Gauge
s
Maintenanc e Require d Indicato r
This indicator reminds you that it is time to take your car in forscheduled maintenance.
Refer to the Maintenance Schedules
for Normal and Severe Driving Conditions on pages 164 — 168 .
For the first 6,000 miles (9,600 km)
after the Maintenance Required
Indicator is reset, it will come on for
two seconds when you turn the ignition switch ON (II). Between 6,000 miles (9,600 km) and
7,500 miles (12,000 km) this
indicator will light for two seconds
when you first turn the ignition switch ON (II), and then flash for
ten seconds.
If you exceed 7,500 miles (12,000
km) without having the scheduled maintenance performed, this
indicator will remain on as a constant
reminder.
Your dealer will reset this indicatorafter completing the scheduled
maintenance. If this maintenance is done by someone other than your
Acura dealer, reset the indicator by pressing the reset button. This
button is located on the bottom of the dashboard to the right of thesteering column.
Instrument s an d Control s
MAIN
T
REQ D
Batter
y
Charging the battery with the cables
connected can seriously damage your
car's electronic controls. Detach the
battery cables before connecting the
battery to a charger.
If your car's battery is disconnected
or goes dead, the audio system willdisable itself. The next time you turn
on the radio you will see "Code" in
the frequency display. Use the Preset buttons to enter the five-digit
code (see page 119).
Maintenance
NOTIC
E
The battery gives off explosive hydrogen gas during normal
operation.
A spark or flame can cause the
battery to explode with enough
force to kill or seriously hurt you.
Wear protective clothing and a
face shield, or have a skilled mechanic do the battery
maintenance.
Light
s
Replacin g a High-moun t Brak e
Ligh t Bul b
LS model
1. Undo the cover fasteners by pushing on the center of each
fastener's head until it pops in. Remove the cover.
2. Determine which bulb is burned out. 3. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
4. Test the lights to make sure the new bulb is working. 5. Reset each fastener by pushing on
the pointed end until it pops backalmost flush with the fingers on
the housing.
6. Reinstall the cover. Secure each fastener by pushing on the centeruntil it locks (the center is flush
with the head).
Maintenance
