2000 MITSUBISHI CARISMA light

FOR PLEASANT DRIVING
6–45
G13A018a
Vanity mirrorEG13A - A
A vanity mirror is fitted to the rear of the sun
visor on the passenger side.
G31A082a
Cigarette lighterEG31A-Al
The cigarette lighter can be used while the
ignition switch is in either “ON” or “ACC”.
1-Push all the way in.
The lighter will automatically return to its orig-
inal position with a “click” when ready.
Pull it out for use.
After use, insert the lighter to its original posi-
tion in the socket.
NOTE
Do not leave the cigarette lighter removed
from its socket, because the socket might
become clogged by foreign material and be
short - circuited.
CAUTION
(1) Do not touch heating element or
lighter housing, hold the knob
only as burns may occur.
(2) Do not allow children to operate
or play with the cigarette lighter
as burns may occur.
(3) Something is wrong with the ciga-
rette lighter if it does not pop back
out within approximately 30 sec-
onds of being pushed in.
Leaving the cigarette lighter
pushed in for an extended period
could cause fire. If it does not pop
out by itself, pull it out and have
the problem corrected at an auth-
orized MITSUBISHI dealer.
(4) Do not leave the cigarette lighter
pushed in or insert the cigarette
lighter from another vehicle.
Otherwise, the lighter may over-
heat and cause fire.
(5) It is recommended that only the
lighter be inserted in its socket.
Use of “plug - in” type accessories
may damage the socket and result
in poor retention of the lighter.

FOR PLEASANT DRIVING
6–46
CAUTION
(6) When the cigarette lighter socket
is used as a power source for an
electric appliance, be sure that
the electric appliance operates at
12 V and has an electric capacity
of 120 W or less. In addition, long
use of the electric appliance with-
out running the engine may run
down the battery.
G32A110a
AshtrayEG32AAV
Push the tray centre (A) to open.
G32A151a
To remove the ashtray, pull up the inner part
(B) from the sliding tray.
CAUTION
(1) Do not put papers and other
things that burn into your ash-
trays. If you do, cigarettes or
other smoking materials could
set them on fire, causing damage.
(2) Always close the ashtray. If left
open, other cigarette butts in the
ashtray may be rekindled.
(3) Put out a match and cigarette be-
fore they are placed in the ash-
tray.

FOR PLEASANT DRIVING
6–49
G14C044a
Centre console box with lid*EG14CAC
To open the box, tilt the armrest backward
and raise the lid. (Refer to “Armrest” on page
3–9.)
G34H066a
Cup holder
EG34HAK
The cup holder is located at the side of the
parking brake lever.
CAUTION
Do not drink beverages while driving
the vehicle; doing so could distract
you and result in an accident.
G17B024a
Rear shelf panel
(Hatchback)
EG17B - X
To remove
1. Pull the knob and tilt the rear seat back
slightly forward.
2. Slightly lift up the front edge of the rear
shelf. Slide the rear shelf rearward by
tapping it lightly at the right and left
sides to release the pins from the
catches.
3. Lift the rear shelf and remove it.

VEHICLE CARE
7–3
Genuine leather*EK27A-Ac
1. Lightly wipe off with gauze or other soft
cloth soaked with a 5 % aqueous sol-
ution of neutral detergent for wool.
2. Dip cloth in fresh water and wring it out
well. Using this cloth, wipe off the de-
tergent thoroughly.
3. Apply leather protecting agent to the
genuine leather surface.
NOTE(1) If genuine leather is wet with water or is
washed in water, wipe off water as
quickly as possible with a dry, soft cloth.
(2) Slight stains on genuine leather may be
removed with leather cleaner as well.
(3) The genuine leather surface may be
damaged if a nylon brush or synthetic
fibre is rubbed hard against it.
(4) Organic solvents such as benzine, al-
cohol and gasoline, acid or alkaline sol-
vents may discolour the genuine leather
surface. Be sure to use neutral deter-
gents.
(5)Dirty genuine leather seat may mildew.
Be very careful about oil stains and re-
move them quickly.
(6) The genuine leather surface may
harden and shrink if it is exposed to di-
rect rays of the sun for long hours. When
your vehicle is parked, place it in the
shade as much as possible.(7) When the temperature of the vehicle in-
terior rises in summer, vinyl products left
on the genuine leather seat may de-
teriorate and stick to the seat.
UpholsteryEK25A-Aa
1. To maintain the value of your new ve-
hicle, handle the upholstery carefully
and keep the interior clean.
Use a vacuum cleaner and brush to
clean the seats. If stained, vinyl and
synthetic leather should be cleaned
with an appropriate cleaner, and cloth
fabrics can be cleaned with either up-
holstery cleaner or a 3 % solution of
neutral detergent in lukewarm water.
2. Clean the carpeting with a vacuum
cleaner and remove any stains with
carpet cleaner. Oil and grease can be
removed by lightly dabbing with a
clean colourfast cloth and stain re-
mover.
Cleaning the outside of your
vehicle
EK28A-Ah
If the following is left on your vehicle, it may
cause corrosion, discolouration and stains,
wash the vehicle as soon as possible.

Seawater, anti-freeze for road use.

Soot and dust, iron powder from fac-
tories, chemical substance (acids, al-
kalis, coal-tar, etc.).

Droppings from birds, carcasses of in-
sects, tree sap, etc.

VEHICLE CARE
7–4
WashingEK22ACCb
Chemicals contained in the dirt and dust
picked up from the road surface can damage
the paint coat and body of your vehicle if left
in prolonged contact.
Frequent washing and waxing is the best
way to protect your vehicle from this dam-
age. This will also be effective in protecting
it from environmental elements such as rain,
snow, salt air, etc.
Do not wash the vehicle in direct sunlight.
Park the vehicle in the shade and spray it
with water to remove dust. Next, using an
ample amount of clean water and a car
washing brush or sponge, wash the vehicle
from top to bottom.
Use a mild car washing soap if necessary.
Rinse thoroughly and wipe dry with a soft
cloth. After washing the vehicle, carfully
clean the joints and flanges of the doors,
bonnet, etc., where dirt is likely to remain.
CAUTION
(1) When washing the under side of
your vehicle or wheel, wear a pair
of rubber gloves.
CAUTION
(2) Refrain from using a car wash as
its brushes may scratch the paint
surface, causing it to lose its
gloss.
Scratches will be especially vis-
ible on darker coloured vehicles.
(3) Never spray or splash water on
the electrical components in the
engine compartment, as this may
adversely affect engine starting.
Exercise caution also when
washing the underbody; be care-
ful not to spray water into the en-
gine compartment.
(4) Some types of hot water washing
equipment apply high pressure
and heat to the vehicle. They may
cause heat distortion and damage
to the vehicle resin parts and may
result in flooding of the vehicle in-
terior. Therefore; observe the fol-
lowing.

Maintain a good distance of ap-
prox. 40 cm or more between
the vehicle body and the wash-
ing nozzle.
CAUTION

When washing around the door
glass, hold the nozzle at a dis-
tance of more than 50 cm and
at right angles to the glass sur-
face.
(5) Using an automatic car wash, pay
attention to the following items, re-
fering to the operation manual or
consulting a car wash operator. If
the followings are not followed, it
could result in damage to your ve-
hicle.

The outside mirrors are re-
tracted.

The roof antenna is removed.

If your vehicle is equipped
with the rear wiper, tape or re-
move it.

VEHICLE CARE
7–5
During cold weatherThe salt and other chemicals spread on the
roads in some areas in winter can have a
harmful effect on the vehicle body. You
should therefore wash the vehicle as often
as possible in accordance with our care–in-
structions. It is recommended to have a pre-
servative applied and the underfloor protec-
tion checked at an authorized MITSUBISHI
dealer before and after the cold weather sea-
son.
After washing your vehicle, wipe off all water-
drops from the rubber parts around the doors
to prevent the doors from freezing.
NOTE
To prevent freezing of the weatherstripping
on the doors, bonnet, etc., they should be
treated with silicone spray.
WaxingEK33A-N
Waxing the vehicle will help prevent the ad-
herence of dust and road chemicals to the
paintwork. Apply a wax solution after wash-
ing the vehicle, or at least once every three
months to assist displacing of water. Do not
wax your vehicle in direct sunlight. You
should wax after the surfaces have cooled.
CAUTION
(1) Waxes containing high abrasive
compounds should not be used.
Such waxes remove rust and
stain effectively from the paint-
work but they are harmful to the
lustre of the painted surface.
Further, they are harmful to
glossy surfaces such as grille,
garnish, mouldings, etc.
(2) Do not use petrol or paint
thinners to remove road tar or
other contamination to the
painted surface.
(3) Do not apply wax on the areas
having black mat coating as it can
cause uneven discolouration,
patches, blurs, etc. If stained with
wax, immediately wipe off with a
piece of soft cloth and warm
water.
(4) On vehicles with the sunroof, be
careful when waxing the area
around the sunroof opening, not
to put any wax on the weather-
strip (black rubber). If stained
with wax, the weatherstrip cannot
maintain a weatherproof seal with
the sunroof.
PolishingEK04A-Ac
The vehicle should only be polished if the
paintwork has become stained or lost its
lustre. Matt - finish parts and plastic bumpers
must not be polished, polishing these parts
will stain them or damage their finish.
Damaged paintEK08A-Ac
Small cracks and scratches in the paint coat
should be touched up as soon as possible
with MITSUBISHI touch - up paint to prevent
corrosion.
Check body areas facing the road or the
tyres carefully for damage to the paint coat
caused by flying stones, etc. The paint code
number for your vehicle can be found on the
vehicle information code plate in the engine
compartment.
Chrome partsEK06A-Aa
In order to prevent spots and corrosion of
chrome parts, wash with water, dry thor-
oughly, and apply a special protective coat-
ing. This should be done more frequently in
winter.

FOR EMERGENCIES
8–2
If the vehicle breaks downEN40B-Bc
If the vehicle breaks down on the road, move
it to the shoulder and use the hazard warning
flashers.
If the engine stops/fails
Vehicle operation and control are affected if
the engine stops. Before moving the vehicle
to a safe area be aware of the following:
1. The brake booster becomes inoperat-
ive and the pedal effort will increase.
Press down the brake pedal harder
than usual.
2. Since the power steering pump is no
longer operative, the steering wheel
feels heavy when turning it. Turn the
wheel with more effort than usual.
Operation under adverse
driving conditions
EI43ABAa
If your vehicle is stuck: in sand,
mud or snow
If the vehicle becomes stuck in snow, sand,
or mud, it can often be moved by a rocking
motion. Move the gearshift lever or selector
lever alternately between the 1st and Re-
verse position (with manual transmission),
the “L” (LOW) and “R” (REVERSE) position
(with INVECS–II 4A/T), and the Sport mode
and “R” (REVERSE) position (with INVECS–
II Sport Mode 4A/T) while applying slight
pressure to the accelerator pedal.
Avoid racing the engine or spinning the
wheels. Prolonged efforts to free a stuck ve-
hicle may result in overheating and trans-
mission failure. Allow the engine to idle for a
few minutes to let the transmission cool be-
tween rocking attempts.
If the vehicle remains stuck after several
rocking attempts, seek other assistance.
WARNING
When attempting to rock your vehicle
out of a stuck position, be sure that
the area around the vehicle is clear of
people and physical objects. The
rocking motion may cause the ve-
hicle to suddenly launch forward or
backward causing injury or damage
to nearby people or objects.
On a flooded road
(1) Avoid flooded roads. Water could enter
the brake discs, resulting in temporarily
ineffective brakes. In such cases, lightly
depress the brake pedal to see if the
brakes operate properly. If they do not,
lightly depress the pedal several times
while driving in order to dry the brake
pads.
(2) When driving in rain or on a road with
many puddles a layer of water may form
between the tyres and the road surface.
This reduces a tyre’s frictional resis-
tance on the road, resulting in loss of
steering stability and braking capability.
To cope with this, observe the following
items:
(a) Drive your vehicle at a slow speed.
(b) Do not drive on worn tyres. Always
maintain the specified tyre inflation
pressures.

FOR EMERGENCIES
8–6
N22A086a
7. Insert the bar (E) into the wheel nut
wrench (F). Then set the end of the bar
to the shaft’s jack end, as shown in the
illustration.
Slowly rotate the wheel nut wrench
until the tyre is slightly off the ground.
WARNING
(1) Raise the vehicle so the tyre just
clears the ground. It is dangerous
to raise the vehicle any higher.
(2) Never get under the vehicle while
using the jack. Avoid jarring the
raised vehicle or leaving it sup-
ported on the jack for any long
time. Both are very dangerous.
(3) Do not start or run the engine
while the vehicle is on the jack.
The vehicle might start moving
and the jack might get out of the
body.
(4) Do not turn the jacked up wheels.
The tyres remaining on the
ground may turn, causing the ve-
hicle body to fall down from the
jack.
(5) No one should stay in the vehicle
while the jack is used.
CAUTION
Use only the jack included with the
vehicle, and use it only for changing
wheels.
N03A064a
Spare wheelEN03ABBaCheck the air pressure in the spare tyre
weekly, making sure it is ready for emerg-
ency use. Maintaining the spare wheel at the
highest specified air pressure will ensure that
it can always be used under any conditions
(city/high–speed driving, varying load
weight, etc.).
WARNING
When used, set to the correct tyre
pressure.