2000 Lexus ES300 light

INTERIOR EQUIPMENT
90Do not use the HomeLink
 universal transmitter with
any garage door opener that lacks the safety stop and
reverse feature as required by Federal Safety
Standards. This includes any garage door opener
model manufactured before April 1, 1982.
CAUTION
When programming or operating the garage door
opener, make sure there is no one around the moving
door. It is dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door
opener. The indicator light comes on. The garage door
opener continues to send the signal for up to 20 seconds
as long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons for about 20
seconds until the indicator light flashes. All memorized
data will be erased. FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules part 15.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference that may be received,
including interference that may cause undesired
operation. WARNING: This transmitter has
been tested and complies with FCC and
DOC/MDC rules. Changes or modifications
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the device.

INTERIOR EQUIPMENT
94
NOTICE
In hot weather, inside of the vehicle becomes veryhot. Do not leave anything flammable ordeformable such as a lighter, the glasses, etc.inside.
AUXILIARY BOX
14E028±1
To use the box, pull on the handle.
CAUTION
To reduce the chance of injury in case of an accident or
a sudden stop, always keep the auxiliary box closed
while driving.

EXTERIOR EQUIPMENT
101
HOOD
15E016
1. To open the hood, pull the hood lock release lever
under the instrument panel. The hood will spring up
slightly.
15E023
2. Insert your fingers under the hood, push up the
auxiliary catch lever and lift the hood.

EXTERIOR EQUIPMENT
107
CAUTION
Do not smoke, cause sparks or allow open flames
when refuelling. The fumes are flammable.
 When opening the cap, do not remove the cap
quickly. In hot weather, fuel under pressure could
cause injury by spraying out of the filler neck if the
cap is suddenly removed.
15E007a
2. To remove the fuel tank cap, turn the cap slowly
counterclockwise, then pause slightly before
removing it. The removed cap can be stored on the
back side of the fuel filler door.
It is not unusual to hear a slight swoosh when the cap is
opened. When installing the cap, turn the cap clockwise
until you hear a click.
If the cap is not tightened securely, the malfunction
indicator lamp comes on. Make sure the cap is tightened
securely.
The indicator lamp goes off after driving several times.
If the indicator lamp does not go off, contact your Lexus
dealer as soon as possible.

COMFORT ADJUSTMENT
126
OUTSIDE REAR VIEW MIRRORS
16E197
Adjust the mirror so that you can just see the side of
your vehicle in the mirror.
Be careful when judging the size or distance of any
object seen in the outside rear view mirror on the
passenger's side. It is a convex mirror with a curved
surface. Any object seen in a convex mirror will look
smaller and farther away than if seen in a normal flat
mirror.
When the inside rear view mirror darkens in ªAUTOº
mode, the driver's side outside rear view mirror also
darken to reduce the reflection of the headlights of the
following vehicle. For details, see ªInside rear view
mirrorº on page 130. When you push the rear window and outside rear view
mirror defogger switch, the heater panels in the outside
rear view mirrors will quickly clear the mirror surface.

COMFORT ADJUSTMENT
131
Adjust the m
irror so that you can just see the rear of
your vehicle in the mirror.
Pushing the switch changes the mode between
ªAUTOº and ªDAYº.
The indicator comes on when the ªAUTOº mode is
selected.
ªDAYº mode: The mirror surface is normal.
ªAUTOº mode: If the mirror detects light from the
headlights of the vehicle behind you, the mirror
surface darkens slightly to reduce the reflected
light.
When the inside rear view mirror surface changes, the
driver's side outside rear view mirror surface will also
become darker.
When the ignition key is inserted and turned on, the
inside rear view mirror always turns on in the ªAUTOº
mode. When the outside air temperature is low, it may take a
little longer for the mirror to darken in response to the
detection of headlights.
CAUTION
Do not adjust the mirror while the vehicle is moving. It
may cause the driver to mishandle the vehicle and an
accident may occur resulting in personal injuries.

COMFORT ADJUSTMENT
136
Fastening front and rear seat belts
16E014a
Adjust the seat as needed and sit up straight and
well back in the seat. To fasten your belt, pull it out
of the retractor and insert the tab into the buckle.
You will hear a click when the tab locks into the buckle.
The seat belt length automatically adjusts to your size
and the seat position.
The retractor will lock the belt during a sudden stop or on
impact. It also may lock if you lean forward too quickly.
A slow, easy motion will allow the belt to extend, and you
can move around freely.When a passenger's shoulder belt is completely
extended and is then retracted even slightly, the belt is
locked in that position and cannot be extended. This
feature is used to hold the child restraint system
securely.
(For details, see ªChild restraintº on page 172.)
To free the belt again, fully retract the belt and then pull
the belt out once more.
If the seat belt cannot be pulled out of the retractor, firmly
pull the belt and release it. You will then be able to
smoothly pull the belt out of the retractor.

COMFORT ADJUSTMENT
144
16E179
This indicator comes on when the ignition key is
turned to the ªACCº or ªONº position. It goes off
after about 6 seconds. This means the front seat belt
pretensioners are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, seat belt pretensioner
assemblies, warning light, interconnecting wiring and
power sources. (For details, see ªService reminder
indicators and warning buzzersº on page 60 for
instructions.)