39-120
Note:
Crossmember -1- does not have to be removed.
Installing
Installation is reverse of removal, noting the following:
Notes: - Remove securing bolts -B- and -C- of rear crossmember at rear final
drive.
- Lower final drive using transmission hoist.
Always replace self-locking nuts.Always clean any remaining locking fluid from thread for drive flange
on rear final drive after removing driveshaft. Otherwise there is a risk
that the bolts may become cross-threaded when installed and shear
when removed again. Cleaning can be performed with a tap.Always replace seal between drive flange and driveshaft (remove
protective film and attach seal to drive flange). Adhesive surface must
be free of grease. Replace driveshaft bolts (self-locking).
Pa
ge 4 of 7 Rear final drive, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.10
