2001 MAZDA MODEL 626 lights

Form No. 8P95-EA-00G
Protecting Your Mazda
4-7
WARNING
!
Snow Blocking the Exhaust Gas:Running the engine when a
vehicle is stopped in deep snow is
dangerous. The exhaust pipe
could be blocked by the snow,
allowing exhaust gas to enter the
cabin. Because exhaust gas
contains poisonous carbon
monoxide, anyone in the cabin
could be injured or killed. Clear
the snow from underneath and
around your vehicle before
starting the engine.
034-1AE
Before DrivingBefore Getting In
• Be sure the windows, outside
mirror(s), and outside lights are
clean.
• Inspect inflation pressures and
condition of tires.
• Look under the vehicle for any sign
of a leak.
• If you plan to back up, make sure
nothing will be in your way.
034-2AE
NOTEEngine oil, engine coolant,
brake/clutch fluid, washer fluid,
and other fluid levels should be
inspected daily, weekly, or at
refueling, depending on the fluid.
See Maintenance, Section 8.

Form No. 8P95-EA-00G
Protecting Your Mazda4-8
Q034-3BE
After Getting In
• Are all doors closed and locked?
• Are the inside and outside mirrors
adjusted?
• Is everyone’ s seat belt fastened?
• Do all the lights work?
• Check all gauges.
• Check all warning lights when the
ignition switch is turned to the ON
position. •
Release the parking brake and
make sure the brake warning light
goes off.
Always be thoroughly familiar with
your Mazda.

035-1AE
Break-In PeriodNo special break-in is necessary, but a
few precautions in the first 1,000 km
(600 miles) may add to the
performance, economy, and life of
your Mazda.
• Don’ t race the engine.
• Don’ t maintain one constant speed
for long periods.
• Avoid unnecessary hard stops.
• Avoid full-throttle starts.

Form No. 8P95-EA-00G
Driving Your MazdaOperating your vehicle requires a good understanding of the many controls you must know and use. Section 5
describes all this in step-by-step information from use of the ignition switch to cruise control and braking.
Also highlighted are the gearshift and shifting modes, power steering, instruments and gaug\
es, warnings and
indicators, windshield wipers, and interior features. You’ll find complete details about the advanced audio
system too.Ignition Switch Positions 5- 2Starting the Engine 5- 4
Manual Transaxle Operation 5- 7 Automatic Transaxle 5- 9
Traction Control System (TCS) 5- 16 Brake System 5- 19
Power Steering 5- 24 Cruise Control 5- 24
Instrument Cluster 5- 30 Gauges 5- 31
Dashboard Illumination 5- 35 Warning Lights/Beeps 5- 35
Lighting Control and Turn Signals 5- 44 Windshield Wipers and Washer 5- 47 Rear Window Defroster 5- 49 Clock 5- 51
Accessory Socket 5- 51 Glove Box 5- 55
Cup Holders 5- 56
Storage Compartments 5- 57 Sunvisors 5- 59
Vanity Mirrors 5- 60
Climate Control System 5- 60
Radio Reception 5- 75
Safety Certification 5- 80
AM/FM Radio with Compact Disc Player 5- 82 AM/FM Radio with Cassette Tape
and Compact Disc Player/Changer (In-Dash CD Changer) 5- 83 Antenna 5-123
5
5-1

Q041-1B1E

Form No. 8P95-EA-00G
Driving Your Mazda5-2

042-1CE
Ignition Switch PositionsWithout immobilizer
system
J94A4001A
 ON
This is the normal running position
after the engine is started. The warning
lights (except brakes) should be
inspected before the engine is started
(page 5-35).
With immobilizer
system
J94S5001
 START
The engine is started in this position. It
will crank until you release the key;
then it returns to the ON position. The
brake warning light can be checked
after the engine is started (page 5-35). 
ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
 LOCK
The steering wheel locks to protect
against theft. Only in this position can
the key be removed.

Form No. 8P95-EA-00G
*Some models.
Driving Your Mazda5-22

Q047-4AE
J94A4015
BRAKE
 Brake System Warning Light
If the brake warning light stays on
after the parking brake is fully
released, the brake system has a
malfunction. Refer to Warning
Lights/Beeps (page 5-36).
 Q047-5A2E
 Antilock Brake System (ABS)*
The ABS control unit continuously
monitors the speed of each wheel. If
one is about to lock up, the ABS
responds by automatically releasing
and reapplying that wheel’ s brake.
The driver will feel a slight vibration
in the brake pedal and may hear a
chattering noise from the brake
system. This is normal when the ABS
operates. Don’ t pump the brakes,
continue to press down on the brake
pedal.

Q047-7B2E
NOTEIf the ABS warning light stays on
while you’re driving, the ABS
control unit has detected a system
malfunction. If this occurs, your
brakes will function normally as if
the vehicle had no ABS. Should
this happen, consult an Authorized
Mazda Dealer as soon as possible.

Form No. 8P95-EA-00G
Driving Your Mazda5-30050-1AEInstrument Cluster
TachometerTurn signal indicator
Speedometer
Turn signal indicator
Odometer/Trip meter selector Fuel gauge
Water temperature gauge
Warning and indicator lights
Odometer and Trip meter
J94S5002
Warning and indicator lights

Form No. 8P95-EA-00G
Driving Your Mazda
5-35


052-1AE
Dashboard Illumination
Dim
Bright
J94A4028When the parking lights or headlights
are on, rotate the thumb wheel to
adjust the brightness of the dashboard
lights.
Q053-1CE
Warning Lights/Beeps
Warning Lights Inspection
Inspect the warning lights by turning
the ignition switch to the ON position
with the engine off and the parking
brake on. Consult an Authorized
Mazda Dealer about any light that
doesn’ t come on.
If the brake system warning light is off
when the ignition switch is in the
START position, have the system
inspected by an Authorized Mazda
Dealer.
After starting the engine, make sure all
warning lights are off. If one stays on,
it’ s signaling for attention. The brake system warning light should
go off when the parking brake is
released.

Form No. 8P95-EA-00G
Driving Your Mazda5-42If the light flashes rapidly, fails to
come on, or comes on and stays on, it
indicates a system malfunction. If any
of these occur, contact an Authorized
Mazda Dealer as soon as possible.
Security indicator light
When there is no key in the ignition,
and the theft-deterrent system has been
armed, the light will flash once every
three seconds. This indicates that the
system is working properly.
053-18F1E
 Ignition Key Reminder
If the ignition switch is in the LOCK
or ACC position, a beep will sound
when any door is opened.
053-19FE
 Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when any door is opened.
053-20A1E
 Headlight High-Beam
Indicator Light
This light indicates one of two things:
• The high-beam headlights are on.
• The turn-signal lever is in the
flash-to-pass position.
053-33AE
Rear Window Defroster
Indicator Light
This light comes on when the rear
window defroster is on.