2001.5 Peugeot 106 Dag tyre pressure

P E U G E O T M A I N T E N A N C E13
Services Level
Operations Description of operations for 1st service
ABC
Intermediate visit
DRAIN AND REFILL- Engine drain and refill.- Fuel filter bleeding (Diesel). - Oil filter.- Fuel filter (Petrol).REPLACEMENT- Fuel filter element (Diesel).- Air filter element.- Spark plugs (Petrol).- Engine oil (check + top up).- Manual gearbox oil (check + top up).- Battery (check + top up) if plug is removable.LEVEL- Front/rear windscreen wash (check + top up).- Coolant (check + top up). - Brake fluid (check + top up). - Power steering fluid (check + top up according to specification). - Operation of lights and indicators. - Condition of glass, headlamp and light lenses and mirrors.- Horn.- Windscreen washer jets.- Condition of wiper blades.- Condition and tension of ancillary drive belts.- Handbrake.- Condition of hydraulic circuits (hoses and covers), check for leaks.CHECK- Condition of rubber boots and gaiters. - Brake pad wear. - Clearances, hubs, rods, ball joints, flexible mountings.- Sealing of dampers.- Wear of rear linings.- Condition and pressure of tyres (including spare wheel). - Emission control check according to current legislation (Petrol). - Smoke opacity (Diesel). - Pollen filter check (according to specification). - Visual check of the whole vehicle by a PEUGEOT dealer.
SERVICE- Courtesy vehicle
ROAD TEST
: All driving conditions : Arduous conditions
PEUGEOT SERVICING LEVELS A, B AND C
06-05-2002

P R A C T I C A L I N F O R M AT I O N8181
For your safety, always change a wheel:
Ð on level, solid, non-slippery ground,
Ð with the handbrake applied, Ð
with Þrst or reverse gear engaged,
Ð Chock the vehicle.
Ð Never position yourself under a vehicle which is supported only by a jack. Use a ramp.
After changing the wheel
Ð Have the wheel bolts and the tyre pressure checked as soon as possible.
Ð Have the damaged tyre repaired so that it can bereturned to the vehicle assoon as possible.
Ð The Òspace-savingÓ* type of spare wheel is Þtted with a
115/70R 15 tyre and is for
temporary use only.
- Pressure: 61 lbf. in 2
(4.2 bars).
- Maximum speed: 50 m.p.h. (80 km/h).
* According to speciÞcation
3
Special procedure for Sport model Positioning the jack
Ð Close the jack completely.
Ð Position the jack under the vehicle at the jacking points tilting it by 90¡, so that the jack handle hinge is at the same height as the sill trim, then straighten it.
Ð Check that the jack is in correct contact with the sill. Replacing the wheel in the carrier
Ð Position the jack storage box with the arrow pointing forwards.
Never place the jack in contact with the sill trim.
06-05-2002

P R A C T I C A L I N F O R M AT I O N93
To tow your 106 without lifting... A towing bar should always be used. From the front and rear:
Ð Attach the towing bar to thetowing eye.
Tow-bar This device must be Þtted by a
PEUGEOT dealer. Towing (boat, caravan, etc.)
¥ before setting out:
- check the pressure of thetyres, both on the vehicle and
on the trailer.
- check the electrical signals on the trailer.
- practice manoeuvring, in parti- cular reversing.
- grease the tow ball regularly, remove it when you have Þni-shed towing.
¥ In a caravan, distribute the load inside evenly and do not exceedthe maximum load.
¥ Always drive at a moderate speed, change gear early, bothgoing uphill and downhill. Payattention to side winds.
¥ When towing, fuel consumption increases. Do not forget to use a
roof deßector if necessary.
¥ Braking distance increases. Brake gradually and gently. Avoidjerky braking. Do not exceed your vehicleÕs
towing capacity.
Towing weight: see ÔTechnical dataÕ section. Recommended nose weight: 50 kg.
06-05-2002

T E C H N I C A L D ATA100
3
4
5
6A
CD
1 2
B
A. ManufacturerÕs plate 1 : EU legislation*
2 : Serial number
3 : Maximum gross vehicle weight (GVW)
4 : Maximum gross train weight (GTW)
5 : Maximum front axle load
6 : Maximum rear axle load
B. Serial number on body C. Legislation plate* D. Tyres and paint reference The label
DafÞxed to the edge of the driverÕs door indicates:
- the dimensions of the wheel rims and tyres,
- the brands of tyres approved by the manufacturer,
- the tyre inßation pressures (the inßation pressure must be
checked when cold, at least once a month) ,
- the paint colour reference. * According to speciÞcation
IdentiÞcation
06-05-2002