Downloaded from www.Manualslib.com manuals search engine COOLING SYSTEM
Diagram
19
19-2
Diagram
1 Engine
2 Radiator
3 "Hot" container with degassing after thermostat
4 Heater matrix
5 Thermostat mounting
6 Thermoplunger mounting (if fitted)7 3 mm ∅ restriction
8 6 mm ∅ restriction
9 Oil/water exchanger
10 Water pump
11 Thermostat
12 Bleed screw
The expansion bottle valve rating is 1.2 bar
(colour: brown).
Downloaded from www.Manualslib.com manuals search engine COOLING SYSTEM
Radiator
19
19-4
Radiator
REMOVAL
Put the vehicle on a two post lift.
Disconnect the battery.
Remove the engine undertray.
Drain the cooling circuit through the lower radiator
hose.
Disconnect the wiring of the fan unit.
Unclip the power steering reservoir and remove it.
Remove:
– the upper cross member,
– the upper radiator mountings,
– the upper hoses on the radiator,
– the inlet manifold-air exchanger duct,
– the fan unit mountings on the radiator and remove
the fan,
– the radiator mountings on the condenser and remove
the radiator.REFITTING
Refitting is the reverse of removal.
Fill and bleed the cooling circuit (see section 19
"Filling and bleeding").
NOTE: ensure that the fins of the radiator or of the
condenser (if fitted) are not damaged when
removing-refitting, and protect them if necessary. SPECIAL TOOLING REQUIRED
Mot. 1202 -01
Hose clip pliers
Mot. 1202 -02
Mot. 1448 Long nose pliers for hose clips
