2000 TOYOTA ECHO child seat

ECHO_U
542000 ECHO (OM52411U)
SU13048
3. While pressing the convertible seatfirmly against the seat cushion and
seatback, let the shoulder belt retract
as far as it will go to hold the convert-
ible seat securely.
SU13049
CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.
SU13050
4. To remove the convertible seat, pressthe buckle−release button and allow the
belt to retract completely. The belt will
move freely again and be ready to
work for an adult or older child passen-
ger.

ECHO_U
552000 ECHO (OM52411U)
SU13051
(C) BOOSTER SEAT INSTALLATION
A booster seat is used in forward−fac-
ing position only.
SU13052
Move seat
fully back
CAUTION
A forward−facing child restraint sys-
tem should be allowed to be put on
the front seat only when it is un-
avoidable. Always move the seat as
far back as possible, because the
force of a deploying airbag could
cause death or serious injury to the
child.
SU13053
1. Sit the child on a booster seat. Runthe lap and shoulder belt through or
around the booster seat and child fol-
lowing the instructions provided by its
manufacturer and insert the tab into
the buckle taking care not to twist the
belt.
Make sure the shoulder belt is correctly
across the child’s shoulder and that the
lap belt is positioned as low as possible
on child’s hips. See "Seat belts" for de-
tails.

ECHO_U
562000 ECHO (OM52411U)
CAUTION
Always make sure the shoulder belt
is positioned across the center of
child’s shoulder. The belt should be
kept away from child’s neck, but
not falling off child’s shoulder. Fail-
ure to do so could reduce the
amount of protection in an accident
and cause serious injuries in a col-
lision.
High−positioned lap belts and
loose−fitting belts both could cause
serious injuries due to sliding un-
der the lap belt during a collision
or other unintended result. Keep
the lap belt as low on hips as pos-
sible.
For child’s safety, do not place the
shoulder belt under child’s arm.
After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.
If the seat belt does not function
normally, it cannot protect your
child from injury. Contact your Toy-
ota dealer immediately. Do not use
the seat until the seat belt is fixed.
SU13054
2. To remove the child restraint system, press the buckle−release button and al-
low the belt to retract.

ECHO_U
572000 ECHO (OM52411U)
SU13101
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
SU13107
Anchor brckets
Use the anchor bracket on the back
panel to attach the top strap.
Anchor brackets are installed for each
rear seat.
This symbol indicates the locatiopn of
user ready tether ancholage.
SU13103
TO USE THE ANCHOR BRACKET:1. Remove the head restraint.
 U sin g a to p st r ap

ECHO_U
582000 ECHO (OM52411U)
SU13104
2. Open the anchor bracket cover withthe mark shown in the illustration.
SU13105
3. Fix the child restraint system withthe seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see Child restraint" in this
Section.
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
SU13106
4. Replace the head restraint.
Store any removed covers in a safe place
such as the glove box.
Be sure to replace all covers when the
anchor bracket is not in use.