperly. In addition, such systems may be
damaged or their performance may be affected by operating your
vehicle. (Citizens band [CB] transceivers, garage door openers and
other transmitters with outputs of five watts or less will not ordinarily
affect your vehicle's operation.)
²Ford cannot assume responsibility for any adverse effects or damage
that may result from the use of such equipment.
ORDERING ADDITIONAL OWNER'S LITERATURE
To order the publications in this portfolio:
Make checks payable to:
HELM, INCORPORATED
P.O. Box 07150
Detroit, Michigan 48207
For a free publication catalog, order toll free: 1-800-782-4356
Monday-Friday 8:00 a.m. - 6:00 p.m. EST,
for credit card holders only
Obtaining a French owner's guide
French Owner's Guides can be obtained from your dealer or by writing to
Ford Motor Company of Canada, Limited, Service Publications, P.O. Box
1580, Station B, Mississauga, Ontario L4Y 4G3.
Customer assistance
248

Engine block heater .................150
Engine oil ..................................189
checking and adding ..............189
dipstick ....................................189
filter, specifications ........191, 232
recommendations ...................191
refill capacities ........................232
specifications ..................233±234
Exhaust fumes ..........................151
F
Floor mats .................................100
Fluid capacities .........................232
Foglamps .....................................23
Fuel ............................................211
calculating fuel economy .......216
cap ...........................................213
capacity ...................................232
choosing the right fuel ...........214
comparisons with EPA fuel
economy estimates .................219
detergent in fuel .....................215
filling your vehicle
with fuel ..................211, 213, 216
filter, specifications ........216, 232
fuel pump shut-off switch .....167
gauge .........................................16
improving fuel economy ........216
low fuel warning light ..............11
octane rating ...................215, 234
quality ......................................215
running out of fuel .................216
safety information relating to
automotive fuels .....................211
Fuses ..................................168±169G
Garage door opener ....................94
Gas cap (see Fuel cap) ............213
Gas mileage
(see Fuel economy) .................216
Gauges .........................................14
engine coolant
temperature gauge ...................17
fuel gauge ..................................16
odometer ...................................15
speedometer .............................15
trip odometer ............................16
GAWR
(Gross Axle Weight Rating) .....160
calculating ...............................161
definition .................................160
driving with a heavy load ......160
location ....................................160
GVWR (Gross
Vehicle Weight Rating) .............160
calculating .......................160±161
definition .................................160
driving with a heavy load ......160
location ....................................160
H
Hazard flashers .........................167
Head restraints .........................110
Headlamps ...................................22
aiming ......................................226
autolamp system .......................23
bulb specifications ..................225
flash to pass ..............................22
high beam ...........................10, 22
replacing bulbs .......................222
turning on and off ....................22
warning chime ..........................13
Index
252

Heating ........................................24
heating and air
conditioning system .................24
HomeLink universal
transceiver (see
Garage door opener) ............94±97
Hood ..........................................187
I
Ignition .................................82, 234
Infant seats
(see Safety seats) .....................137
Inspection/maintenance
(I/M) testing ..............................220
Instrument panel
cleaning ...................................230
cluster ..................................8, 230
lighting up panel
and interior ...............................22
location of components ..............8
J
Jack ............................................175
positioning ...............................175
storage .....................................175
Jump-starting your vehicle ......179
K
Keys
key in ignition chime ...............13
positions of the ignition ...........82
L
Lamps
autolamp system .......................23bulb replacement
specifications chart ................225
cargo lamps ...............................22
fog lamps ...................................23
headlamps .................................22
headlamps, flash to pass ..........22
instrument panel, dimming .....22
interior lamps ...........................98
replacing bulbs ...............221±225
Lane change indicator
(see Turn signal) ........................87
Liftgate ......................................106
Lights, warning and indicator ......8
air bag ..........................................8
anti-lock brakes (ABS) ....11, 153
brake ............................................9
charging system ..........................8
cruise indicator ...................10, 86
door ajar ....................................10
high beam .................................10
low fuel ......................................11
low washer fluid .......................13
oil pressure .................................9
overdrive off ..............................13
safety belt ...................................9
service engine soon ..................11
turn signal indicator .................10
Load limits .................................160
GAWR ......................................160
GVWR ......................................160
trailer towing ..........................160
Locks
childproof ..................................92
doors ..........................................92
Lubricant specifications ...233±234
Lumbar support, seats .............113
Index
253