2000 RENAULT MEGANE engine overheat
[x] Cancel search: engine overheatPage 42 of 181
Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T1.WIN 24/2/2001 14:26-page43
1.37
INSTRUMENT PANEL(continued)
The presence and operation of the warning lights described below depend on the vehicle equipment and
country.
9SERVICE warning light
This light illuminates
when the ignition is
switched on and then
extinguishes within 3 seconds.
If it illuminates when the
vehicle is being driven, it is
advisable to stop at a Renault
Dealer soon.
It illuminates together with one
of the warning lights:
Tell-tale light for
left-hand direction
indicator
Low fuel-level warning
light
It extinguishes as soon
as the engine starts.
If it illuminates or remains
illuminated, fill up with fuel as
soon as possible.
Tell-tale light for
right-hand direction
indicators9Warning light for
serious injection
incident/
Coolant temperature warning
light
• Warning light for serious
injection incident
If it flashes when you are
driving, it indicates that the
engine is overheating or there
is a fault in the injection
system. Stop at once, switch
off the ignition and call for
the assistance of a Renault
Dealer.
•Coolant temperature
warning light
If this light illuminates
(permanent illumination)
when you are driving, stop
the vehicle. If the needle4on
the temperature gauge is in
zone4a, call a Renault
Dealer. If this is not the case,
continue driving and consult
a Renault Dealer at the
earliest opportunity.9Electronic fault
warning light
If it illuminates when
you are driving, there is
an electrical or
electronic fault. Consult your
Renault Dealer as soon as
possible.
Oil pressure warning
light
It should extinguish as
soon as the engine starts; if it
illuminates when you are
driving, stop at once, switch off
the ignition and check the oil
level. If this is normal, call for
the assistance of a Renault
Dealer.
Battery charging
warning light
It should extinguish as
soon as the engine starts.
If it illuminates when you are
driving, it indicates that the
circuit is overcharging or
discharged. Stop and have the
circuit checked.
Page 57 of 181
Downloaded from www.Manualslib.com manuals search engine A
B
C
D
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T1.WIN 24/2/2001 14:26-page58
1.52
WINDSCREEN WASH/WIPE
Windscreen wiper
With the ignition on, turn
handle1
•AOff
•BIntermittent wiping
The wipers will pause for several
seconds between sweeps. The
sweep interval may be varied by
turning the central ring on the
stalk switch1:
•CNormal wiping speed
•DFast wiping speed
Vehicles with automatic
selection of wiping speed
If a wiping speed is selectedwhen
driving, the wiping speed is
reduced to the lower speed when
the car stops:
• from fast wiping speed the speed
will change to normal wiping
speed;
• from normal wiping speed the
speed will change to intermittent
wiping.
As soon as the vehicle moves off,
wiping will return to the speed
originally selected.
When the vehicle is stationary:If
stalk switch1is operated, it
overrides and cancels automatic
operation.
Note:
If for any reason the wipers cannot
move (e.g. stuck to windscreen by
ice), the system will automatically
cut off the power supply to the
wipers.
Windscreen washer,
headlight washers
With the ignition on, pull the stalk1
towards you.
Press briefly to engage one sweep of
the wiper, press hold to engage three
sweeps.
•Carlightsoff
The windscreen washer will be
activated.
•Carlightson
The headlight washers will be
activated at the same time.
In frosty weather, make sure the
wiper blades are not stuck by ice
(risk of motor overheating).
Keep an eye on the condition of the
blades. Change the wiper blades as
soon as they become less efficient
(approximately once a year).
If you switch off the ignition before
switching off the windscreen wiper
(positionA) the blades will stop
randomly on the windscreen.
Page 63 of 181
Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:29-page4
2.04
SPECIAL POINTS RELATING TO PETROL VERSIONS
The following operating conditions
may cause the catalytic converter to
overheat and thus reduce its
efficiencyor even destroy it and
cause heat damage to the vehicle:
• Driving for a long time with the
low fuel level warning light
illuminated;
• Faulty ignition, running out of
fuel or spark plug disconnected
occurring as engine misfiring and
snatches when driving;
• Using leaded petrol;
• Using lubrication additives or
fuel which is not approved by
Renault;
• Loss of power;
• The fitting of non-recognised
security systems which have been
integrated into the fuel injection
system for immobilisation
purposes;
• Bump starting the vehicle, as
unburntpetrolinthesystemmay
affect the catalyst if the car does
not start quickly. However, jump
starting with jump leads across
the battery is permissible.If you note any of the above
incidents, have the necessary
repairs carried out as soon as
possible by your Renault Dealer.
Theseincidentsmaybeavoidedby
taking your vehicle regularly to
your Renault Dealer at the intervals
specified in your servicing booklet.
Starting problems
To avoid damaging the catalytic
converter,do not keep trying to
startthe engine (using the ignition
key, or by pushing or pulling the
vehicle)without having identified
and corrected the starting fault.
If the fault cannot be identified, do
not persist in attempting to start the
engine. Call a Renault Dealer.
Do not park the vehicle or
run the engine in locations
where combustible substancesormaterialssuchasgrassor
leaves can come into contact with a
hot exhaust system.
Page 64 of 181
![RENAULT MEGANE 2000 X64 / 1.G Owners Manual Downloaded from www.Manualslib.com manuals search engine 2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\](/manual-img/7/1565/w960_1565-63.png "RENAULT MEGANE 2000 X64 / 1.G Owners Manual Downloaded from www.Manualslib.com manuals search engine 2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\")
Downloaded from www.Manualslib.com manuals search engine 2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:29-page5
2.05
GEAR LEVER HANDBRAKE POWER STEERING
To select reverse
(vehicle stationary)
Move the lever to neutral, then
position the lever in reverse.
Ring1has to be lifted up to the gear
lever knob to select reverse gear.
The reversing lights will illuminate
as soon as reverse gear is selected
(ignition on).To release:
Pull the lever up slightly, press
button2and then lower the lever to
the floor.
Theredwarninglightonthe
instrument panel will illuminate if
you are driving with an incorrectly
released handbrake.
To apply:
Pull the lever up.
The lever should travel about 10
notches to hold the car. Your vehicle
is fitted with self-adjusting rear
brake shoes and the handbrake
should only be adjusted during a
brake overhaul.
When the vehicle is
stationary, make sure
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating may
occur.When power assisted steering is
fitted, never leave the steering
wheel on full lock when the vehicle
is parked as this may damage the
pump.
Never switch off the
ignition when travelling
downhill, and avoid
doing so when driving in
general (power steering and
brake servo will not function).
Page 149 of 181
Downloaded from www.Manualslib.com manuals search engine 2
1
3
4
3
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T5.WIN 24/2/2001 14:44-page16
5.16
FUSES
Fuse box1
If an incident occurs in an electrical
component, check first of all that
the fuses are sound. Also make sure
that the faulty component is
correctly connected. If a short
circuit occurs, unscrew one of the
wing nuts on the battery posts to
isolate the battery.
Open the cover2(under the steering
wheel).To identify the fuses, refer to label4
(shown on the page opposite).
It is advisable not to use the free
fuse locations.
Check the fuse in
question andreplace it,
if necessary,with a fuse
which must be of the
same rating as the original fuse
If a fuse is fitted where the rating
is too high, it may cause the
electrical circuit to overheat (risk
offire)intheeventofanitemof
equipment using an excessive
amount of current.
CORRECT INCORRECT
Use tweezers3to remove the fuse.
Toremovethefusefromthe
tweezers, slide the fuse to the side.
A wise precaution:
Obtain a box of spare bulbs and
fuses from your Renault Dealer.
Page 158 of 181
Downloaded from www.Manualslib.com manuals search engine 1
2
3
4
A
B
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T5.WIN 24/2/2001 14:44-page25
5.25
SCREEN WIPERS
Replacing windscreen wiper
blades1
•Lift the windscreen wiper arm3.
• Move the blade into a horizontal
position.
•Press tab2and slide the wiper
blade downwards until hook4on
the wiper arm is released.
• Remove blade in direction of
arrow (A)andfitnewbladein
direction of arrow (B).To refit
To refit the wiper blade, proceed in
reverse order to removal. Make sure
the blade is correctly locked in
position.
• In frosty weather, make
sure the wiper blades
arenotstuckbyice
(risk of motor
overheating).
• Change the wiper blades as
soon as they become less
efficient (approximately once a
year).
Page 166 of 181
Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T5.WIN 24/2/2001 14:44-page33
5.33
OPERATING INCIDENTS(continued)
On the open road CAUSES REMEDIAL ACTION
•Steering becomes hard to turn. Belt broken. Have the belt replaced.
Lack of oil in pump. Top up the oil (see maintenance
section).
If the problem persists, consult a
Renault Dealer.
• The engine overheats. The coolant
temperature warning light illuminates
(or the gauge needle moves into the
red zone).Water pump: belt stretched or broken.
Faulty engine cooling fan.Stop the vehicle and switch off the
engine. Consult a Renault Dealer.
Coolant leaks. Check the condition of hoses and
clips.
Check the expansion bottle: it should
contain coolant. If it does not, top it
up(having let it cool down). Take care
not to scald yourself. This action is
only temporary: consult your Renault
Dealer as soon as possible.
Radiator
Never fill a hot radiator with cold coolant if a considerable quantity has been lost. After any operation on the
vehicle which has involved even partial draining of the cooling system, it must be refilled with a new mixture
prepared in the correct proportions. Reminder: only products approved by our Technical Department may be
used for this purpose.