11-24SAE viscosity No. and Applicable Temperature
OM-H0212
Rear differential gear oil
Checking the gear oil level CAUTION
If the vehicle requires frequent refilling, there may be an oil leak. If you suspect a problem, have the vehicle checked at your
SUBARU dealer.
Your vehic le may b e eq uip p ed with a rear d ifferenti al p rotec tor. The
d ifferential p rotec tor p rovid es p rotec tion to the r ear d ifferential assem-
b ly d uring off-road use. Removal of the rear d iffer ential p rotec tor is not
req uired when c hec king the oil level.
11-26Power steering fluid
Checking the fluid level
WARNING
Be careful not to burn yourself because the fluid may be hot.
CAUTION
When power steering fluid is being added, use only clean fluid,
and be careful not to allow any dirt into the tank. And never use
different brands together. Avoid spilling fluid when adding it in the tank.
The p ower steering fluid exp and s g reatly as its tem p erature rises; the
fluid level d iffers ac c ord ing to fluid temp erature. Therefore, the reser-
voir tank has two d ifferent c hec king rang es for hot and c old fluid s.
Chec k the p ower steering fluid level monthly.
1. Park the vehic le on a level surfac e, and stop the eng ine.
2. Chec k the fluid level of the reservoir tank.
When the fluid is hot after the vehic le has b een ru n: Chec k that the oil
level is b etween “HOT MIN ” and “HOT MAX ” on the surfac e of the
reservoir tank.
When the fluid is c ool b efore the vehic le is run: C hec k that the oil level
is b etween “COLD MIN ” and “COLD MAX ” on the surfac e of the res-
ervoir tank.
3. If the fluid level is lower than the ap p lic ab le “MIN ” line, ad d the
rec ommend ed fluid as nec essary to b ring the level b etween the
“ MIN ” and “MAX ” line.
11-38
Installing the wheel cover
HGA013BA
Alig n the valve with the valve hole in the c over, t hen fit the c over on
the wheel b y tap p ing your hand evenly around the c i rc umferenc e of
the c over.
NOTE When any of the wheels is removed and replaced for tire rotation or to change a flat tire, always check the tightness of the wheel nutsafter driving approximately 600 miles (1,000 km). If any nut is loose,tighten it to the specified torque.
Aluminum wheels (If equipped)
Aluminum wheels c an b e sc ratc hed and d amag ed easily . Hand le them
c arefully to maintain their ap p earanc e, p erformanc e , and safety.
When any of the wheels is removed and rep lac ed for tire rotation or to
c hang e a flat, always c hec k the tig htness of the wh eel nuts after d riving
ap p roximatly 600 miles (1,000 km). If any nut is lo ose, tig hten it to the
sp ec ified torq ue. Never ap p ly oil to the thread ed p arts, wheel nuts, or tap ered surfac e
of the wheel. Never let the wheel rub ag ainst sharp p rotrusions o r c urb s.
Be sure to fit tire c hains on uniformly and c omp let ely around the tire,
otherwise the c hains may sc ratc h the wheel.
