45-40
Installing
ABS wheel speed sensor rotor on AWD rear axle, examining
Note:
Repair Manual, "Suspension, Wheels, Steering", Repair Group 42
- Release ABS wheel speed sensor harness from holder (arrow).
- Pull ABS wheel speed sensor out of wheel bearing housing.
- Replace clamping sleeve page 45
-37
item - 4 -.
- Before inserting wheel speed sensor, install boot seal and grease
sensor all around with assembly paste. Then, press in wheel speed
sensor by hand until fully seated.
- Re-route sensor harness in reverse order of removal.
- Raise vehicle.
- Remove wheel.
- Pull ABS wheel speed sensor out of wheel bearing housing.
- Examine rotor for signs of dirt and damage.
If the rotor is dirty or damaged, remove the drive axle. If the rotor is
damaged, replace the outer CV joint together with the rotor. The outer CV joint is supplied as a replacement part with the rotor.
Pa
ge 20 of 20 Sus
pension mounted ABS com
ponents
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.45.4
