SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Seats
Quick Tips 2001 Mazda Millenia page 12
page 13
Revised January 9, 2001
1. Head restraint
To raise/lower: Press release
button (4) and pull up/
push down
To move forward/aft: Rotate
(driver’s seat only)
Power seats
2. Raise/lower front of seat
Move front of switch vertically
Fore/aft adjustment
Move switch horizontally
Raise/lower rear of seat
Move rear of switch vertically
Raise/lower seat cushion
Movecenter of switch vertically
3. Seatback angle
Rotate fore/aft for desired angleLumbar support
(driver’s seat only)
Located at front of
center console
Press top/bottom of switch to
increase/decrease firmness WARNINGS: Always wear
your safety belt and properly
secure children 12 and under
in the rear seat
If you choose to install a
forward-facing child restraint
seat, move vehicle seat as
far back as possible
Air bag is supplemental
and does not replace safety
belt usage
Do not adjust seat while driving
1
4
23
1
Shoulder belt height
adjustment
To raise/lower belt, press
button (1) and move up/down
WARNING: Make sure
adjuster locks in position
WARNINGS: Children less
than 4 years old and under
40 pounds should always
use a safety seat
Never place rear-facing child
restraint seat in front seatChild restraint seat
Some child restraint systems are
equipped with tethers that must
be installed on one of the three
anchors on the rear seats
To install in rear outboard seats:
Use dual locking mode retractor
safety belt; see Owner’s Manual
for proper installation and child
seat tether instructionsWARNING: Read all
information and warnings
in Owner’s Manual and
attached to seat before using
child safety seat
Dual locking mode
lap/shoulder belt retractor
(front passenger and rear
outboard safety belts only)
Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about
5 mph or more
Automatic locking mode:
Must be used when installing
child safety seat
To activate: Pull webbing fully
out of retractor until click is
heard; belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully
CLIMATE CONTROLS
Always check the Owner’s Manual for more operating information and safety features
Climate
Controls
Console/
Trunk
Quick Tips 2001 Mazda Millenia page 14
page 15
Revised January 9, 2001
Trunk
To open: Use key or remote
keyless entry fob
Remote trunk release,
see Driver’s View
Remote trunk release
lock-out
To enable/disable: Press left/
right side of switch (located
in glovebox)5. Temporary spare tire
To change flat tire:
Follow instructions in
Owner’s Manual
WARNING: Do not exceed
50 mph with temporary
spare
6. Lugwrench and jack
handle
7. Jack
Interior luggage
compartment
release
Allows you to escape
should you become
locked in trunk
To open: Pull “T” handle; “T”
handle will glow if it has been
exposed to light
2
34
1
5
7
6
8
Automatic climate control
1. Auto
Press to select automatic
system operation
2. Temperature control
Rotate left/right for
colder/warmer
3. Mode
Press to select
= air to dash
= air to dash and floor
= air to floor
= air to floor and
windshield
4. Off
Press to turn off climate
control system
5. Fan control
Press to cycle through four
speed settings
Center console
1. Parking brake
To engage: Pull up
To release: Pull up slightly
while depressing button at
front of lever, lower parking-
brake lever
2. Cup holders
3. Accessory socket
For accessories only
4. Storage bin6. Ambient temperature
Press to display outside
temperature
7. Air intake control
Press for
recirculated/outside air
8. Air Conditioning
Press to manually select
normal, economical or off
9. Defrost
Press to direct air to windshield
10. Rear window
defogger
Press to turn on/off
11. Clock
12. Clock controls
To set: Press (H) hour/
(M) minutes; press RESET
to clear minutes
Tip: Fan speed, A/C selection
and mode selection are
indicated in display (13)
H SET M RESET
4:20F72
REAR FRONT
69431058712111213
PULL
8
