28-35
Checking voltage supply of valves for
camshaft adjustment
- Disconnect harness connector from valve.
If LED does not light up, conduct the following tests:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder - Connect LED tester VAG1527 between engine ground and terminal 1
of connector (B+).
- Crank starter for several seconds (engine can start).
LED in voltage tester must light up.
- Check fuse for valves for camshaft adjustment.
- Check wiring from terminal 1 on 2-pin connector to fuse for continuity
per wiring diagram. - Check fuel pump relay and signal to relay page 24
-95
.
Pa
ge 10 of 12 Camshaft ad
justment s
ystem, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU03.28.2
