UPPER REAR STRUCTURE
Lights mounting side panel rain channel
44Lights mounting side panel rain channel
INTRODUCTION
This part is changed in addition to changing the
rearend panel. It is carried out partially.
In the operation described below, only descriptions of
the joints specific to the part concerned are given.
Information on parts to which this is additional, will be
dealt with in their respective sections (refer to
contents).
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with:
–side panel extension,
–lights mounting with studs and welded nuts,
–bumper counter blade,
–tailgate counter balance reinforcement,
–welded nuts,
–upper hinge reinforcement.
IMPORTANT: the Parts Department part should be cut
out before fitting at the level of the assembled side
panel extender (refer to diagram below). PARTS CONCERNED (thickness in mm):
1 Lights support side panel rain channel 1.5
2 Bolt diameter 8 mm key of 13
3 Steel rivet
16715S
44-33
K
TOP OF BODY
Roof inner panel extender
45Roof inner panel extender
INTRODUCTION
This part is changed in addition to changing roof with
cross member.
In the operation described below, only descriptions of
the joints specific to the part concerned are given.
Information on parts to which this is additional, will be
dealt with in their respective sections (refer to
contents).
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part on its own.
PARTS CONCERNED (thickness in mm):
1 Roof inner panel extender 1
2 Roof rear cross member 0.8
3 Lights support side panel rain channel 1.5
4 Side inner panel extender 0.8
5 Side panel lining0.7 REMOVAL
F = bolt of Ø 8 mm
765E1-16643
CAA11538R8
45-5
E
