‒ Unscrew the hexagon socket-head bolt -
arrow- and then pull the slave cylinder to
the rear out of the gearbox. → Fig.3 Detaching slave cylinder from hose/pipe assembly
Removing
‒ To remove the hose/pipe assembly, lever
out clip -A- to the stop using a screwdriver. Only then can the hose/pipe assembly be
pulled out.
Installing
‒ Press in clip -A- to stop.
‒ Push hose/pipe assembly into slave
cylinder until it engages audibly.
‒ To check, pull on the hose/pipe assembly. → Fig.4 Coat clutch slave cylinder with grease before installing
‒ Lightly lubricate contact surface for push
rod at clutch release lever with copper
grease, e.g. Z 381 351 TE.
‒ Before fitting slave cylinder into gearbox
housing, lubricate area -a- on boot with
lithium grease G 052 150 A2. → Fig.5 Installing clutch slave cylinder Notes:
◆ If the clutch slave cylinder -4- is inserted Page 5 of 65-Speed Manual Gearbox 01A 4WD4.3.2014vw-wi://rl/A.en-GB.4B-S-S01AA.wi::21141314.xml?xsl=2
