2000 YAMAHA YZF-R6 coolant reservoir

2-1
2
EAU00026
2-DESCRIPTIONLeft view1. Front fork compression damping force
adjusting screw (page 3-19)
2. Front fork rebound damping force
adjusting screw (page 3-18)
3. Front fork spring preload adjusting bolt (page 3-18)
4. Air filter (page 6-17)
5. Rear shock absorber compression
damping force adjusting screw (page 3-20)6. Rear shock absorber spring preload
adjusting ring (page 3-20)
7. Rear shock absorber rebound damping
force adjusting knob (page 3-20)
8. Shift pedal (page 3-11)
9. Coolant reservoir tank (page 6-13)
10. Engine oil filter (page 6-11)
E_5eb_Description.fm Page 1 Thursday, November 18, 1999 4:02 PM

4-1
4
EAU01114
4-PRE-OPERATION CHECKSOwners are personally responsible for their vehicle’s condition. Your motorcycle’s vital functions can start to deteriorate
quickly and unexpectedly, even if it remains unused (for instance, if it is exposed to the elements). Any damage, fluid leak or
loss of tire pressure could have serious consequences. Therefore, it is very important that, in addition to a thorough visual in-
spection, you check the following points before each ride.
EAU00340
PRE-OPERATION CHECK LIST
ITEM CHECKS PAGE
Front brake
• Check operation, free play, fluid level and fluid leakage.
• Fill with DOT 4 brake fluid if necessary.6-25 ~ 6-28
Rear brake6-25 ~ 6-28
Clutch• Check operation condition and free play.
• Adjust if necessary.6-25
Throttle grip and housing• Check for smooth operation.
• Lubricate if necessary.6-21, 6-30
Engine oil• Check oil level.
• Fill with oil if necessary.6-10 ~ 6-13
Coolant reservoir tank• Check coolant level.
• Fill with coolant if necessary.6-13 ~ 6-16
Drive chain• Check chain slack and condition.
• Adjust if necessary.6-28 ~ 6-29
Wheels and tires• Check tire pressure, wear and damage.6-21 ~ 6-24
6-37 ~ 6-40
Control cable• Check for smooth operation.
• Lubricate if necessary.6-30
Brake pedal shaft• Check for smooth operation.
• Lubricate if necessary.6-30
Brake and clutch lever
pivots• Check for smooth operation.
• Lubricate if necessary.6-31
E_5eb_Preop.fm Page 1 Thursday, November 18, 1999 4:05 PM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-13
610. Start the engine and warm it up for
several minutes. While warming
up, check for oil leakage. If oil
leakage is found, stop the engine
immediately and check for the
cause.
11. After the engine is started, the oil
level indicator light should go off if
the oil is at the specified level.
EC000067
CAUTION:@ If the indicator light flickers or re-
mains on, immediately stop the en-
gine and consult with a Yamaha
dealer. @12. Install the cowling.
EAU01611
Cooling system1. Check the coolant level in the res-
ervoir tank when the engine is cold
as the coolant level will vary with
engine temperature. The coolant
level should be between the maxi-
mum and minimum marks.2. If the level is low, remove the res-
ervoir tank cover by removing the
bolts.
3. Add coolant or distilled water to
raise it to the specified level.
4. Install the reservoir tank cover and
bolts.1. Maximum level mark
2. Minimum level mark
1. Bolt (´ 2)
Reservoir tank capacity:
0.44 L
E_5eb_Periodic.fm Page 13 Thursday, November 18, 1999 4:06 PM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-15
67. Connect the radiator hose and
tighten the clamp.
8. Retighten the drain bolt to the
specified torque. If the gasket is
damaged, replace it.
9. Remove the reservoir tank cover
by removing the bolts.10. Remove the reservoir tank by re-
moving the bolts.
11. Remove the reservoir tank cap
and turn the tank upside down to
empty it.
12. Install the reservoir tank.
13. Fill the reservoir tank with coolant
up to the maximum level, then in-
stall the cap and cover.
14. Pour the recommended coolant
into the radiator until it is full. Tightening torque:
Drain bolt:
12 Nm (1.2 m·kg)
1. Bolt (´ 2)
1. Bolt (´ 2)
E_5eb_Periodic.fm Page 15 Thursday, November 18, 1999 4:06 PM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-16
6
EC000080
CAUTION:@ Hard water or salt water is harmful
to the engine. You may use distilled
water if you can’t get soft water. @15. Install the radiator cap.
16. Run the engine several minutes to
recheck the coolant level in the ra-
diator. If it is low, fill with more
coolant until it reaches the top of
the radiator.17. Check for coolant leakage.
NOTE:@ If you find any leaks, ask a Yamaha
dealer to inspect. @18. Install the panel and the cowling. Recommended anti-freeze:
High quality ethylene glycol
anti-freeze containing corrosion
inhibitors for aluminum engines.
Antifreeze and water mix ratio:
1:1
Total amount:
2.15 L
Reservoir tank capacity:
0.44 L
E_5eb_Periodic.fm Page 16 Thursday, November 18, 1999 4:06 PM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-42
6
5. Engine overheating
EW000070
WARNING
@ Do not remove the radiator cap when the engine and radiator are hot. Scalding hot fluid and steam may be blown
out under pressure, which could cause serious injury. Open the radiator cap as follows. Wait until the engine has
cooled. Remove the radiator cap stopper by removing the screw. Place a thick rag like a towel over the radiator cap
and slowly rotate the cap counterclockwise to the detent. This procedure allows any residual pressure to escape.
When the hissing sound has stopped, press down on the cap while turning counterclockwise and remove it. @NOTE:@ If it is difficult to get the recommended coolant, tap water can be temporarily used, provided that it is changed to the recom-
mended coolant as soon as possible. @
Wait until the
engine has cooled.
Check the coolant level in the
reservoir tank and/or radiator.
Level is OK.Level is low, check the
cooling system for leakage.
No
leakage.Leakage.
Ask a Yamaha dealer to inspect
and repair the cooling system.Add coolant. (See NOTE.)
Restart the engine. If the engine overheats again, ask a
Yamaha dealer to inspect and repair the cooling system.
E_5eb_Periodic.fm Page 42 Thursday, November 18, 1999 4:06 PM