Page 65 of 184
A
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T1.WIN 12/10/2000 16:22-page65
1.57
ELECTRIC HEADLIGHT BEAM ADJUSTMENT
ControlAadjusts the headlight
beam height according to the load.
Turn controlAdownwards to lower
the headlights and turn the control
upwards to raise the headlight
beams.Versions
All versions except utility
Utility versionAdjustment positions for controlA
Position 0:Basic setting, luggage
compartment empty and only the
driver on board or with one front
passenger.
Position 2:Vehicle with 5 persons on
board, luggage compartment empty.
Position 3:Vehicle luggage
compartment fully laden and
driver only.
Positions 1, 4:Intermediate
positions.
Position 0:Basic setting, vehicle
unladen
Position 3:Vehicle fully laden
Positions 1, 2, 4:Intermediate
positions
Page 66 of 184
A
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T1.WIN 12/10/2000 16:22-page66
1.58
ELECTRIC HEADLIGHT BEAM ADJUSTMENT
ControlAadjusts the headlight
beam height according to the load.
Turn controlAdownwards to lower
the headlights and turn the control
upwards to raise the headlight
beams.Versions with dual headlights Adjustment positions for controlA
Position 0 or 1:Basic setting, luggage
compartment empty and only the
driver on board or with one front
passenger.
Position 2 or 3:Vehicle with driver
and four passengers, luggage
compartment empty.
Position 4:Vehicle with driver and
four passengers, luggage
compartment full.
Page 67 of 184

1
A
B
C
D
1
E
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T1.WIN 12/10/2000 16:22-page67
1.59
WINDSCREEN WASHERS / WIPERS
Front wiper
Ignition on, move stalk1
parallel to the steering wheel:
•APark.
•BIntermittent wipe.
Between wipes, the blades will
stop for several seconds.
Depending on version, it may
be possible to alter the time
between wipes by turning the
central ring2of stalk1.
•CContinuous slow wiping.
•DContinuous fast wiping.In freezing conditions, make sure that
the wiper blades are not stuck to the
windscreen (risk of overheating the
motor).
Keep an eye on the condition of the
blades. Change them as soon as they
become less efficient: approximately
once a year.
If you turn the engine off before
stopping the wipers (positionA)the
blades may stop anywhere on the
windscreen.
Windscreen washer,
headlight washer
Ignition on, pull stalkEtowards you.
• Headlights off
The windscreen washers will
activate.
• Headlights on
The headlight washers will also
be activated.
Page 70 of 184
1
22
3
1
0
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T1.WIN 12/10/2000 16:22-page70
1.62
AUDIBLE AND VISIBLE SIGNALS
Horn
Press the end of stalk1or, for
vehicles fitted with an air bag, press
buttons2.
Headlight flasher
To flash the headlights, even if the
lights are not in use, pull stalk1
towards you.
Hazard warning lights
Press switch3.
This switch illuminates all four
indicators at the same time.
It is to be used in cases of danger to
warn other road users that you:
• are obliged to stop in a normally
prohibited location,
• are obliged to drive under
particular conditions.
Direction indicators
Move stalk1parallel to the steering
wheel and in the direction in which
you are going to turn.
When driving on the motorway, the
steering wheel is not often turned
far enough to return the stalk
automatically to position0. There is
an intermediate position in which
the stalk can be held when changing
lanes.
When the stalk is released, it
automatically returns to0.
Page 127 of 184