Page 55 of 101

6-9
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
NOTE:
If a torque wrench is not available
when you are installing a spark plug, a
good estimate of the correct torque is
1/4 to 1/2 turn past finger tight. Have
the spark plug tightened to the speci-
fied torque as soon as possible.Tightening torque:
Spark plug:
20 Nm (2.0 m·kg)
1. Maximum level mark
2. Minimum level mark
EAU01326*
Engine oil
Oil level inspection
1. Place the motorcycle on a level
place and hold it in an upright po-
sition. Warm up the engine for
several minutes.
NOTE:
Be sure the motorcycle is positioned
straight up when checking the oil level.
A slight tilt toward the side can result in
false readings.
1. Engine oil drain bolt
2. With the engine stopped, check
the oil level through the level win-
dow located at the lower part of
the left side crankcase cover.
NOTE:
Wait a few minutes until the oil level
settles before checking.
3. The oil level should be between
the maximum and minimum
marks. If the level is low, fill the
engine with sufficient oil to the
specified level.
Page 57 of 101

6-11
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1. O-ring
2. Oil filter element
EC000066
CAUTION:
l
Do not put in any chemical ad-
ditives. Engine oil also lubri-
cates the clutch and additives
could cause clutch slippage.
l
Be sure no foreign material en-
ters the crankcase.
10. Start the engine and warm it up
for a few minutes. While warming
up, check for oil leakage. If oil
leakage is found, stop the engine
immediately and check for the
cause.
1. Final gear oil drain bolt
2. Final gear oil filler bolt
3. Proper level
EAU02943*
Final gear oil
EW000066
WARNING
Do not let foreign material enter the
final gear case. Be sure oil does not
get on the tire or wheel.
Oil level inspection
1. Place the motorcycle on a level
place and hold it in an upright po-
sition. The engine should be cool
at ambient temperature.2. Remove the oil filler bolt and
check the oil level. The oil level
should be at the brim of the filler
hole. Add the recommended oil if
necessary.
Oil replacement
1. Place an oil pan under the final
gear case.
2. Remove the oil filler bolt and drain
bolt to drain the oil.
3. Install and tighten the drain bolt to
the specified torque.
4. Fill the gear case to the brim of the
filler hole with the recommended
oil. Tightening torque:
Drain bolt:
23 Nm (2.3 m·kg)
Page 61 of 101
6-15
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
a. Free play
EAU00635
Throttle cable free play
inspectionThere should be a free play of 4 ~
6 mm at the throttle grip. If the free play
is incorrect, ask a Yamaha dealer to
make this adjustment.
EAU00637
Valve clearance adjustmentThe correct valve clearance changes
with use, resulting in improper fuel/air
supply or engine noise. To prevent
this, the valve clearance must be ad-
justed regularly. This adjustment how-
ever, should be left to a professional
Yamaha service technician.
a. Tread depth
1. Side wall
EAU00647*
TiresTo ensure maximum performance,
long service, and safe operation, note
the following:
Tire air pressure
Always check and adjust the tire pres-
sure before operating the motorcycle.
Page 70 of 101
6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU02985
Brake and clutch lever
lubricationLubricate the pivoting parts.
Recommended lubricant:
Engine oil
EAU02986
Sidestand lubricationLubricate the sidestand pivoting point
and metal-to-metal contact surfaces.
Check that the sidestand moves up
and down smoothly.
EW000113
WARNING
If the sidestand does not movesmoothly, consult a Yamaha dealer.Recommended lubricant:
Engine oil
Page 71 of 101

6-25
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU02939
Front fork inspectionVisual check
EW000115
WARNING
Securely support the motorcycle sothere is no danger of it falling over.
Check for scratches or damage on the
inner tube and excessive oil leakage
from the front fork.
Operation check
1. Place the motorcycle on a level
place.
2. Hold the motorcycle in an upright
position and apply the front brake.
3. Push down hard on the handle-
bars several times and check if
the fork rebounds smoothly.
EC000098
CAUTION:
If any damage or unsmooth move-
ment is found with the front fork,consult a Yamaha dealer.
EAU00794
Steering inspectionPeriodically inspect the condition of
the steering. Worn out or loose steer-
ing bearings may be dangerous. Place
a stand under the engine to raise the
front wheel off the ground. Hold the
lower end of the front forks and try to
move them forward and backward. If
any free play can be felt, ask a
Yamaha dealer to inspect and adjust
the steering. Inspection is easier if the
front wheel is removed.
EW000115
WARNING
Securely support the motorcycle sothere is no danger of it falling over.
Page 76 of 101

6-30
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
XVS650A1. Screw (´ 3)
EC000108
CAUTION:
Do not over-tighten the screws asthe lens may break.
EAU01579
Supporting the motorcycleSince the Yamaha XVS650/XVS650A
has no centerstand, follow these pre-
cautions when removing the front and
rear wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motor-
cycle is in a stable and level position
before starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
Front wheel service
To stabilize the rear of the motorcycle,
either use a motorcycle stand or place
a motorcycle jack under the frame in
front of the rear wheel to prevent it
from moving from side to side. Then
use a motorcycle stand to elevate the
front wheel off of the ground.
Rear wheel service
Use a motorcycle stand or motorcycle
jack to elevate the motorcycle so the
rear wheel is off the ground. Alterna-
tively, two jacks can be placed under
the frame or swingarm.
Page 81 of 101
6-35
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU01297*
Troubleshooting chart
EW000125
WARNING
Never check the fuel system while smoking or in the vicinity of an open flame.
Check if there is fuel
in the fuel tank.1. Fuel
Enough fuel.
No fuel.
Go to compression check.
Supply fuel.
Engine doesn’t start, go to compression check.
Use the electric starter.2. Compression
There is compression.
No compression.
Go to ignition check.
Ask a Yamaha dealer to
inspect.
Remove spark
plugs and
check electrodes.3. Ignition
Wet.
Dry.
Wipe clean with dry cloth and correct
spark gap or replace spark plugs.
Ask a Yamaha dealer to inspect.
Engine doesn’t start, ask a Yamaha
dealer to inspect.Engine doesn’t start, go to battery
check.Open throttle half-way and start
the engine.
Use the electric starter.4. Battery
Engine turns over
quickly.
Engine turns over
slowly.
Battery good.Check connections or
recharge.
Page 99 of 101

INDEX
A
Air filter ....................................................6-12
Antitheft alarm (optional) ..........................3-3
B
Battery ....................................................6-26
Brake and clutch lever lubrication ..........6-24
Brake and shift pedal lubrication ............6-23
Brake fluid replacement ..........................6-22
Brake light switch adjustment .................6-21
C
Cable inspection and lubrication ............6-23
Carburetor adjustment ............................6-13
Care ..........................................................7-1
Checking the front brake pads and
rear brake shoes ..................................6-21
Clutch lever ...............................................3-5
Clutch lever free play adjustment ...........6-18
Controls/Instruments
(XVS650/XVS650A) ..............................2-5
D
Dimmer switch ..........................................3-3
E
Engine break-in ........................................5-5
Engine oil ..................................................6-9
Engine stop switch ...................................3-4
Engine trouble indicator light ....................3-2
F
Final gear oil ...........................................6-11
Front brake lever ......................................3-5
Front brake lever free play
adjustment ...........................................6-19
Front fork inspection ...............................6-25
Front wheel installation ...........................6-31
Front wheel removal ...............................6-31
Fuel ...........................................................3-7
Fuel cock ..................................................3-8
Fuel tank breather hose ...........................3-7
Fuel tank cap ............................................3-6
Fuse replacement ...................................6-27
G
Give safety the right of way ......................1-1
H
Handlebar switches ..................................3-3
Dimmer switch ....................................3-3
Engine stop switch ..............................3-4
Horn switch .........................................3-3
Lights switch .......................................3-4
Pass switch .........................................3-3
Start switch .........................................3-4
Turn signal switch ...............................3-3
Headlight bulb replacement ...................6-28
Helmet holder .........................................3-12
High beam indicator light ..........................3-2
Horn switch ...............................................3-3
I
Identification number records ...................9-1
Idle speed adjustment ............................6-14
Indicator lights ..........................................3-2
Engine trouble indicator light ..............3-2
High beam indicator light ....................3-2
Neutral indicator light ..........................3-2
Turn indicator light ..............................3-2
Inspecting the brake fluid level ...............6-22
K
Key identification number .........................9-1
L
Left view (XVS650) ...................................2-1
Left view (XVS650A) ................................2-3
Lights switch .............................................3-4
Luggage strap holders ............................3-15
M
Main switch/Steering lock .........................3-1
Model label ...............................................9-2
N
Neutral indicator light ................................3-2
P
Panel A .....................................................6-6
Panel B .....................................................6-7
Panel removal and installation .................6-5
Parking ......................................................5-6