2000 Lexus GS300 light

KEYS AND DOORS
14
11L023-3
Do not bend the key grip.
Do not cover the key grip with any material that
cuts off electromagnetic waves.
Do not knock the key hard against other
objects.
Do not leave the key exposed to high
temperatures for a long period, such as on the
dashboard and hood under the direct sunlight.
Do not put the key in water or wash it in an
ultrasonic washer.
Do not use the key with electromagnetic
materials.
ENGINE IMMOBILISER SYSTEM

KEYS AND DOORS
15
w11L016
The engine immobiliser system is a theft prevention
system. When you insert the key in the ignition
switch, the transponder chip in the key's head
transmits an electronic code to the vehicle. The
engine will start, only when the electronic code in
the chip corresponds to the registered ID code for
the vehicle.
The system is automatically set when the key is
removed from the ignition switch. At this time, the
security indicator light flashes. When you insert the key
in the ignition switch, the security indicator light goes out
and the system is canceled automatically, which
enables the engine to start.
For your Lexus dealer to make you a new key with
built±in transponder chip, your dealer will need your key
number and master key. However, there is a limit to the
number of additional keys your Lexus dealer can make
for you.If you make your own duplicate key, you will not be
able to cancel the system or start the engine.
For vehicles sold in U.S.A.
FCC ID: MOZ RI±7ATY
MADE IN JAPAN
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.

KEYS AND DOORS
17
1
Locking the doors and sounding an alarm
2
Unlocking the doors
3
Indicator light
4
Unlocking the trunk lid
NOTE: *This feature can be set inoperative as
vehicle theft deterrent measure in case of the loss of
the wireless remote control key. Ask your Lexus
dealer for details.
When you operate any button on the key, push it slowly
and surely.
The operational range of the wireless remote control is
approximately 1 meter (3 ft.). The effective range may
vary with different conditions. To activate the wireless
remote control without fail, do it approximately 1 meter
(3 ft.) from your Lexus.In the following cases, the battery in the key may be
discharged. If this is a case, replace it using a special
screwdriver.
The remote control does not work.
The operational range of wireless remote control
becomes extremely short.
The indicator light on the key is dimmed or does not
come on.
For the replacement of the battery, see ºReplacing the
batteryº on page 24. You can also have the battery of the
key replaced by your Lexus dealer.
If you lose the wireless key, contact your Lexus dealer
as soon as possible to avoid the possibility of theft, or an
accident.
You can use up to 4 wireless remote control keys for the
same vehicle. Contact your Lexus dealer for detailed
information.
The wireless remote control key is an electronic
component. Observe the following instructions in
order not to cause damage to the key.
Do not leave the wireless remote control key on
places where the temperature becomes high such as
on the dashboard.
Do not disassemble it.
Avoid knocking it hard against other objects or

KEYS AND DOORS
18dropping it.
Avoid putting it in water.
Locking/Unlocking the doors
When you push the ºLOCKº button on the key
briefly, all the doors can be locked from outside the
vehicle.
At this time, you can hear one beep.* However, when
you push the ºLOCKº button with any door not closed
securely, the buzzer sounds for 10 seconds.** To stop
the buzzer, close all the doors securely or push the
ºUNLOCKº button. If the key is in the ignition switch,
locking cannot be done.
Make sure all the doors are locked when you leave the
vehicle. Push the ºLOCKº button once again. If they
were already locked, the turn signal lights will flash.***
NOTE: *The volume of beep sound can be changed.
**The buzzer can be set not to sound with any door
not closed securely. ***The turn signal lights can be
set not to flash. Ask your Lexus dealer for details.
NOTICE
Do not push the ºLOCKº button any longer than
2 to 3 seconds. Pushing the button longer
activates an alarm. For details, see page 21.
When you push the ºUNLOCKº button, the driver's
door is unlocked. Pushing that button once again
within 3 seconds from the first push, all other doors
are also unlocked.*

KEYS AND DOORS
19
NOTE: *Unlocking by a 2±time operation can be
changed. Ask your Lexus dealer for details.At this time, two beeps sound.* Together with the
activation of unlocking, the interior light comes on for 15
seconds if the interior light switch is in ºDOORº
position.** However, this function does not work when
the ignition key is in the ºONº position. For further
information, see ºInterior lightsº on page 80.
You have 30 seconds to open a door after using the
wireless remote unlock feature.*** If a door is not
opened by then, all the doors will be automatically
locked again.
Even if the ºLOCKº or ºUNLOCKº switch is kept pressed
in, the locking or unlocking operation is not repeated.
Release the button and then push again.
NOTE: *The volume of beep sound can be changed.
**The interior light can be set not to come on or the
duration of lighting can be changed. ***The time
before automatic re±locking can be changed. Ask
your Lexus dealer for details.

KEYS AND DOORS
26
NOTICE
Make sure the positive side and negative side
of the battery should be faced correctly.
Be careful not to bend the electrode of the
battery insertion and that dust or oils do not
adhere to the inside of the module.
Take care not to lose the screws and O±ring.
5. Install the lid with the 2 screws.
NOTICE
Take care not to damage or bend the O±ring when
installing.
6. Install the module into the key frame and secure the
cover with the screw.
7. When pushing any switch on the wireless key, make
sure the indicator light comes on.
DOORS
Locking with key