2000 YAMAHA XVS125 key

5-5
OPERATION AND IMPORTANT RIDING POINTS
1
2
3
4
5
6
7
8
9
EAU03183
0–1,000 km
Avoid prolonged operation above 1/3
throttle.
1,000–1,600 km
Avoid prolonged operation above 1/2
throttle.
ECA00058
cC
After 1,000 km of operation, the
engine oil must be changed and
the oil filter element replaced.
1,600 km and beyond
The vehicle can now be operated
normally.
EC000049
cC
If any engine trouble should occur
during the engine break-in period,
immediately have a Yamaha dealer
check the vehicle.
EAU00460
Parking
When parking, stop the engine, and
then remove the key from the main
switch.
EW000058
w
8Since the engine and exhaust
system can become very hot,
park in a place where pedestri-
ans or children are not likely
to touch them.
8Do not park on a slope or on
soft ground, otherwise the
motorcycle may overturn.
5JX-9-E0 4/9/0 4:11 AM Page 28

PERIODIC MAINTENANCE AND MINOR REPAIR
6
6-5
1
EAU01122
Removing and installing pan-
els
The panels shown above need to be
removed to perform some of the
maintenance jobs described in this
chapter. Refer to this section each
time a panel needs to be removed
and installed.
1. Panel A
1
1. Panel B
21
EAU03184
Panel A
To remove the panel
1. Slide the lock cover open, insert
the key into the lock, and then
turn it 1/4 turn clockwise.
1. Lock cover
2. Unlock
5JX-9-E0 4/9/0 4:11 AM Page 33

PERIODIC MAINTENANCE AND MINOR REPAIR
6
6-6
1
2. Pull the rear of the panel out with
the key inserted in the lock, and
then slide the panel forward to
release it in the front.To install the panel
1. Secure the front of the panel,
and then push the rear of the
panel in with the key inserted in
the lock.
2. Turn the key counterclockwise to
the original position, remove it,
and then close the lock cover.
EAU03185
Panel B
To remove the panel
1. Remove the bolt.
1. Bolt
5JX-9-E0 4/9/0 4:11 AM Page 34

1
2
3
4
5
6
7
8
9
6-33
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU01749
Replacing the fuses
The fuse boxes are located behind
panel B. (See page 6-6 for panel
removal and installation procedures.)
If a fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn
off the electrical circuit in ques-
tion.
1. Fuse box (´2)
11
2. Remove the blown fuse, and
then install a new fuse of the
specified amperage.
1. Main fuse
2. Spare fuse
3. Headlight fuse
4. Ignition fuse
5. Signaling system fuse
6. Carburetor heater fuse
7. Spare fuse (´2)
73564
21
Specified fuses:
Main fuse: 30 A
Ignition fuse: 10 A
Signaling system fuse: 10 A
Headlight fuse: 15 A
Carburetor heater fuse: 10 A
EC000103
cC
Do not use a fuse of a higher
amperage rating than recommend-
ed to avoid causing extensive
damage to the electrical system
and possibly a fire.
3. Turn the key to “ON” and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
5JX-9-E0 4/9/0 4:11 AM Page 61

EAU01039
CONSUMER INFORMATION
9-1
8
9
EAU02944
Identification numbers
Record the key identification number,
vehicle identification number and
model label information in the spaces
provided below for assistance when
ordering spare parts from a Yamaha
dealer or for reference in case the
vehicle is stolen.
1. KEY IDENTIFICATION
NUMBER:
2. VEHICLE IDENTIFICATION
NUMBER:
3. MODEL LABEL INFORMATION:
EAU01041
Key identification number
The key identification number is
stamped into the key tag.
Record this number in the space pro-
vided and use it for reference when
ordering a new key.
1. Key identification number
EAU01043
Vehicle identification number
The vehicle identification number is
stamped into the steering head pipe.
Record this number in the space pro-
vided.
NOTE:
The vehicle identification number is
used to identify your motorcycle and
may be used to register your motor-
cycle with the licensing authority in
your area.
1. Vehicle identification number
1
1
1
6
5JX-9-E0 4/9/0 4:11 AM Page 81