Page 19 of 172

18n
Indicator and warning lamps
Technology that monitors itself
Many of the systems for your BMW
monitor themselves automatically, both
during engine starts and while you are
driving. Indicator and warning lamps
that are identified by "
l
" are tested for
proper functioning whenever the igni-
tion key is turned. They each light up
once for different periods of time.
If a fault should occur in one of these
systems, the corresponding lamp does
not go out after the engine is started, or
it lights up while the vehicle is moving.
You will see how to react to this below.
Red: stop immediately
Battery charge current
The battery is no longer being
charged. There is a malfunction
in the alternator V-belt or in the charg-
ing circuit of the alternator. Please con-
tact the nearest BMW center.
If the V-belt is defective, do not
continue driving. The engine could
be damaged due to overheating. If the
V-belt is defective, increased steering
effort is also required.
<
Engine oil pressure
l
Stop vehicle and switch off en-
gine immediately. Check the en-
gine oil level and top off as required. If
the oil level is correct, please contact
the nearest BMW center.
Do not continue driving. The en-
gine could be damaged because
of inadequate lubrication.
<
Tire Pressure Warning (RDW)
l
Flashing warning lamp in addi-
tion to an acoustic signal: a tire
failure has occurred. Carefully reduce
speed to less than 50 mph (80 km/h),
thus preventing any hard braking or
steering maneuvers.
For additional information, refer to
page 65.
Brake warning indicator
l
If the lamp comes on when the
parking brake is not engaged,
check the brake fluid level. Before driv-
ing further, be sure to read the notes on
pages 89 and 112.
Brake warning lamp for Cana-
dian models.
Page 21 of 172

20n
Indicator and warning lamps
Brake pads
l
Have the brake pads checked.
For additional information, refer
to page 89.
Dynamic Brake Control (DBC) l
Malfunction in the DBC system.
Conventional braking efficiency
is available and unrestricted.
For additional information, refer to
page 88.
Warning lamp, Dynamic Brake
Control (DBC) for Canadian
models.
Dynamic Stability Control
(DSC) l
Indicator lamp flashes:
The system is active and governs drive
and braking force.
If the indicator lamp does not go out
after the engine is started, or if it comes
on during normal driving and stays on:
DSC has been switched off or has been
deactivated because of a malfunction.
In the event of a malfunction, have the
system checked by your BMW center.
For additional information, refer to
page 63.
Service Engine Soon l
If the indicator lamp either re-
mains on or comes on intermit-
tently, this indicates a fault in the emis-
sions-related electronic systems.
Although the vehicle remains opera-
tional, you should have the systems
checked by your BMW center at the
earliest possible opportunity.
For additional information, refer to
page 124.
"Service Engine Soon" warning
lamp for Canadian models.
Engine electronics
Malfunction in the engine elec-
tronic control system. The elec-
tronics will permit continued driving at
reduced engine output or engine speed.
Please have the system inspected by
your BMW center.
Yellow: for your information
Rear foglamp
Lights up whenever the rear
foglamp is turned on.
For additional information, refer to
page 68.
Page 22 of 172
21n
IndexDataTechnologyRepairsCar careControlsOverview
Indicator and warning lampsGreen: for your information
Turn signal indicator
Flashes when the turn signals
are operated. Rapid flashing
indicates a system malfunction.
For additional information, refer to
page 56.
Blue: for your information
High beams
Lights up when the high beams
are on or the headlamp flasher
is actuated.
For additional information, refer to
pages 56, 68.
Page 61 of 172

60n
1 Odometer With the ignition key in position 0, you
can activate the displays shown in the
illustration by pressing the button in the
instrument cluster (arrow).2 Trip odometerTo reset the trip odometer to zero,
press the button (arrow) with the igni-
tion key in position 1.520us004
Avoid engine speeds in the gauge's red
warning zone.
If the needle gets into this range, fuel
supply is interrupted to protect the en-
gine, resulting in a noticeable loss of
power.520de029
When you switch on the ignition, the
indicator lamp lights up briefly to
confirm that the system is operational.
Once the indicator lamp comes on and
stays on, there are approx. 2.6 gallons
(10 liters) of fuel left in the fuel tank.
For fuel tank capacity, refer to
page 157.
Certain operating conditions (such
as those encountered in mountainous
areas) may cause the needle to fluctu-
ate slightly.
Please refuel early, since driving
to the last drop of fuel can result
in damage to the engine or catalytic
converter.<520us005
Odometer Tachometer Fuel gauge
Page 167 of 172

Everything from A to ZTrip odometer60
Trunk lid, refer to luggage
compartment lid35
Trunk lights
bulb replacement134
Turn signal indicator21,56
Turning radius155 U
Uniform Tire Quality
Grading99
Used batteries138 V
Vehicle
starting54
Vehicle battery136,158
Vehicle care
exterior117
interior119
Vehicle Identification
Number (VIN)113
Vehicle immobilizer29
Vehicle painting117
Vehicle storage122
Vehicle weight156
Ventilation70
draft-free73
Vinyl upholstery, care119
W
Warning lamps18
Warranty and Service Guide
Booklet (Canadian
models)114
Washer reservoir, filling108
Washing your car115
Water on roadways
deep water85
Waxing, paintwork118
Weights156
Wheel rims101
Wheelbase155
Wheels and tires101,103
Width155
Wind protector93
Windows
comfort use30
remote control32
Windshield washer nozzle
adjustment108
Windshield washer reservoir,
filling108
Windshield wipers57
blade replacement128
Winter tires101,102
Wiper blade
replacement128
Wiper system57
Work in the engine
compartment104
X
Xenon lamp129,151