2000 YAMAHA XT500E maintenance

6-22
8Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor brake performance.
8Be careful that water does not
enter the master cylinder when
refilling. Water will significantly
lower the boiling point of the fluid
and may result in vapor lock.
8Brake fluid may deteriorate paint-
ed surfaces or plastic parts.
Always clean up spilled fluid
immediately.
8Have a Yamaha dealer check
the cause if the brake fluid level
goes down.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU00742
Brake fluid replacementThe brake fluid should be replaced
only by trained Yamaha service per-
sonnel. Have the Yamaha dealer
replace the following components
during periodic maintenance or when
they are damaged or leaking:
8oil seals (every two years)
8brake hoses (every four years)
EAU00744
Drive chain slack checkNOTE:
Spin the wheel several times and find
the tightest position of the chain.
Check and/or adjust the chain slack
while itÕs in this tightest position.To check the chain slack the motor-
cycle must be held straight up with
both wheels on the ground and with-
out rider. Check the slack at the posi-
tion shown in the illustration. Normal
slack is approximately 30 ~ 40 mm. If
the slack exceeds 40 mm, adjust.
a
a.Chain slack
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 23

EC000096
cCToo little chain slack will overload
the engine and other vital parts.
Keep the slack within the specified
limits.3.After adjusting, be sure to tighten
the axle nut and caliper bracket
bolt to the specified tightening
torque.
6-23
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU03006
Drive chain lubricationThe chain consists of many parts
which work with each other. If the
chain is not maintained properly, it
will wear out quickly. Therefore, the
chain must be serviced regularly.
This service is especially necessary
when riding in dusty areas. This
motorcycle is equipped with a sealed
type chain. Steam cleaning, high-
pressure washers, and solvents can
damage the drive chain, so do not
use these for cleaning it. Use only
kerosene to clean the drive chain.
Wipe it dry, and thoroughly lubricate it
with SAE 30 ~ 50W motor oil. Do not
use any other lubricants on the drive
chain. They may contain solvents
that could damage the sealed chain. Tightening torque:
Axle nut:
105 Nm (10.5 m
0kg)
Caliper bracket bolt:
48 Nm (4.8 m
0kg)
EAU01134
Drive chain slack adjustment1.Loosen the axle nut and caliper
bracket bolt.
2.Turn both left and right chain
adjusting plates the same
amount. Make sure that they are
in the same position for proper
wheel alignment. To tighten the
chain, turn in direction a. To
loosen the chain, turn in direction
b.
a
b2 1
3
1.Chain adjusting plate
2.Axle nut
3.Caliper bracket bolt
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 24

6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EC000097
cCBe sure to oil the chain after wash-
ing the motorcycle or riding in the
rain.
EAU00773
Throttle cable and grip
lubricationThe throttle twist grip assembly
should be greased at the time that
the cable is lubricated, since the grip
must be removed to get at the end of
the throttle cable. After removing the
screws, hold the end of the cable up
in the air and put in several drops of
lubricant. With the throttle grip disas-
sembled, coat the metal surface of
the grip assembly with a suitable all-
purpose grease.
EAU02962
Cable inspection and
lubrication
EW000112
wDamage to the outer housing of
cables may lead to internal rusting
and interfere with the cable move-
ment. Replace damaged cables as
soon as possible to prevent unsafe
conditions.Lubricate the cables and cable ends.
If a cable does not operate smoothly,
ask a Yamaha dealer to replace it.
Recommended lubricant:
Engine oil
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 25

6-25
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU02984
Brake and shift pedal
lubricationLubricate the pivoting parts.
Recommended lubricant:
Engine oil
EAU02986
Sidestand lubricationLubricate the sidestand pivoting point
and metal-to-metal contact surfaces.
Check that the sidestand moves up
and down smoothly.
EW000113
wIf the sidestand does not move
smoothly, consult a Yamaha deal-
er.
Recommended lubricant:
Engine oil
EAU02985
Brake and clutch lever
lubricationLubricate the pivoting parts.
Recommended lubricant:
Engine oil
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 26

6-26
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU00790
Rear suspension lubricationLubricate the pivoting parts.
Recommended lubricant:
Molybdenum disulfide grease
1
1
1.Grease nipple (´2)
Operation check
1.Place the motorcycle on a level
place.
2.Hold the motorcycle in an upright
position and apply the front
brake.
3.Push down hard on the handle-
bars several times and check if
the fork rebounds smoothly.
EC000098
cCIf any damage or unsmooth move-
ment is found with the front fork,
consult a Yamaha dealer.
EAU02939
Front fork inspectionVisual check
EW000115
wSecurely support the motorcycle
so there is no danger of it falling
over.Check for scratches or damage on
the inner tube and excessive oil leak-
age from the front fork.
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 27

EW000115
wSecurely support the motorcycle
so there is no danger of it falling
over.
6-27
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU01144
Wheel bearingsIf there is play in the front or rear
wheel hub or if the wheel does not
turn smoothly, have a Yamaha dealer
inspect the wheel bearings.
EAU00794
Steering inspectionPeriodically inspect the condition of
the steering. Worn out or loose steer-
ing bearings may be dangerous.
Place a stand under the engine to
raise the front wheel off the ground.
Hold the lower end of the front forks
and try to move them forward and
backward. If any free play can be felt,
ask a Yamaha dealer to inspect and
adjust the steering. Inspection is eas-
ier if the front wheel is removed.
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 28

6-28
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
EAU00800
BatteryThis motorcycle is equipped with a
sealed-type battery. Therefore it is
not necessary to check the elec-
trolyte or fill the battery with distilled
water.
8 8
If the battery seems to have dis-
charged, consult a Yamaha deal-
er.
8 8
If the motorcycle is equipped
with optional electrical acces-
sories, the battery tends to dis-
charge more quickly, so be sure
to recharge it periodically.
EC000101
cCNever try to remove the sealing
caps of the battery cells. The bat-
tery will be damaged.
Battery storage
When the motorcycle is not used for
a month or longer, remove the bat-
tery, fully charge it and store it in a
cool, dry place.
EC000102
cC8
8
Completely recharge the bat-
tery before storing. Storing a
discharged battery can cause
permanent battery damage.
8 8
Use a battery charger
designed for a sealed-type
(MF) battery. Using a conven-
tional battery charger will
cause battery damage. If you
do not have a sealed-type bat-
tery charger, contact your
Yamaha dealer.
8 8
Always make sure the connec-
tions are correct when rein-
stalling the battery.
EW000116
wBattery electrolyte is poisonous
and dangerous, causing severe
burns, etc. It contains sulfuric
acid. Avoid contact with skin, eyes
or clothing.
ANTIDOTE:
8 8
EXTERNAL: Flush with water.
8 8
INTERNAL: Drink large quanti-
ties of water or milk. Follow
with milk of magnesia, beaten
egg, or vegetable oil. Call a
physician immediately.
8 8
EYES: Flush with water for 15
minutes and get prompt med-
ical attention.
Batteries produce explosive
gases. Keep sparks, flame, ciga-
rettes etc., away. Ventilate when
charging or using in an enclosed
space. Always shield your eyes
when working near batteries.
KEEP OUT OF REACH OF CHIL-
DREN.
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 29

EC000103
cCDo not use fuses of higher amper-
age rating than those recommend-
ed. Substitution of a fuse of
improper rating can cause exten-
sive electrical system damage and
possibly a fire.
EAU01146
Headlight bulb replacementThis motorcycle is equipped with a
quartz bulb headlight. If the headlight
bulb burns out, replace it as follows:
1.Remove cowling A. (See page
6-7 for cowling removal and
installation procedures.)
2.Remove the headlight unit.
6-29
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9Specified fuse:
20 A
1
1.Bolt (´3)
1
2
EAU01307
Fuse replacementThe fuse is located behind panel A.
(See page 6-7 for panel removal and
installation procedures.)
If the fuse is blown, turn off the main
switch and the switch of the circuit in
question. Install a new fuse of proper
amperage. Turn on the switches and
see if the electrical device operates.
If the fuse immediately blows again,
consult a Yamaha dealer.1.Main fuse
2.Spare fuse
4PT-9-E6 (ENG) 6 12/27/00 1:29 PM Page 30