2001 FORD EXPLORER bulb

[x] Cancel search: bulb

Page 8 of 288

FORD EXPLORER 2001 2.G Owners Manual WARNING LIGHTS AND CHIMES
Check engine
Your vehicle is equipped with a
computer that monitors the engines
emission control system. This
system is commonly known as the
On Board Diagnostics System
(OB

Page 9 of 288

FORD EXPLORER 2001 2.G Owners Manual 3. The fuel cap may not have been properly installed and securely
tightened.
These temporary malfunctions can be corrected by filling the fuel tank
with high quality fuel of the recommended octane and

Page 11 of 288

FORD EXPLORER 2001 2.G Owners Manual Turn signal
Illuminates when the left or right
turn signal or the hazard lights are
turned on. If one or both of the
indicators stay on continuously or
flash faster, check for a burned-out
turn signal

Page 243 of 288

FORD EXPLORER 2001 2.G Owners Manual Please consult your ªWarranty Guideº for complete emission warranty
information.
Readiness for Inspection/Maintenance (I/M) testing
In some localities, it may be a legal requirement to pass an I/M t

Page 244 of 288

FORD EXPLORER 2001 2.G Owners Manual Replacing headlamp bulbs
To remove the headlamp bulb:
1. Make sure headlamp switch is in
OFF position, then lift hood and
open the hinged headlamp cover.
2. Disconnect the electrical
connector from th

Page 245 of 288

FORD EXPLORER 2001 2.G Owners Manual If the bulb is accidentally touched, it should be cleaned with rubbing
alcohol before being used.
1. With the flat side of the new bulbs plastic base facing upward, insert
the glass end of the bulb i

Page 246 of 288

FORD EXPLORER 2001 2.G Owners Manual Replacing tail lamp/turn/backup lamp bulbs
The tail lamp/turn/backup lamp bulbs are located in the tail lamp
assembly, one just below the other. Follow the same steps to replace
either bulb:
1. Open t

Page 247 of 288

FORD EXPLORER 2001 2.G Owners Manual 4. Install the bulb socket in lamp assembly turning it clockwise,
5. Install the lamp assembly on liftgate with two screws.
Replacing high-mount brake lamp bulbs
1. Remove the two screws and move
the
Page:   1-8 9-16 next >