2000 Lexus LS400 lexus LS400 2000 Engine / LEXUS 2000 LS400 OWNER'S MANUAL (OM50533U)

COMFORT ADJUSTMENT
208
16L093b

Anchor brackets
Use the anchor bracket on the filler panel behind the rear
seat to attach the top strap.
Anchor brackets are installed for each rear seat.

COMFORT ADJUSTMENT
209
16L205b
1. Fix the child restraint system with the seat belt.
2. Latch the hook onto the anchor bracket and
tighten the top strap.
For instructions to install the child restraint system, see
ªType of child restraint systemº on page 188.
CAUTION
Make sure the top strap is securely latched, and check
that the child restraint system is secure by pushing and
pulling it in different directions.

COMFORT ADJUSTMENT
210
DRIVING POSITION MEMORYSYSTEM
The micro computer can memorize the position of the
driver's seat, the height of the shoulder belt anchor of the
driver's seat belt, and the positions of the tilt and
telescopic steering, and outside rear view mirrors. Two
different driving position profiles can be entered into the
computer's memory.
Recording a driving position in the computer's memory
can only be done when the ignition key is in the ºONº
position and the selector lever is in the ªNº or ªPº position.
Setting a driving position
16L055

COMFORT ADJUSTMENT
211
1. Adjust the driver's seat, driver's shoulder belt
anchor,
tilt and telescopic steering and outside rear
view mirrors to the desired position.
2. While pushing the ºSETº button, push button º1º
or º2º until the signal beeps.
The beep sound means that the positions are recorded
in the computer's memory.
By repeating these two steps and pressing the
remaining button, the driving position for another driver
can be recorded.
To set a new memorized position, select the desired
position and perform step 2. The previous memory will
be erased and the new position will be set.
To make only slight changes to an already memorized
position, the easiest way is to first activate the
memorized position, then make the desired changes
and perform step 2 above.

COMFORT ADJUSTMENT
212
Activating a memorized position
16L056
When you push button º1º or º2º, the driving
position will be automatically adjusted to the
position recorded for that button.

COMFORT ADJUSTMENT
213
Conditions for memorized position activation

Ignition key ºONº and selector lever in ºNº or ºPº
position with the vehicle stopped.
All parts of the memorized positions can be activated.
 Key not in ignition switch and within 30 seconds of
opening driver's door.
The memorized position can be activated, except for
the tilt and telescopic steering.
If any driving position memory switch is pushed while
one of the memorized driving position profiles is being
activated, the operation will stop.
To activate the system, push the desired button (º1º or
º2º) again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory will be erased and the memorized positions will
have to be set again.

COMFORT ADJUSTMENT
214
CAUTION
Do not start the vehicle while the adjustments are
being made.
 Take care not to select the wrong button, or the seat
could strike the rear passenger or hit your body
against the steering wheel. If this happens, you can
stop the movement by pressing another driving
position memory switch.

SECTION 1 ± 7
215
INSTRUMENTS AND CONTROLS
Theft deterrent
Theft deterrent system216
. . . . . . . . . . . . . . . . . . . . . . . . .
Theft prevention labels 219
. . . . . . . . . . . . . . . . . . . . . . . .