2000 Lexus ES300 automatic transmission

CHASSIS
414± BRAKES
Pedal clearance
Pedal free play
Brake pad wear limit
Parking brake lining wear limit
Parking brake adjustment
Fluid type
70 mm (2.8 in.) Min. *1
1 ± 6 mm (0.04 ± 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
3 ± 6 clicks *
2
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 k\
gf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when depressed with the pressure of 294 N (30 \
kgf, 66 lbf.)
± STEERING
Wheel free play
Power steering fluid type
Less than 30 mm (1.2 in.)
Automatic transmission fluid DEXRONII or III

CHASSIS
419
63E009
Check the fluid level through the reservoir. If
necessary, add automatic transmission fluid
DEXRON
II or III.
If the vehicle has been driven around 80 km/h (50 mph)
for 20 minutes (a little more in frigid temperatures), the
fluid is hot (60C ± 80C or 140 F ± 175F). You may
also check the level when the fluid is cold (about room
temperature, 10 C ± 30C or 50F ± 85F) if the engine
has not been run for about five hours.

CHASSIS
420
63E003±1

1If hot O.K. 2If hot add 3If cold O.K.
4If cold add
Clean all dirt off the reservoir and look at the fluid level.
If the fluid is cold, the level should be in the ªCOLDº
range. Similarly, if it is hot, the fluid level should be in the
ªHOTº range. If the level is at the low side of the
appropriate range, add automatic transmission fluid
DEXRON
II or III to bring the level within the range.
To remove the reservoir cap, turn it counterclockwise
and lift up. To reinstall it, turn it clockwise. After
replacing the reservoir cap, visually check the steering
box case, vane pump and hose connections for leaks or
damage.

GAS STATION INFORMATION

Fuel selection:
Select Octane Rating 87 (Research Octane Number
91) or higher. For improved vehicle performance, the
use of premium unleaded gasoline with an Octane
Rating 91 ( Research Octane Number 96) or higher is
recommended.

Fuel tank capacity:
70 L (18.5 gal., 15.4 lmp. gal.)

Engine oil:
API SJ, ªEnergy±Conservingº multigrade engine oil
or ILSAC multigrade engine oil.
Recommended oil viscosity ± SAE 5W±30 if normal
temperatures are below 38 C (100F)
Oil capacity: L (qt., lmp.qt.)
Drain and refill with filter 4.7 (5.0, 4.1)
without filter 4.5 (4.8, 4.0)
See page 402 for detailed information.

Engine coolant:
Capacity: 8.8 L (9.3 qt., 7.7 lmp. qt.)
Coolant type ± ªTOYOTA Long Life Coolantº or
equivalent
With ethylene±glycol type coolant for a proper
corrosion protection of aluminum components
Do not use alcohol type antifreeze or plain water alone.
For checking the engine coolant, see page 407
.

Automatic transaxle:
Fluid type ± Automatic transmission fluid Type T±IV

Tire information:
See page 423 through 432 for detailed information.

Tire pressure:
Tire size: P205/65R15 92V or P215/60R16 91V
cold tires
kPa (kgf/cm
2 or bar, psi)
Vehicle loaded
up Vehicle load up to vehicle
capacity to 4 occupants weight
Front tires 180 (1.8, 26) 220 (2.2, . . . . . . . . . . . .
32)
Rear tires 180 (1.8, 26) 220 (2.2, . . . . . . . . . . .
32)
When driving under the above vehicle load conditions at
sustained high speeds above 160 km/h (100 mph), in
countries where such speeds are permitted by law,
inflate the front and rear tires 220 kPa (2.2 kgf/cm
2 or bar,
32 psi), but never exceed the maximum cold tire
pressure molded on the tire sidewall.