ELECTRICAL COMPONENTS
458
64E016
1Type A 2Type B 3Good 4Blown
If there is an overload in the circuits from the battery, the
fuses are designed to blow before the entire wiring
harness is damaged.
CAUTION
Always use a genuine Lexus fuse or equivalent for
replacement. Never install an ordinary wire ± even for
a temporary fix. This may cause extensive damage and
possibly a fire.
NOTICE
Before replacing the fuses, have the cause ofelectrical overload determined and repaired byyour Lexus dealer.
GAS STATION INFORMATION
Fuel selection:
Select Octane Rating 87 (Research Octane Number
91) or higher. For improved vehicle performance, the
use of premium unleaded gasoline with an Octane
Rating 91 ( Research Octane Number 96) or higher is
recommended.
Fuel tank capacity:
70 L (18.5 gal., 15.4 lmp. gal.)
Engine oil:
API SJ, ªEnergy±Conservingº multigrade engine oil
or ILSAC multigrade engine oil.
Recommended oil viscosity ± SAE 5W±30 if normal
temperatures are below 38 C (100F)
Oil capacity: L (qt., lmp.qt.)
Drain and refill with filter 4.7 (5.0, 4.1)
without filter 4.5 (4.8, 4.0)
See page 402 for detailed information.
Engine coolant:
Capacity: 8.8 L (9.3 qt., 7.7 lmp. qt.)
Coolant type ± ªTOYOTA Long Life Coolantº or
equivalent
With ethylene±glycol type coolant for a proper
corrosion protection of aluminum components
Do not use alcohol type antifreeze or plain water alone.
For checking the engine coolant, see page 407
.
Automatic transaxle:
Fluid type ± Automatic transmission fluid Type T±IV
Tire information:
See page 423 through 432 for detailed information.
Tire pressure:
Tire size: P205/65R15 92V or P215/60R16 91V
cold tires
kPa (kgf/cm
2 or bar, psi)
Vehicle loaded
up Vehicle load up to vehicle
capacity to 4 occupants weight
Front tires 180 (1.8, 26) 220 (2.2, . . . . . . . . . . . .
32)
Rear tires 180 (1.8, 26) 220 (2.2, . . . . . . . . . . .
32)
When driving under the above vehicle load conditions at
sustained high speeds above 160 km/h (100 mph), in
countries where such speeds are permitted by law,
inflate the front and rear tires 220 kPa (2.2 kgf/cm
2 or bar,
32 psi), but never exceed the maximum cold tire
pressure molded on the tire sidewall.
