2000 YAMAHA XVZ1300A fuel

PERIODIC MAINTENANCE AND MINOR REPAIR
6-29
6
EAU02990*
Troubleshooting chart
EW000125
WARNING
@ Never check the fuel system while smoking or in the vicinity of an open flame. @
Check if there is fuel
in the fuel tank.1. Fuel
Enough fuel.
No fuel.
Go to compression check.
Supply fuel.
Engine doesn’t start, go to compression check.
Use the electric starter.2. Compression
There is compression.
No compression.
Go to ignition check.
Ask a Yamaha dealer to
inspect.
Remove spark
plugs and
check electrodes.3. Ignition
Wet.
Dry.
Wipe clean with dry cloth and correct
spark gap or replace spark plugs.
Ask a Yamaha dealer to inspect.
Engine doesn’t start, ask a Yamaha
dealer to inspect.Engine doesn’t start, go to battery
check.Open throttle half-way and start
the engine.
Use the electric starter.4. Battery
Engine turns over
quickly.
Engine turns over
slowly.
Battery good.Check connections or
recharge.
E_4YP_Periodic.fm Page 29 Wednesday, October 6, 1999 10:05 AM

MOTORCYCLE CARE AND STORAGE
7-2
7
ECA00010
CAUTION:@ l
Avoid using strong acidic wheel
cleaners, especially on spoked
wheels. If you do use such
products for hard-to-remove
dirt, do not leave it on any long-
er than instructed, then thor-
oughly rinse it off with water,
immediately dry the area and
apply a corrosion protection
spray.
l
Improper cleaning can damage
windshields, cowlings, panels
and other plastic parts. Use
only a soft, clean cloth or
sponge with mild detergent and
water to clean plastic.
l
Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
sponges which have been in
contact with strong or abrasive
cleaning products, solvent or
thinner, fuel (gasoline), rust re-
movers or inhibitors, brake flu-
id, antifreeze or electrolyte.
l
Do not use high-pressure wash-
ers or steam-jet cleaners since
they cause water seepage and
deterioration in the following ar-
eas: seals (of wheel bearings,
swingarm bearings, forks and
brakes), electric components
(couplers, connectors, instru-
ments, switches and lights),
breather hoses and vents.
l
For motorcycles equipped with
a windshield: Do not use strong
cleaners or hard sponges as
they will cause dulling or
scratching. Some cleaning
compounds for plastic may
leave scratches on the wind-
shield. Test the product on a
small hidden part of the wind-
shield to make sure they do not
leave any marks. If the wind-
shield is scratched, use a quali-
ty plastic polishing compound
after washing.
@After riding in the rain, near the sea oron salt-sprayed roadsSince sea salt or salt sprayed on the
roads in the winter are extremely corro-
sive in combination with water, carry
out the following steps after each ride
in the rain, near the sea or on salt-
sprayed roads. (Salt sprayed in the
winter may remain on the roads well
into spring.)
E_4YP_Cleaning.fm Page 2 Wednesday, October 6, 1999 10:06 AM

MOTORCYCLE CARE AND STORAGE
7-4
7
ECA00013
CAUTION:@ l
Apply spray oil and wax spar-
ingly and wipe off any excess.
l
Never apply oil or wax on rub-
ber and plastic parts, but treat
them with a suitable care prod-
uct.
l
Avoid using abrasive polishing
compounds as they wear away
the paint.
@NOTE:@ Consult a Yamaha dealer for advice on
what products to use. @
StorageShort-term
Always store your motorcycle in a cool,
dry place and, if necessary, protect it
against dust with a porous cover.
ECA00014
CAUTION:@ l
Storing the motorcycle in a
poorly ventilated room or cover-
ing it with a tarp while it is still
wet will allow water and humidi-
ty to seep in and cause rust.
l
To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chemi-
cals are stored.
@
Long-term
Before storing your motorcycle for
several months:
1. Follow all the instructions in the
“Care” section of this chapter.
2. Drain the carburetor float cham-
bers by loosening the drain bolts;
this will prevent fuel deposits from
building up. Pour the drained fuel
into the fuel tank.
3. Only for motorcycles equipped
with a fuel cock which has an
“OFF” position: Turn the fuel cock
to “OFF”.
4. Fill up the fuel tank and add fuel
stabilizer (if available) to prevent
the fuel tank from rusting and the
fuel from deteriorating.
5. Perform the following steps to pro-
tect the cylinders, piston rings, etc.
from corrosion.
E_4YP_Cleaning.fm Page 4 Wednesday, October 6, 1999 10:06 AM

8-1
8
EAU01038
8-SPECIFICATIONSSpecifications
Model XVZ1300A
Dimensions
Overall length 2,480 mm
Overall width 950 mm
Overall height 1,160 mm
Seat height 715 mm
Wheelbase 1,695 mm
Ground clearance 150 mm
Minimum turning radius 3,400 mm
Basic weight (with oil and full
fuel tank)
330 kg
Engine
Engine type Liquid cooled 4-stroke, DOHC
Cylinder arrangement V type 4-cylinder
Displacement 1,294 cm
3
Bore ´ stroke 79 ´ 66 mm
Compression ratio 10:1
Starting system Electric starter
Lubrication system Wet sumpEngine oil
Ty p e
Recommended engine oil
classification API Service SE, SF, SG type or
higher
Quantity
Periodic oil change 3.5 L
With oil filter replacement 3.7 L
Total amount 4.3 L
-20˚ -10˚ 0˚
10˚20˚ 30˚
40˚50˚C
SAE 10W/30
SAE 15W/40SAE 20W/40SAE 20W/50
SAE 10W/40
CAUTION:Be sure to use motor oils that do not contain anti-friction
modifiers. Passenger car motor oils (often labeled
“Energy Conserving”) contain anti-friction additives which
will cause clutch and/or starter clutch slippage, resulting in
reduced component life and poor engine performance.
E_4YP_Spec.fm Page 1 Wednesday, October 6, 1999 10:06 AM

SPECIFICATIONS
8-2
8
Final gear oil
Type SAE80API “GL-4” Hypoid Gear
Oil
Quantity 0.2 L
Radiator
capacity (including all routes) 2.9 L
Air filterDry type element
Fuel
Type Regular unleaded gasoline
Fuel tank capacity 18 L
Reserve amount 3.5 L
Carburetor
Type ´ quantity BDS28 ´ 4
Manufacturer MIKUNI
Spark plug
Manufacturer/Type NGK / DPR7EA-9 or
DENSO / X22EPR-U9
Gap 0.8 ~ 0.9 mm
Clutch typeWet, multiple-disc
Transmission
Primary reduction system Spur gear
Primary reduction ratio 1.667
Secondary reduction system Shaft drive
Secondary reduction ratio 2.567Transmission type Constant mesh 5-speed
Operation Left foot operation
Gear ratio
1st 2.438
2nd 1.579
3rd 1.160
4th 0.906
5th 0.750
Chassis
Frame type Double cradle
Caster angle 30°
Trail 126 mm
Tires
Front
Type Tubeless
Size 150/80-16 71H
Manufacturer /
modelDunlop / D404F
Rear
Type Tubeless
Size 150/90B15M/C 74H
Manufacturer /
modelDunlop / D404
E_4YP_Spec.fm Page 2 Wednesday, October 6, 1999 10:06 AM

SPECIFICATIONS
8-4
8
Headlight typeQuar tz bulb (halogen)
Bulb voltage, wattage ´ quantity
Headlight 12 V, 60/55 W ´ 1
Auxiliary light 12 V, 4 W ´ 1
Tail/brake light 12 V, 5/21 W ´ 1
Turn signal lights 12 V, 21 W ´ 4
Meter light 14 V, 1.4 W ´ 2
Neutral indicator light 12 V, 1.7 W ´ 1
High beam indicator light 12 V, 1.7 W ´ 1
Oil level indicator light 12 V, 1.7 W ´ 1
Turn indicator light 12 V, 1.7 W ´ 1
Fuel level indicator light 14 V, 3 W ´ 1
Engine overheat indicator light 12 V, 1.7 W ´ 1
Overdrive / Engine trouble
indicator light 12 V, 1.7 W ´ 1
Fuses
Main fuse 30 A
Ignition fuse 10 A
Signaling system fuse 20 A
Headlight fuse 20 A
Fan fuse 10 A
Odometer fuse 5 A
E_4YP_Spec.fm Page 4 Wednesday, October 6, 1999 10:06 AM

10-INDEXAAdjusting front fork preload .................... 3-12
Adjusting rear shock absorber
preload ................................................ 3-13
Antitheft alarm (optional) ..........................3-3BBattery ................................................... 6-23
Brake and clutch lever lubrication........... 6-22
Brake and shift pedal lubrication ............ 6-21
Brake fluid replacement ......................... 6-21
Brake light switch adjustment ................. 6-18CCarburetor adjustment ........................... 6-11
Care.........................................................7-1
Checking the front and
rear brake pads ................................... 6-19
Clutch lever ..............................................3-5
Clutch lever free play adjustment ........... 6-16
Controls/Instruments ................................2-3
Coolant .................................................. 6-10DDimmer switch .........................................3-4EEngine break-in........................................5-5
Engine oil .................................................6-7
Engine overheat indicator light .................3-2
Engine stop switch ...................................3-5FFinal gear oil .......................................... 6-10
Front brake lever ......................................3-6
Front brake lever free play
adjustment .......................................... 6-17
Front fork inspection .............................. 6-23
Fuel ......................................................... 3-7
Fuel cock ................................................. 3-8
Fuel level indicator light ........................... 3-1
Fuel tank cap ........................................... 3-7
Fuse replacement.................................. 6-25GGive safety the right of way ..................... 1-1HHandlebar switches ................................. 3-4
Dimmer switch ................................... 3-4
Engine stop switch ............................. 3-5
Horn switch ........................................ 3-4
Lights switch ...................................... 3-5
Pass switch ........................................ 3-4
Start switch ........................................ 3-5
Turn signal switch .............................. 3-4
Headlight bulb replacement ................... 6-27
Helmet holders ...................................... 3-11
High beam indicator light ......................... 3-1
Horn switch ............................................. 3-4IIdentification number records................... 9-1
Idle speed adjustment ........................... 6-11
Indicator lights ......................................... 3-1
Engine overheat indicator light ........... 3-2
Fuel level indicator light ...................... 3-1
High beam indicator light .................... 3-1
Neutral indicator light.......................... 3-1
Oil level indicator light .........................3-2
Overdrive / Engine trouble
indicator light....................................3-2
Turn indicator light ..............................3-2
Inspecting the brake fluid level ...............6-19
KKey identification number .........................9-1LLeft view...................................................2-1
Lights switch ............................................3-5MMain switch ..............................................3-1
Model label ..............................................9-2NNeutral indicator light ...............................3-1OOil level indicator light ..............................3-2
Overdrive / Engine trouble indicator
light ........................................................3-2PParking.....................................................5-6
Pass switch ..............................................3-4
Periodic maintenance and lubrication .......6-3
Pre-operation check list ............................4-1RRear brake pedal .....................................3-6
Rear brake pedal height adjustment.......6-17
Rider seat ..............................................3-10
Right view ................................................2-2
E_4YPIX.fm Page 1 Wednesday, October 6, 1999 10:07 AM

INDEX
SShifting .................................................... 5-3
Shift pedal ............................................... 3-6
Sidestand .............................................. 3-15
Sidestand/clutch switch operation
check .................................................. 3-15
Sidestand lubrication ............................. 6-22
Spark plugs ............................................. 6-6
Specifications .......................................... 8-1
Speedometer ........................................... 3-3
Starter (choke) knob ................................ 3-9
Starting a warm engine ............................ 5-3
Starting the engine .................................. 5-1
Start switch .............................................. 3-5
Steering lock............................................ 3-9
Storage.................................................... 7-4TThrottle cable free play inspection ......... 6-12
Tips for reducing fuel consumption .......... 5-4
Tires ...................................................... 6-13
Tool kit..................................................... 6-1
Troubleshooting..................................... 6-28
Troubleshooting chart ............................ 6-29
Turn indicator light ................................... 3-2
Turn signal and taillight bulb
replacement ........................................ 6-28
Turn signal switch .................................... 3-4
VValve clearance adjustment .................. 6-12
Vehicle identification number................... 9-1WWheels .................................................. 6-15
E_4YPIX.fm Page 2 Wednesday, October 6, 1999 10:07 AM