GENERAL OPERATION
²When the engine is not running, use the system sparingly otherwise it
will run the battery down.
²
When the ignition is turned to OFF, the Rear Seat Entertainment System
(RSES) is also turned OFF. When the ignition is turned ON, the RSES
returns to SINGLE PLAY mode and the last media position. To play a
video tape, toggle the MEDIA control on the RSEM to VCP mode.
²Do not leave the videocassette in the videocassette player (VCP)
overnight or for long periods of time.
²To listen through the vehicle's speaker system, press the speaker
button (
/) on the Rear Seat Entertainment Module (RSEM).
When the ignition is turned ON, audio is through the headphones at
LOW volume. Press the (+) control to increase volume.
²
To enable or disable the RSES, simultaneously press the 3 and 5 memory
presets on the radio face. When the RSEM controls are enabled,
will
appear in the radio display. Press the presets again to disable the RSES.
Inserting/removing cassette
Inserting cassette
²Open the center console cover. Insert a videocassette into the cassette
compartment.
Inserting a videocassette into the VCP automatically turns the power ON
and the tape should begin playback if the tape is an autoplay videocasette
tape (recording protection tabs are removed).
The tape counter is automatically reset to 0:00:00.
If the vehicle is traveling over rough terrain, it may be difficult to insert
the cassette because the machine attempts to hold the cassette firmly to
prevent vibration. If this condition is encountered, either press firmly or
Operating Instructions
14
