Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T1.WIN 24/2/2001 14:26-page41
1.35
INSTRUMENT PANEL(continued)
The presence and operation of the warning lights, described below, depend on the vehicle equipment and
country.
7Multifunction display
• Engine oil level indicator
The vehicle must be parked
on level ground and the
engine should have been
switched off for some time
beforehand to obtain an
accurate reading.
For approximately 30 seconds
after the ignition has been
switched on:
-iftheleveliscorrect,the
display will show “oil OK”
Special feature:to gain a
more accurate reading of
the level, press the trip
mileage reset button or the
information scroll button
on the on-board computer
during these 30 seconds (on
the stalk on the right-hand
side of the steering wheel).
The squares which appear
on the display indicate the
level. The number of
squares displayed is
reduced as the oil level
drops and they are replaced
by a dash.To move to on-board computer
reading, press the button again.
- When the level is at a
minimum,thedashesand
the word “ oil” flash, “ OK” is
no longer displayed and the
SERV warning will
illuminate.
It is vital to top up the oil as
soon as possible.
• On-board computer
Canbereadapproximately
30 seconds after the ignition
is switched on.
Refer to the information in
section 1 on the on-board
computer.8Multifunction key
Press repeatedly on the key to
select information on the
display, or to reset the on-board
computer trip mileage
counter(s).
STOP light
It goes out as soon as
the engine starts.
This lights up together with
one of the warning lights:
Engine immobiliser
system indicator light
This light has several
functions.
Refer to the information
on the engine immobiliser in
section 1.
Downloaded from www.Manualslib.com manuals search engine 3
1
2
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T1.WIN 24/2/2001 14:26-page46
1.40
ON-BOARD COMPUTER
1Display
2Start key and reset button on the
trip mileage counters
For example, to reset the trip
mileage, the display must be set to
“trip mileage”.
Automatic resetting
The trip mileage recorders will b
reset automatically when the
maximum capacity of any of the
memories is exceeded.3Display selection key
Keep pressing key3briefly to
show the following information
in sequence:
a) total mileage recorder,
b) trip mileage recorder,
c) fuel consumed,
d) average consumption,
e) current consumption,
f) estimated range,
g) distance covered,
h) average speed.
Display flashing
Consult a Renault Dealer if the
display flashes.
Interpreting certain values
displayed after resetting
The values showing average fuel
consumption, range and average
speed will become more stable and
reliable the further you travel since
thelasttimetheresetkeywas
pressed.For the first few miles after pressing
the reset button you will notice:
• that the range increases as you
travel. This is normal. Average
fuel consumption may decrease
when:
- The car stops accelerating.
- The engine reaches its operating
temperature (engine cold when
start button pressed).
- When you drive from a built up
area on to the open road.
Therefore, if the average fuel
consumption decreases, the range
will increase.
•Youmayalsonoticethatthe
average fuel consumption
increases when the vehicle is
stationary and the engine idling.
This is normal since the module
takes account of fuel used during
idling.
