2000 Lexus LS400 seat adjustment

COMFORT ADJUSTMENT
147
Fastening front and rear seat belts
16L115a
Adjust the seat as needed and sit up straight and
well back in the seat. To fasten your belt, pull it out
of the retractor and insert the tab into the buckle.
You will hear a click when the tab locks into the buckle.
The seat belt length automatically adjusts to your size
and the seat position.
The retractor will lock the belt during a sudden stop or on
impact. It also may lock if you lean forward too quickly.
A slow, easy motion will allow the belt to extend, and you
can move around freely.When a passenger's shoulder belt is completely
extended and is then retracted even slightly, the belt is
locked in that position and cannot be extended. This
feature is used to hold the child restraint system
securely.
(For details, see ºChild restraintº on page 184.)
To free the belt again, fully retract the belt and then pull
the belt out once more.
If the seat belt cannot be pulled out of the retractor, firmly
pull the belt and release it. You will then be able to
smoothly pull the belt out of the retractor.

COMFORT ADJUSTMENT
148
CAUTION
After inserting the tab, make sure the tab and buckle
are locked and that the belt is not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally,
immediately contact your Lexus dealer. Do not use
the seat until the seat belt is fixed. It cannot protect
an adult occupant or your child from injury.
16L116a

COMFORT ADJUSTMENT
150

Front seat belts only
Adjust the shoulder anchor position to your size.
Manual type: To raise the anchor position, push the
anchor up. To lower the anchor position, support the
anchor
while you push the lock release button then slide
the anchor down. After adjustment, make sure the
anchor is locked in position.
CAUTION
Always make sure the shoulder belt is positioned
across the center of your shoulder. The belt should be
kept away from your neck, but not falling off your
shoulder. Failure to do so could reduce the amount of
protection in an accident and cause severe injuries in a
collision.
16L024a

COMFORT ADJUSTMENT
151


Front seat belts only
Power type: To adjust the shoulder anchor position,
press the upper or lower part of the control switch
located on the door. When the switch is released, the
shoulder anchor will stop at that position.
CAUTION
Always make sure the shoulder belt is positioned
across the center of your shoulder. The belt should be
kept away from your neck, but not falling off your
shoulder. Failure to do so could reduce the amount of
protection in an accident and cause severe injuries in a
collision.
16L117a

COMFORT ADJUSTMENT
152To release the belt, press the buckle release button
and allow the belt to retract.
If the belt does not retract smoothly, pull it out and check
for kinks or twists. Then make sure it remains untwisted
as it retracts.
Seat belt extender
If your seat belts cannot be fastened securely because
it is not long enough, a personalized seat belt extender
is available from your Lexus dealer free of charge.
Please contact your local Lexus dealer to order the
proper required length for the extender. Bring the
heaviest coat you expect to wear for proper
measurement and selection of length. Additional
ordering information is available at your Lexus dealer.
CAUTION
When using the seat belt extender, observe the
following. Failure to follow these instructions could
result in less effectiveness of the seat belt restraint
system in case of vehicle accident, increasing the
chance of personal injury.

Never use the seat belt extender if you can fasten the
seat belt without it.
 Remember that the extender provided for you may
not be safe when used on a different vehicle, or for
another person or at a different seating position than
the one originally intended for.
16L026a

COMFORT ADJUSTMENT
153
To connect the extender to the seat belt, insert the
tab into the seat belt buckle so that the ºPRESSº
signs on the buckle release buttons of the extender
and the seat belt are both facing outward as shown.
You will hear a click when the tab locks into the buckle.
When releasing the seat belt, press on the buckle
release button on the ext
ender, not on the seat belt. This
helps prevent damage to the vehicle interior and
extender itself.
When not in use, remove the extender and store in the
vehicle for future use.

COMFORT ADJUSTMENT
154
CAUTION
After inserting the tab, make sure the tab and buckle
are locked and that the belt is not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent you from properly latching the tab and
buckle.
 If the seat belt does not function normally,
immediately contact your Lexus dealer. Do not use
the seat until the seat belt is fixed. It cannot protect
an adult occupant or your child from injury.

COMFORT ADJUSTMENT
155
Front seat belt pretensioners
16L239a
The driver and front passenger's seat belt
pretensioners are designed to be activated in
response to a severe frontal impact.
When the airbag sensor detects the shock of a severe
frontal impact, the front seat belt is quickly drawn back
by the retractor so that the belt snugly restrains the front
seat occupants.
The seat belt pretensioners are activated even with no
passenger in the front seat.
Collisions occurring at certain speeds and angles may
cause the seat belt pretensioners and SRS airbags not
to operate all together.