2000 YAMAHA XV125S fuel

1
2
3
4
5
6
7
8
9
MOTORCYCLE CARE AND STORAGE
7-4
Storage
Short-term
Always store your motorcycle in a
cool, dry place and, if necessary,
protect it against dust with a
porous cover.
ECA00014
cC
8Storing the motorcycle in a
poorly ventilated room or cov-
ering it with a tarp while it is
still wet will allow water and
humidity to seep in and cause
rust.
8To prevent corrosion, avoid
damp cellars, stables (because
of the presence of ammonia)
and areas where strong chem-
icals are stored.
Long-term
Before storing your motorcycle for
several months:
1. Follow all the instructions in
the “Care” section of this
chapter.
2. Drain the carburetor float
chambers by loosening the
drain bolts; this will prevent
fuel deposits from building up.
Pour the drained fuel into the
fuel tank.
3. Only for motorcycles equipped
with a fuel cock which has an
“OFF” position: Turn the fuel
cock to “OFF”.
4. Fill up the fuel tank and add
fuel stabilizer (if available) to
prevent the fuel tank from rust-
ing and the fuel from deterio-
rating.
5. Perform the following steps to
protect the cylinders, piston
rings, etc. from corrosion.
a. Remove the spark plug caps
and spark plugs.
b. Pour a teaspoonful of engine
oil into each spark plug bore.c. Install the spark plug caps onto
the spark plugs and place the
spark plugs on the cylinder
head so that the electrodes are
grounded. (This will limit
sparking during the next step.)
d. Turn the engine over several
times with the starter. (This
will coat the cylinder walls
with oil.)
e. Remove the spark plug caps
from the spark plugs, install
the spark plugs and then the
spark plug caps.
EWA00003
w
When turning the engine over, be
sure to ground the spark plug elec-
trodes to prevent damage or injury
from sparking.
6. Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 76

1
2
3
4
5
6
7
8
9
EAU01038
SPECIFICATIONS
Specifications
Model XV125S
Dimensions
Overall length 2,190 mm
Overall width 805 mm
Overall height 1,140 mm
Seat height 685 mm
Wheel base 1,495 mm
Ground clearance 145 mm
Minimum turning radius 2,800 mm
Basic weight (with oil and full
fuel tank)147 kg
Engine
Engine type Air-cooled 4-stroke, SOHC,
gasoline
Cylinder arrangement V-type 2-cylinder
Displacement 124 cm
3
Bore ´Stroke 41.0 ´47.0 mm
Compression ratio 10.7:1
Starting system Electric starter
Lubrication system Wet sumpEngine oil
Type
Recommended engine oil
classification API Service SE, SF, SG type
or higher
cC
Be sure to use motor oils that do not contain anti-friction
modifiers. Passenger car motor oils (often labeled “Energy
Conserving”) contain anti-friction additives which will cause
clutch and/or starter clutch slippage, resulting in reduced
component life and poor engine performance.
Quantity
Periodic oil change 1.4 L
With oil filter replacement 1.6 L
Total amount 1.7 L
Air filterWet type element
8-1
–10° 0° 10° 20° 30°
40°
SAE 10W/30
SAE 10W/40
SAE 20W/40
SAE 20W/50
–20°
SAE 15W/40 50°C
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 78

SPECIFICATIONS
1
2
3
4
5
6
7
8
9
Fuel
Type Regular unleaded gasoline
Fuel tank capacity 9.5 L
Reserve amount 2.6 L
Carburetor
Type/quantity BDS26/1
Manufacturer MIKUNI
Spark plug
Manufacturer / Type NGK / CR6HSA or
DENSO / U20FSR-U
Gap 0.6 ~ 0.7 mm
Clutch typeWet, multiple-disc
Transmission
Primary reduction system Spur gear
Primary reduction ratio 3.400
Secondary reduction system Chain drive
Secondary reduction ratio 3.615
Number of sprocket teeth
(Rear/Front) 47/13
Transmission type Constant mesh 5-speed
Operation Left foot operationGear ratio 1st 2.643
2nd 1.684
3rd 1.261
4th 1.000
5th 0.821
Chassis
Frame type Double cradle
Caster angle 32°
Trail 120 mm
Tire
Type With tube
Front
Size 3.00-18 47P
Manufacturer/ CHENG SHIN / C-916
model
Rear
Size 130/90-15 M/C 66P
Manufacturer/ CHENG SHIN / C-915
model
8-2
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 79