Page 2063 of 2189

rl,Security System Does Not Disarm With
The Valet Switch
Security System Does Not Work ln The
Valet Mode ('96-'98 HX, LX, EX)
1. ls luse 3 (in the under-dash fuse box) OK?
Yes - Go to the next steD.
No - Replace the blown fuse, then go to the
next step.
2. Does the fuse blow again?
Yes - Locate and reoair the short.
No - Retest the system.
3. ls there battery voltage at terminal 11 of the
security control unit connecto( when the ignition
switch is in the ON (ll) position?
Yes - Go to the next step.
No - Locate the open in the wiring between
luse 3 and the security control unit.
ls lhere approximately 5 volts at terminal 4 of the
keyless entry harness connector (B)?
Yes - Go to the next step.
No - Replace the radio.
rl e
133-21
5. ls there approximately 5 volts at terminal 5 of the
security control unit connector?
Yes - Go to the next step.
No - Locate the open in the BLU wire between
the security control unit and the radio.
ls the voltage at terminal 5 oJ the security control
unit connector changed from approximately 5
volts to 0 volts when the valet switch is pressed?
Yes - Replace the security control unit.
No - ReDlace the radio.
6.
Page 2064 of 2189

Security System (cont'd)
3.
Security System Does Not Disarm With
The Valet Switch
Security System Does Not Work In The
Valet Mode ('99-'00 models)
1. ls fuse 3 (in the under-dash fuse box) (HX, LX,
EX, DX-V, Si) or the fuse in the securily in-line
luse holder (CX, DX) OK?
Yes - Go to the next step.
No - Replace the blown fuse, then go to the
next step.
Does the fuse blow again?
Yes - Locate and reoair the short.
No- Retest the system.
ls there battery voltage al terminal 11 of the
security control unit connector, when the ignition
switch is in the ON (ll) position?
Yes - Go to the next steo.
No - Locate the open in the wiring between
fuse 3 (HX, LX, EX, DX-V, Si) or the luse
in the security inline fuse holder (CX,
DX) and the securiv control unit.
133-22
4. ls there approximately 5 volts at terminal 5 of the
security control unit connector?
Yes - Go to the next steo.
No - Replace the security control unit.
ls the voltage at terminal 5 of the security control
unil connector changed from approximately 5
volts to 0 volts when the valet switch is pressed?
Yes - Replace the security control unit.
No - Check that the valet switch is working
properly, then check for an open in the
wiring between the valet switch and the
security control unit.
Page 2084 of 2189
\
\
19. Left Front Corner of Engine Compartment22. Letl Rear Corner of Engine Compartment
20. Left Front of Engine Compartment23. Left Rear Corner of Engine Compartment
21. Left Rear Corner of Engine Compartment24. Lower Left Rear of Engine Compartment
POWER STEERING I
\
201 -3
Page 2091 of 2189
Cornponent Location
61. Behind Left Side of Dash Panel\
\
64. Rear of Under-dash Fuse/Relay Box
62. Behind Left Side of Dash Panel65. Underside of Steering Column
63. Rear of Under-dash Fuse/Relay Box66. Behind Left Side of Dash Panel
201 -'l 0
\
Page 2092 of 2189
\
\
\
67. Rear of Gauge Assembly70. Behind Left Side of Front Console
68. Behind Left Side of Dash Panel71. Right Side of Steering Column
69. Behind Left Side of Dash Panel72. Lett Side of Steering Column
:FFF: l:: : aalrlffiiilffi::-E--:
201 -1 1
Page 2107 of 2189
Connector Views
Cavity Numbering Systemu
WIRE SIDE
ofTERMINAL SIDE
ot
MALE TERMINALSFEMALE TERMINALS
LOCKING DEVICE
Must be at top.
In-Line Connector View Index (views begi202-2)
Connector View
cs16.................. 58
c551 . .... ............. 47
c552 ..... ............. 22
c556.................. 61
c557.................. 62
c562 ..... ............. 42
c568.................... 4
cs70.................... 5
c571 . . . . . . . . . . . . . . . . . . . . 5
c575.................. 73
C604 (Hatchback) ........ 7
C605 (Hatchback) ........ I
C607 (Hatchback) ........ 9
c639 .. ............... 23
c656 ... ............... 24
c723.................. 57
202
Page 2111 of 2189