2000 VOLVO C70 parking brake

ad blue oil viscosity key fob battery fuse box location windshield wipers load capacity

Page 43 of 89

VOLVO C70 2000 Owners Manual The spare wheel is located under the carpet on the trunk floor. The jack and crank are secured in the wheel recess.
· Engage the parking brake.
· Put the gear selector in (P)ark (automatic) or in

The spare wheel is located under the carpet on the trunk floor. The jack and crank are secured in the wheel recess.
· Engage the parking brake.
· Put the gear selector in (P)ark (automatic) or in Reverse (manual).
· With the car still on the ground, use the lug wrench to loosen the wheel bolts 1/2 1 turn. Turn the bolts
counterclocKWise to loosen.
· Fold out the crank handle on the jack by pressing the knob on the handle downward. To attach the jack, refer to the
illustration on the following page.
CAUTION: The car must not be driven with wheels of different dimensions or with a spare tire other than the one that
came with the car. The use of different size wheels can seriously damage your car's transmission.
NOTE: To avoid excessive wear and the necessity of rebalancing, mark and reinstall wheels in the same location and
position as before removal. To lessen the chance of imbalance, each wheel hub is equipped with a guide stud to ensure
that a removed wheel can be reinstalled in its original position (as when changing over to winter tires/wheels).
pg. 83 Wheel changing
There is a jack attachment located in the center on each side of the car. Position the jack on the bar in the attachment
as shown in illustration above and crank while simultaneously guiding the base of the jack to the ground. The base of
the jack must be flat on a level, firm, non-slippery surface. Before raising the car, check that the jack is still
correctly positioned in the attachment. Raise the vehicle until both wheels on the side of the car where the jack is
attached are lifted off the ground. Unscrew the wheel bolts completely and carefully remove the wheel so as not to
damage the thread on the studs.
Installing the wheel
Clean the contact surfaces on the wheel and
hub. Lift the wheel and place it on the hub. Make sure that you align the wheel with the guide stud on the wheel hub
prior to installation. Install the wheel bolts crosswise (see illustration) and tighten by turning lightly clocKWise. Lower
the vehicle to the ground and alternately tighten the bolts to 100 ft. lbs. (136 Nm). Install the wheel cap (where
applicable).
ProCarManuals.com

Page 44 of 89

VOLVO C70 2000 Owners Manual WARNING!
· The jacks attachment must engage the bar in the jack attachment (A). The cars weight must not rest on the jack
attachment (B).
· Be sure the jack is on a firm, level, non-slippery

Page 66 of 89

VOLVO C70 2000 Owners Manual Generator
Rated output 1400 W
Max. current 100 A
Bulbs
BulbUS no.Power SocketNo/bulbs
Headlights
High beam H755W -2
Low beam H755W -2
Front parking lights/turn signals 3357NA30/7W/30/2.2cp W 2.5 x 15

Page 83 of 89

VOLVO C70 2000 Owners Manual Immobilizer (start inhibitor)42
Instrument illumination22
Instruments14,15
J
Jack53
,82,83
Jump starting70
K
Keyless entry system43
Keylock59
Keys42
Kick -down61,63
Kickdown62,64
L
Label information1

Page: < prev 1-8 9-16

fog light bulb oil change brake pads airbag off garage door opener dead battery