2000 FORD CROWN VICTORIA oil dipstick

IDENTIFYING COMPONENTS IN THE ENGINE COMPARTMENT
4.6L SOHC V8 engine
1. Brake fluid reservoir
2. Engine oil dipstick
3. Engine oil filler cap
4. Windshield washer fluid reservoir
5. Air filter assembly
6. Power steering fluid reservoir
7. Engine coolant reservoir
8. Battery
9. Automatic transmission fluid dipstick
912
3
6578
4
Maintenance and care
156

ENGINE OIL
Checking the engine oil
Refer to the Scheduled Maintenance Guide for the appropriate intervals
for checking the engine oil.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait a few minutes for the oil to drain into the
oil pan.
3. Set the parking brake and ensure the gearshift is securely latched in P
(Park).
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the
engine oil level indicator (dipstick).
6. Wipe the indicator clean. Insert the indicator fully, then remove it
again.
DO NOT OVERFILL MIN
MAX
Maintenance and care
157

engine oil filler cap and use a funnel to pour the engine oil into the
opening.
3. Recheck the engine oil level. Make sure the oil level is not above the
normal operating range on the engine oil level indicator (dipstick).
4. Install the indicator and ensure it is fully seated.
5. Fully install the engine oil filler cap by turning the filler cap clockwise
until three clicks can be heard.
To avoid possible oil loss, DO NOT operate the vehicle with the
engine oil level indicator and/or the engine oil filler cap removed.
Engine oil and filter recommendations
Look for this certification
trademark.
Use SAE 5W-30 motor oil certified for gasoline engines by the American
Petroleum Institute (API).
Motor oil displaying the API certification trademark will meet all
requirements for your vehicle’s engine.
Ford oil specification is WSS-M2C153-G.
Do not use supplemental engine oil additives, oil treatments or engine
treatments. They are unnecessary and could, under certain conditions,
lead to engine damage which is not covered by your warranty.
Change your engine oil and filter according to the appropriate schedule
listed in the Scheduled Maintenance Guide.
Ford production and aftermarket (Motorcraft) oil filters are designed for
added engine protection and long life. If a replacement oil filter is used
that does not meet Ford material and design specifications, start-up
engine noises or knock may be experienced.
It is recommended you use the appropriate Motorcraft oil filter (or
another brand meeting Ford specifications) for your engine application.
Maintenance and care
159

set zone adjustment .................75
Controls
power seat ............................94,95
Coolant
checking and adding ..............161
coolant temperature light ........10
refill capacities .................164,201
specifications ...................202,204
Cruise control
(see Speed control) ....................66
Customer Assistance ................137
Ford accessories for your
vehicle .....................................214
Ford Extended
Service Plan ............................207
Getting assistance outside the
U.S. and Canada .....................213
Getting roadside assistance ...137
Getting the
service you need ....................207
Ordering additional
owner’s literature ...................217
The Dispute
Settlement Board ...................210
Utilizing the Mediation/
Arbitration Program ...............213
Daytime running lamps
(see Lamps) ................................24
Defrost
rear window ..............................25
Dipstick
automatic
transmission fluid ...................168
engine oil .................................157
Doors
lubricant specifications ..........202
Driving under special
conditions
through water .........................136
Emergencies, roadside
jump-starting ..........................148
Emission control system ..........187Engine ........................................204
check engine/
service engine soon light ...........9
cleaning ...................................197
coolant .....................................161
fail-safe coolant ......................165
idle speed control ...................171
lubrication
specifications ...................202,204
refill capacities ........................201
service points ..........................156
starting after a collision .........138
Engine block heater .................120
Engine oil ..................................157
change oil soon warning,
message center .......................157
checking and adding ..............157
dipstick ....................................157
filter, specifications .........159,201
recommendations ...................159
refill capacities ........................201
specifications ...................202,204
Exhaust fumes ..........................121
Fail safe cooling ........................165
Floor mats ...................................79
Fluid capacities .........................201
Fuel ............................................179
calculating fuel economy .......184
cap ...........................................181
capacity ...................................201
choosing the right fuel ...........182
comparisons with EPA fuel
economy estimates .................187
detergent in fuel .....................183
filling your vehicle
with fuel ....................179,181,184
filter, specifications .........184,201
fuel pump shut-off switch .....138
gauge .........................................15
improving fuel economy ........184
low fuel warning light ................8
octane rating ....................183,204
Index
220

Required fuel Unleaded fuel only - 87 octane
Fuel tank capacity 71.9L (19.0 gallons)
Engine oil capacity (includes filter
change)4.7L (5.0 quarts). Use Motorcraft
SAE 5W-30 Super Premium Motor
Oil, Ford specification
WSS-M2C153-G.
Tire pressure and size Refer to the Tire Pressure Label
located on the rear passenger door
jamb.
Hood release Pull handle under the left side of
the instrument panel.
Coolant capacity
115.0L (15.8 quarts)
Automatic transmission fluid
capacity
213.1L (13.9 quarts). Use
Motorcraft MERCONV ATF.3
Power steering fluid capacity Fill to line on reservoir. Use
Motorcraft MERCONAT F.
1Use Ford Premium Engine Coolant (green in color). DO NOT USE Ford
Extended Life Engine Coolant (orange in color). Refer toAdding engine
coolant, in the Maintenance and Care chapter.
2Ensure the correct automatic transmission fluid is used. Transmission
fluid requirements are indicated on the dipstick or on the dipstick
handle. MERCONand MERCONV are not interchangeable. DO NOT
mix MERCONand MERCONV. Refer to your Scheduled Maintenance
Guide to determine the correct service interval.
3Indicates only approximate dry-fill capacity. Some applications may
vary based on cooler size and if equipped with in-tank cooler. The
amount of transmission fluid and fluid level should be set by the
indication on the dipstick’s normal operating range. Police Package refill
capacity-12.1L (12.8 quarts).
Filling station information
224