2001 MAZDA MODEL 626 light

Form No. 8P95-EA-00G
LIGHTS
HEADLIGHT HIGHBEAM
HEADLIGHT LOWBEAM
PARKING LIGHTS
ILLUMINATIONCONTROL
TURN SIGNALS
HOOD RELEASE
TRUNK RELEASE
FUEL
ENGINE COOLANTTEMPERATURE
ENGINE OIL
BATTERY CHARGING SYSTEM
BRAKE SYSTEM
VENTILATION FAN
AIR RECIRCULATION
FRESH AIR
VENT
VENT-FLOOR
How to Use This Manual
Q002-2AE
Graphic symbols:
Some of the following symbols are used to identify
controls and displays on your vehicle.

Form No. 8P95-EA-00G
How to Use This ManualHAZARD WARNINGFLASHER
SEAT BELTS
FLOOR
FLOOR
DEFROSTING
DEFROSTING
REAR WINDOW DEFROSTER
WINDSHIELD
WIPER & WASHER
LIGHTER
HORN
WASHER FLUID
CHECK ENGINE LIGHT

Form No. 8P95-EA-00G
*Some models.
Your Vehicle at a Glance
1-3
004-3AE
Dashboard Overview
Hazard warning flasher switch (page 6-2)
Vent (page 5-62) Side vent (page 5-62)
J94S1002
Instrument cluster (page 5-30)
Cruise control switch* (page 5-26)Audio system* (page 5-75)
Shift lever (page 5-7, 5-9)
Parking brake handle (page 5-21)
Dashboard illumination
control (page 5-35)
Hood release handle (page 3-20)
Outside mirror switch*
(page 3-34) Light control/
Turn signal lever
(page 5-44)
Climate control system (page 5-60)

Form No. 8P95-EA-00G
*Some models.
Your Vehicle at a Glance1-4
004-4AE
Doors
Courtesy light (page 3-41)
Front (Driver’s side)
Remote trunk lid release (page 3-16)Door lock switch* (page 3-7)
Door lock (page 3-4)
Power window
master control*
(page 3-13)J94S1003_a
(2001)
Outside mirror (page 3-33)
Door handle (page 3-7)
Courtesy light (page 3-41)
Front (Passenger’s side)J94S1004_a (2001)
Door lock (page 3-4)
Outside mirror (page 3-33)
Power window switch* (page 3-13) Door handle (page 3-7)

Form No. 8P95-EA-00G
Essential Safety Equipment
2-3

016-2AE
J94A2025 Seat Recline
To change each individual seatback
angle, lean forward slightly while
raising the lever. Then lean back to the
desired position and release the lever.
Make sure the lever returned to its original position and the seatback is
locked in place by attempting to push
it forward and backward.


016-15BE
WARNING
!
Reclining:Sitting in a reclined position while
the vehicle is moving is dangerous
because you don’ t get the full
protection from seat belts. During
sudden braking or a collision, you
can slide under the lap belt and
suffer serious internal injuries.
For maximum protection, sit well
back and upright.
CAUTION
!
When returning a rear-reclined
seatback to its upright position,
make sure you support the
seatback while operating the
seatback lever. If the seatback is
not supported, it will flip forward
suddenly and could cause injury.

Form No. 8P95-EA-00G
Essential Safety Equipment
2-7

017-5A1E
J94A2030 Seat Height Adjustment
Raise the seat-bottom by pulling up on
the center of the switch. Release the
switch when the seat is where you
want it. Lower the seat-bottom by pressing
down on the center and releasing it
when the seat is where you want it.


016-2AE
J94A2025 Seat Recline
To change each individual seatback
angle, lean forward slightly while
raising the lever. Then lean back to the
desired position and release the lever.

Form No. 8P95-EA-00G
Essential Safety Equipment2-16
WARNING
!
Twisted Seat Belts:Twisted seat belts can cause
injury. In a collision, the full
width of the belt isn’t available to
absorb the impact. This puts more
force on the bones beneath the
belt, which could break them or
cause other serious injury or
death. Don’ t wear twisted seat
belts.
WARNING
!
One Belt, One Passenger:Using one seat belt for more than
one person at a time is dangerous.
A seat belt used in this way can’ t
spread the impact forces properly
and the two passengers could be
crushed together and seriously
injured or even killed. Never use
one belt for more than one person
at a time.
020-3HE
J94S2003 Seat Belt Warning Light/Beep
If the driver ’s seat belt is not fastened
when the ignition switch is turned to
the ON position, a beep will sound for
about 6 seconds and the seat belt
warning light will remain on until the
belt is fastened.

Form No. 8P95-EA-00G
*Some models.
Essential Safety Equipment
2-51

000–00?
 Constant Monitoring
The following components of the
supplement restraint systems are
monitored by a diagnostic system:
• SAS unit
• Air bag modules
• Side air bag crash sensors*
• Related wiring
A diagnostic module continuously
monitors the system’s readiness. This
begins when the ignition switch is
turned to the “ ON” position and
continues while the vehicle is being driven.
J94S2005

Supplemental restraint system
warning light
If the supplemental restraint system is
OK, the SRS warning light comes on
when the ignition switch is turned to
the ON position or after the engine is
cranked. After about 6 seconds it goes