Page 83 of 301

COMFORT ADJUSTMENT
70
FRONT SEATS
(MANUAL TYPE)
Front seat precautions
CAUTION
The side airbags are installed in the driver and front
passenger seats.  Observe the following precautions.
 Do not lean over the front door when the vehicle is in
use.  The side airbag inflates with considerable speed
and force; you may be killed or severely injured.
 Do not modify or replace the seats or  the surface of
the seats with side airbags.  Such changes may
disable the system, or cause the side airbags to
inflate, resulting in death or serious injury.  Consult
your Lexus dealer.
 Do not use accessories for the seats which cover the
parts where the side airbags should inflate.  Such
accessories may prevent the side airbags from
activating correctly, causing death or serious injury.
Seat adjustment precautions
Adjust the driver's seat so that the foot pedals, steering wheel
and instrument panel controls are within easy reach of the
driver.
CAUTION
Do not adjust the seat while the vehicle is moving as
the seat may unexpectedly move and cause the
driver to lose control of the vehicle.
 Be careful not to hit the seat against a passenger,
luggage or the rear seat.
 After  adjusting the seat position, try sliding it forward
and backward to make sure it is locked in position.
 After adjusting the seatback, exert body pressure to
make sure it is locked in position.
 Do not put objects under the seats.  The objects may
interfere with the seat±lock mechanism or
unexpectedly push up the seat position adjusting
lever; the seat may suddenly move, causing the
driver to lose control of the vehicle.
 While  adjusting the seat, do not put your hands under
the seat or near the moving parts.  You may catch and
injure your hands of fingers. 
     
        
        Page 84 of 301
COMFORT ADJUSTMENT
71
Adjusting front seats
SS16001
 1Seat position lock release lever
 2Seat cushion front edge angle adjusting knob
 3Seat cushion height adjusting knob
 4Seatback angle lock release lever
Adjusting seat position
SS16003
Hold the center of the lever and pull it up.  Then slide the
seat to the desired position with slight body pressure and
release the lever. 
     
        
        Page 90 of 301
COMFORT ADJUSTMENT
77
SV16060
2. Pull the lever, lift the cover (b) up and fix it to the upper
part of the trunk using the magnet attached on the cover
(b).
Be sure to use ºLEXUS Genuine Sports Gear, Bagº for carrying
long objects (ski board, poles, etc.) properly.
For installation and handling of the ºLEXUS Genuine Sports
Gearº, follow the instructions provided with goods.
CAUTION
Be sure to close the cover (a) and (b) when the trunk
storage extension is not in use.  Goods in the luggage
compartment may be thrown into the passenger
compartment in a sudden stop or crash resulting in
injury.
HEAD RESTRAINTS
Front seats
SV16006
To raise the head restraint, pull it up.  To lower it, press the
lock  release button and push the head restraint down.  To
move the head restraint forward or rearward, pull or push
on the top.
The head restraint is most effective when it is close to your
head.  Therefore, using a cushion on the seatback is not
recommended. 
     
        
        Page 91 of 301
COMFORT ADJUSTMENT
78
CAUTION
Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
Rear seats
SV16007
Outside rear seats
SV16008
Center rear seat
To raise the head restraint, pull it up.  To lower it, press the
lock release button and push the head restraint down.
The head restraint is most effective when it is close to your
head.  Therefore, using a cushion on the seatback is not
recommended.
CAUTION
Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed. 
     
        
        Page 92 of 301

COMFORT ADJUSTMENT
79
TILT STEERING WHEEL
SV16064
To change the steering wheel angle, hold the steering
wheel, pull the lock release lever toward you, tilt the
steering wheel to the desired angle and release the lever.
When the steering wheel is in a low position, it will spring up as
you release the lock release lever.
CAUTION
 Do not adjust the steering wheel while the vehicle is
moving.  It may cause the driver to mishandle the
vehicle  and an accident may occur resulting in death
or injuries.
 After adjusting the steering wheel, try moving it up
and down to make sure it is locked in position.
OUTSIDE REAR VIEW MIRRORS
SV16010
Adjust  the mirror so that you can just see the side of your
vehicle in the mirror.
Be careful when judging the size or distance of any object seen
in the outside rear view mirror on the passenger's side.  It is a
convex mirror with a curved surface.  Any object seen in a
convex  mirror will lock smaller and farther away than if seen in
a normal flat mirror.
When the ignition switch is turned ºONº, the heater panels in
the outside rear view mirrors will quickly clear the surface.
The outside rear view mirror heater will operate while the
ignition switch is ºONº. 
     
        
        Page 95 of 301

COMFORT ADJUSTMENT
82Injured person.  Lexus recommends the use of a seat belt.
Depending on the injury, first check with your doctor for specific
recommendations.
CAUTION
Persons should ride in their seats properly wearing
their seat belts whenever the vehicle is moving.
Otherwise, they are much more likely to suffer serious
bodily injury or death in the event of sudden braking or
a collision.
When using the seat belts, observe the following:
Use the belt for only one person at a time.  Do not use
a single belt for two or more people ± even children.
 Avoid reclining the seatbacks too much.  The seat
belts provide maximum protection when the
seatbacks are in the upright position.  (See
ºAdjusting seatback angleº on page 72.)
 Be careful not to damage the belt webbing or
hardware.  Take care that they do not get caught or
pinched in the seat or doors.
 Inspect the belt system periodically.  Check for cuts,
fraying, and loose parts.  Damaged parts should be
replaced.  Do not disassemble or modify the system.
Keep the belts clean and dry.  If they need cleaning,
use a mild soap solution or lukewarm water.  Never
use bleach, dye, or abrasive cleaners ± they may
severely weaken the belts.  (See ºCleaning the
interiorº on page 282 for instructions.)
 Replace the belt assembly (including bolts) if it has
been used in a severe impact.  The entire assembly
should be replaced even if damage is not obvious.
Fastening front and rear seat belts
SV16013
Adjust  the seat as needed and sit up straight and well back
in the seat.  To fasten your belt, pull it out of the retractor
and insert the tab into the buckle.
You will hear a click when the tab locks into the buckle.
The seat belt length automatically adjusts to your size and the
seat position. 
     
        
        Page 96 of 301

COMFORT ADJUSTMENT
83
The retractor will lock the belt during a sudden stop or on
impact.  It also may lock if you lean forward too quickly.  A slow,
easy motion will allow the belt to extend, and you can move
around freely.
When a passenger's shoulder belt is completely extended and
is then retracted even slightly, the belt is locked in that position
and cannot be extended.  This feature is used to hold the child
restraint system securely.  
(For details, see ºChild restraintº on
page 102.)  To free the belt again, fully retract the belt and then
pull the belt out once more.
If the seat belt cannot be pulled out of the retractor, firmly pull
the belt and release it.  You will then be able to smoothly pull
the belt out of the retractor.
CAUTION
 After inserting the tab, make sure the tab and buckle
are locked and that the belt is not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally,
immediately contact your Lexus dealer.  Do not use
the seat until the seat belt is fixed.  It cannot protect
an adult occupant or your child from injury.
SV16014
Adjust the position of the lap and shoulder belts.
 1
Position  the lap belt as low as possible on your hips ± not
on your waist.
 2 Adjust it to a snug fit by pulling the shoulder portion
upward through the latch plate.
CAUTION
Both high±positioned lap belts and loose±fitting
belts could cause serious injuries due to sliding
under the lap belt during a collision or other
unintended result.  Keep the lap belt positioned as
low on hips as possible.
 For your safety, do not place the shoulder belt under
your arm. 
     
        
        Page 97 of 301
COMFORT ADJUSTMENT
84
SV16015
Adjust the shoulder anchor position to your size.
To raise the anchor position, push the anchor up.  To lower the
anchor position, support the anchor while you push the lock
release button then slide the anchor down.  After adjustment,
make sure the anchor is locked in position.
CAUTION
Always make sure the shoulder belt is positioned
across the center of your shoulder.  The belt should be
kept away from your neck, but not falling off your
shoulder.  Failure to do so could reduce the amount of
protection in an accident and cause severe injuries in a
collision.
SV16016
To release the belt, press the buckle release button and
allow the belt to retract.
If the belt does not retract smoothly, pull it out and check for
kinks or twists.  Then make sure it remains untwisted as it
retracts.