2001 MAZDA MODEL 626 brakes

Form No. 8P95-EA-00G


Driving Your Mazda5-36

Q053-2GE
 Brake System Warning
Light
This warning has two functions.
 Parking brake warning
The light comes on when the parking
brake is applied with the ignition
switch in the START or ON position.
It goes off when the brake is fully
released.
 Low brake fluid level warning
If the light stays on after the parking
brake is fully released, you may have a
brake problem. If it stays on:
1. Be sure the parking brake is fully
released.
2. Check the light. If this light is still on, drive to the
side of the road and park off the
right-of-way.
You may notice that the pedal is
harder to push or that it may go
closer to the floor. In either case, it
will take longer to stop the vehicle.
3. With the engine stopped, check the brake fluid level immediately and
add fluid as required (page 8-25). 4. After adding fluid, check the light
again.
If the warning light remains on, or
if the brakes do not operate
properly, do not drive the vehicle.
Have it towed to an Authorized
Mazda Dealer.
Even if the light goes off, have
your brake system inspected as
soon as possible.

Form No. 8P95-EA-00G
Driving Your Mazda
5-37
WARNING
!
Brake Warning Light:Driving with the brake system
warning light on is dangerous. It
indicates that your brakes may
not work at all or that they could
completely fail at any time. If this
light remains on, have the brakes
inspected immediately. Don’t
drive with this light on.

053-4HE
 Seat Belt Warning
Light/Beep
If the driver ’s seat belt is not fastened
when the ignition switch is turned to
the ON position, a beep will sound for
about 6 seconds and the seat belt
warning light will remain on until the
belt is fastened.
If the system does not operate
correctly, consult an Authorized
Mazda Dealer.

053-5CE
 Charging System
Warning Light
This warning light indicates a
malfunction of the alternator or of the
charging system.
If the light comes on while driving:
1. Drive to the side of the road and park off the right-of-way.
2. Turn off the engine. Inspect the alternator drive belt for looseness
and breakage.

Form No. 8P95-EA-00G
*Some models.
Driving Your Mazda5-40If the check engine light flashes
continuously, decrease your speed and
consult an Authorizd Mazda Dealer as
soon as possible.

053-12CE
 Door-Ajar Warning
Light
This warning light comes on when any
door or trunk isn’ t securely closed.
Q053-15IE
Antilock Brake System
(ABS) Warning Light*
The warning light stays on for a few
seconds when the ignition switch is
turned to the ON position.
If the ABS warning light stays on
while you’re driving, the ABS control
unit has detected a system
malfunction. If this occurs, your
brakes will function normally as if the
vehicle had no ABS. Should this
happen, consult an Authorized Mazda
Dealer as soon as possible.
NOTEWhen the engine is jump-started to
charge the battery, uneven rpm
occurs and the ABS warning light
comes on. This is due to a weak
battery, not a malfunction.
Recharge the battery.

Form No. 8P95-EA-00G
Appearance Care7-8Pay special attention to removing salt,
dirt, mud, and other foreign material
from the underside of the wings, and
make sure the drain holes in the lower
edges of the doors and rocker panels
are clean.
Insects, tar, tree sap, bird droppings,
industrial fallout, and similar deposits
can damage the finish if not removed
immediately. When prompt washing
with plain water is ineffective, use a
mild soap made for use on vehicles.
Thoroughly rinse off all soap with
lukewarm or cold water. Don’t allow
soap to dry on the finish. After washing the vehicle, dry it with a
clean chamois to prevent water spots
from forming.
WARNING
!
Driving with Wet Brakes:Driving with wet brakes is
dangerous. Increased stopping
distance or the vehicle pulling to
one side when braking could
result in a serious accident. Light
braking will indicate whether the
brakes have been affected. Dry
the brakes by driving very slowly
and applying the brakes lightly
until brake performance is
normal.

Waxing
Your vehicle needs to be waxed when
water no longer beads on the finish.
Always wash and dry the vehicle
before waxing it. In addition to the
vehicle body, wax the metal trim to
maintain its luster.
1. Use wax which contains no abrasives. Waxes containing
abrasive will remove paint and
could damage bright metal parts.
2. Use a good grade of natural wax for metallic, mica, and solid colors.
3. When waxing, coat evenly with the sponge supplied or a soft cloth.

Form No. 8P95-EA-00G
Appearance Care7-10
078-5A1E

Underbody Maintenance
Road chemicals and salt used for ice
and snow removal and solvents used
for dust control may collect on the
underbody. If not removed, they will
speed up rusting and deterioration of
such underbody parts as fuel lines,
frame, floor pan, and exhaust system,
even though these parts may be coated
with anticorrosive material.
Thoroughly flush the underbody and
wheel housings with lukewarm or cold
water at the end of each winter. Try
also to do this every month.
Pay special attention to these areas
because they easily hide mud and dirt. It will do more harm than good to
wet down the road grime without
removing it.
The lower edges of doors, rocker
panels, and frame members have drain
holes that should not be clogged.
Water trapped there will cause rusting.
WARNING
!
Driving with Wet Brakes:Driving with wet brakes is
dangerous. Increased stopping
distance or the vehicle pulling to
one side when braking could
result in a serious accident. Light
braking will indicate whether the
brakes have been affected. Dry
the brakes by driving very slowly
and applying the brakes lightly
until brake performance is
normal.

Form No. 8P95-EA-00G
Maintenance
8-3


082-1AE
Scheduled MaintenanceFollow Schedule 1 if the vehicle is operated mainly where none of the followin\
g conditions applies.
If any of them apply, follow Schedule 2 (Puerto Rico residents follow Schedule 2).
• Repeated short-distance driving
• Driving in dusty conditions
• Driving with an extended use of brakes
• Driving in areas where salt or other corrosive materials are being used
• Driving on rough or muddy roads
• Extended periods of idling or low-speed operation
• Driving for a prolonged period in cold temperatures or extremely humid c\
limates

Form No. 8P95-EA-00G
I: Inspect and repair, clean, adjust, or replace if necessary
L : Lubricate
Maintenance8-6Schedule 1 (Cont ’d)
MAINTENANCE
INTERVALS
Number of months or miles (kilometers), whichever comes first
INTERVALS
Months
6
12
18
24
30
36
42
48
MAINTENANCE

1000 km
12
24
36
48
60
72
84
96
MAINTENANCE

ITEM
(
1000 miles)
(7.5)
(15)
(22.5)
(30)
(37.5)
(45)
(52.5)
(60)
Drum brakes
I
I
Disc brakes
I
I
Steering operation and linkages
I
I
Front suspension ball joints
I
I
Driveshaft dust boots
I
I
Bolts and nuts on chassis and body
I
I
Exhaust system heat shields
I
I
All locks and hinges
L
L
L
L
L
L
L
L
Air-conditioner refrigerant (if installed)
I
I
I
I
Air-conditioner compressor (if installed)
I
I
I
I

Form No. 8P95-EA-00G
I: Inspect and repair, clean, adjust, or replace if necessary
L : Lubricate
Maintenance
8-9
Schedule 2 (Cont ’d)
MAINTENANCE
INTERVALS
Number of months or miles (kilometers), whichever comes first
INTERVALS
Months
4
8
12
16
20
24
28
32
36
40
44
48
MAINTENANCE

1000 km
8
16
24
32
40
48
56
64
72
80
88
96
MAINTENANCE

ITEM
(
1000 miles)
(5)
(10)
(15)
(20)
(25)
(30)
(35)
(40)
(45)
(50)
(55)
(60)
Brake and clutch fluid level
I
I
I
I
I
I
I
I
I
I
I
I
Drum brakes
I
I
Disc brakes
I
I
I
I
Tire inflation pressure and tire wear
I
I
I
I
I
I
I
I
I
I
I
I
Steering operation and linkages
I
I
Power steering fluid level
I
I
I
I
I
I
I
I
I
I
I
I
Front suspension ball joints
I
I
Driveshaft dust boots
I
I
Bolts and nuts on chassis and body
I
I
I
I
Exhaust system heat shields
I
I
All locks and hinges
L
L
L
L
L
L
L
L
L
L
L
L