2000 AUDI A8 sensor

01-29


Installation location:
On transmissions with hydraulic regulation -E17-, the Sensor for
Transmission RPM is secured to the underside of the valve body (see
illustration). For these transmissions the sensor is an inductive sensor. Fig. 11 Sensor for Transmission RPM -G182-

On transmissions with hydraulic regulation -E182-, the transmission input
speed sensor -A- is secured behind the valve body at the transmission
housing. On these transmissions the sensor is a hall effect sensor.
Information about which transmission is installed
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00

Sensor for Transmission RPM -G182-, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 38
Pa
ge 19 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-30


The Shift Lever Lock Solenoid is located in the shift lever housing -arrow-
.
Shift Lever Lock Solenoid, removing and installing
Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 37
Fig. 12 Shift Lever Lock Solenoid -N110-

Location: integrated in Throttle Valve Control Module -J338- -arrow-.
The location is described in the applicable engine repair manual under
repair Group 01, 23 or 24. Fig. 13 Throttle Position (TP) Sensor -G69-
Pa
ge 20 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2

01-32


Engines without E-Gas:
The kick-down switch is integrated in the accelerator cable in the plenum
chamber, behind bulkhead -arrow-.
Engines with E-gas:
The kick-down switch is integrated in the throttle position sensor and
Sensor 2 for Accelerator Position (-G79-, -G185-).
A learning procedure must be performed for the shift point of the kick
down switch for engines with E-gas. If the throttle position sensor (-G79-, -
G185-) is removed, exchange the engine control module or disconnect
the battery. Learning procedure can be found in Repair Manual, Fuel
Injection & Ignition, Repair Group 24; Kick down shift point, checking.
Kick-down switch, removing and installing
Repair Manual, Fuel Supply System, Repair Group 20, accelerator pedal mechanism, repairing Front and All Wheel Drive
Fig. 16 Kick-down switch -F8-
- To remove and install the kick down switch, the accelerator cable must
be removed and installed and then adjusted or the throttle position
sensor (38-G79-, -G185-) must be replaced.
Pa
ge 22 of 23 Electrical/electronic com
ponents and locations
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.2