2000 SUBARU LEGACY oil change

1-30
Attachment of any equipment (bush bar, winches, snow plow,
skid plate, etc.) other than SUBARU genuine accessory parts to the front end. Modification of the suspension system or front end structure.
Installation of a tire of different size and construction from the
original tires listed on the tire placard attached to the door jamb.
Always c onsult your SUBARU d ealer if you want to in stall any ac c es-
sory p arts to your vehic le.
Seatbelt maintenance
CAUTION
Keep the belts free of polishes, oils, chemicals and particularly
battery acid. Never attempt to make modifications or changes that will pre-
vent the seatbelt from operating properly.
To c lean the seatb elts, use a mild soap and lukewar m water. Never
b leac h or d ye the b elts b ec ause this c ould seriousl y affec t their streng th.
Insp ec t the seatb elts and attac hments inc lud ing the web b ing and all
hard ware p eriod ic ally for c rac ks, c uts, g ashes, tea rs, d amag e, loose
b olts or worn areas. Rep lac e the seatb elts even if only minor d amag e is
found .

Seat, seatbelt and SRS airbags1-47
–
CONTINUED –

Storing the built-in child restraint
Always p rop erly store the b uilt-in c hild restraint b efore using the reg u-
lar lap -should er b elt for the rear-c enter seating p osition.
HBS060BA
HBS066BA
1. Fasten the c hest c lip .
2. Stow the b elt b uc kle into the rec ess of the c hild restraint c ushion.
3. Fold the c hild restraint c ushion up into the seat b ac k.
Replacing restraint system parts after a collision
WARNING
Replace the built-in child restraint equipped vehicle seatback as-
sembly if the child restraint was in use during a serious collision.
The built-in restraint may be severely weakened. In a subsequent
accident, it might not be able to provide adequate protection. Theentire assembly should be replaced even if damage is not ob-vious.
Maintenance CAUTION
Keep the belts free of polishes, oils, chemicals and particularly
battery acid as they may weaken the belts. Never attempt to make modifications or changes that will pre-
vent the built-in child restraint from operating properly.

11-38
Installing the wheel cover
HGA013BA
Alig n the valve with the valve hole in the c over, t hen fit the c over on
the wheel b y tap p ing your hand evenly around the c i rc umferenc e of
the c over.
NOTE When any of the wheels is removed and replaced for tire rotation or to change a flat tire, always check the tightness of the wheel nutsafter driving approximately 600 miles (1,000 km). If any nut is loose,tighten it to the specified torque.
Aluminum wheels (If equipped)
Aluminum wheels c an b e sc ratc hed and d amag ed easily . Hand le them
c arefully to maintain their ap p earanc e, p erformanc e , and safety.
When any of the wheels is removed and rep lac ed for tire rotation or to
c hang e a flat, always c hec k the tig htness of the wh eel nuts after d riving
ap p roximatly 600 miles (1,000 km). If any nut is lo ose, tig hten it to the
sp ec ified torq ue. Never ap p ly oil to the thread ed p arts, wheel nuts, or tap ered surfac e
of the wheel. Never let the wheel rub ag ainst sharp p rotrusions o r c urb s.
Be sure to fit tire c hains on uniformly and c omp let ely around the tire,
otherwise the c hains may sc ratc h the wheel.