01-296
Resistance measurement: switch multimeter to 2 M measuring range
Test
step VAG
1598/20
sockets Test of
Test conditions
- Additional steps Specified
value Corrective action
25 A) 51 + 28
3)
51 + 34
51 + 55
51 + 26 Wiring to ECM (upshift/downshift
signal)
Ignition switched
off
- ECM
disconnected infinite
1)
- Check wiring per wiring
diagram.
51 + xx
2)
less than 1.5
1) Switch VAG1526 to highest resistance ( ) measuring range. 2) Corresponding terminal assignment at Engine Control Module (ECM).
Electrical Wiring Diagrams & Component Locations A) Signal is transmitted to Transmission Control Module (TCM) via the Engine Control Module (ECM). Test is only for vehicles
without CAN-Bus
Pa
ge 38 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16
01-301
Resistance measurement
Test
step VAG
1598/20
sockets Test of
Test conditions
- Additional stepsSpecified
value Corrective action
28 A) 85 + 28
3)
85 + 34
86 + 28 3)
86 + 34 Wiring connection of TCM to
ECM (CAN-bus)
Ignition switched
off ECM
disconnected infinite
1)
- Check wiring per wiring
diagram.
85 + xx
2)
86 + xx 2)
less than 1.5
Further information on CAN-bus
page 01
-263
1) Switch VAG1526 to highest resistance ( ) measuring range. 2) Applicable terminal assignment at Engine Control Module (ECM).
Repair Manual, Fuel Injection & Ignition, Repair Group 24
Pa
ge 46 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16
01-310
Transmission with Multi-function Transmission Range (TR) switch -F125- with 8 - pin connector, checking
Resistance measurement: switch multimeter to 2 M measuring range
Test step
Connector
pins at F 125 Test of
Test conditions
- Additional stepsSpecified
value Corrective action
Continued
to
1 6 + 7 Part No. signal of
Multi-function TR
switch Ignition switched
off
- Selector lever in R,
D, 4, 3, and 2 infinitive
1)
Repair Manual, 5 Spd.
Automatic Transmission 01V, Repair Group 38
- Replace multi-function TR switch
Ignition switched
off
- Selector lever in P,
and N less than 2
The Part No. signal for the Engine
Control Module (ECM) is being
checked
1) Switch VAG1526 to highest resistance ( ) measuring range. Note:
If function check was OK, check voltage supply to Multi-function TR switch -F125- page 01
-311
Pa
ge 59 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16
